2017 Peugeot 208 ignition

30
Trip computer
Instrument panel display
screen
F Each press on the end of the wiper control stalk displays the information in
turn.
-
Trip 1 showing:
•
t

he average speed,
•
t

he average fuel consumption,
•

t
he distance travelled,
for the first trip.
Starting prevented
You have exceeded the authorised driving
limit: the starting prevention system does
not allow the engine to be started.
To be able to restart the engine, you must call
on a PEUGEOT dealer or a qualified workshop. Each time the ignition is switched on, these
warning lamps come on and the AdBlue
warning lamp flashes, accompanied by an
audible signal and the display of the message
"Emissions fault: Starting prevented".
During the permitted driving phase (between
685 and 0 miles (1,100 km and 0 km))
While driving, the message is displayed every
30 seconds while the fault with the SCR
emission control system persists.
The alert is repeated when switching on the
ignition.
You should go to a PEUGEOT dealer or a
qualified workshop as soon as possible.
Other wise you will not be able to restart the
vehicle. If a fault with the SCR system is confirmed
(after 30 miles (50 km) covered with the
permanent display of the message signalling
a fault), these warning lamps come on and the
AdBlue warning lamp flashes, accompanied by
an audible signal and the display of a message
(e.g. "Emissions fault: Starting prevented in
200 miles (300 km") indicating the remaining
range expressed in miles or kilometres.
Dashboard instruments

33
Date and time adjustment
Instrument panel
F Each press of this button moves between the following settings:
-


h o u r,
-


minutes,
-

1
2 or 24 hour format.
With PEUGEOT Connect
Radio
F Select the Settings menu.
F
Sel
ect "Date and time ".
F

Sel
ect "Date " or "Time ".
F

C
hoose the display formats.
F

C
hange the date and/or time using the
numeric keypad.
F

C
onfirm with " OK".
Current fuel consumption
(mpg or l/100 km or km/l)
T his function is only displayed from
20
mph (30 km/h).
Calculated over the last few seconds.
Average fuel consumption
(mpg or l/100 km or km/l)
C alculated since the last trip computer
reset.
Distance travelled
(miles or km)
Calculated since the last trip computer
reset.
Average speed
Calculated since the last trip computer
reset.
(mph or km/h)
Total time in stop mode
(minutes / seconds or hours / minutes)
If your vehicle is fitted with the Stop & Start, a
time counter adds up the time spent in STOP
mode during a journey.
It resets to zero every time the ignition is
switched on.
1
Dashboard instruments

38
F Remove the black cap located on the edge of the door, using the key.
F

I
nsert the key in the socket without forcing
it, then without turning it, move the latch
sideways towards the inside of the door.
F

R
emove the key and refit the cap.
Deadlocking
Deadlocking renders the exterior and
interior door controls inoperative.
It also deactivates the manual central
control button.
You must therefore never leave anyone
inside the vehicle when it is deadlocked.
With the key
F Turn the key to the rear in the driver's door lock.
F

T
urn the key to the rear again within
5
seconds to deadlock the vehicle.
Using the remote control
F Press.
F
P
ress this button again within
5
seconds to deadlock the
vehicle.
Deadlocking is confirmed by fixed
lighting of the direction indicators for
approximately 2


seconds.
According the version you have, the
electric door mirrors fold at the same time.
Remote control problem
Following disconnection of the vehicle battery,
replacement of the remote control battery or
in the event of a remote control malfunction,
you can no longer unlock, lock or locate your
vehicle.
F

F
irst of all, use the key in the door lock to
unlock or lock your vehicle.
F

T
hen reinitialise the remote control.
If the problem persists, contact a PEUGEOT
dealer as soon as possible.
Reset
F Switch off the ignition.
F T urn the key to position 2 (Ignition) .
F

I
mmediately press the closed
padlock button for a few
seconds.
F

S
witch off the ignition and remove the key
from the switch.
The remote control is now fully operational
again.
Access

39
Changing the battery
Battery ref.: CR1,620 / 3 volts.If the battery is flat, you are informed
by lighting of this warning lamp in
the instrument panel, an audible
signal and a message in the screen.
F

U
nclip the cover using a small screwdriver
at the cut-out.
F

R
emove the cover.
F

R
emove the discharged battery from its
housing.
F

F
it the new battery into its housing
observing the polarity.
F

C
lip the cover onto the casing.Do not throw away the remote control
batteries, they contain metals which are
harmful to the environment.
Take them to an approved collection
point. Lost keys
Go to a PEUGEOT dealer, taking with you
the vehicle's registration certificate, your
personal identification documents and if
possible, the label bearing the key code.
The PEUGEOT dealer will be able to look
up the key code and the transponder code
required to order a new key.
Closed vehicle
Driving with the doors locked could make it
difficult for the emergency services to enter
the vehicle in an emergency.
As a safety precaution, never leave children
alone in the vehicle, except for a very short
period.
In all cases, it is essential to remove the key
from the ignition switch when leaving the
vehicle.
Remote control
The high frequency remote control is a
sensitive system; do not operate it while
it is in your pocket as there is a possibility
that it may unlock the vehicle, without you
being aware of it.
Do not repeatedly press the buttons of your
remote control out of range and out of sight
of your vehicle. It may become inoperative.
It will then be necessary to reinitialise it
again.
No remote control can operate when the
key is in the ignition switch, even when
the ignition is switched off, except for
reinitialisation. Anti-theft protection
Do not make any modifications to the
electronic engine immobiliser system; this
could cause malfunctions.
Second-hand vehicle
Have the pairing of all of the keys in your
possession checked by a PEUGEOT dealer,
to ensure that only your keys can be used to
open and start the vehicle.
2
Access

42
Self-protection function
The alarm is triggered if the battery, the
central control or the siren wiring are put
out of ser vice or damaged.
For all work on the alarm system, contact a
PEUGEOT dealer or a qualified workshop.
Total protection
Switching on
F S witch off the ignition and get out of the
vehicle.
F

P
ress the locking button on the
remote control.
The exterior perimeter monitoring is activated
after 5


seconds.
Interior volumetric monitoring is activated after
45


seconds.
If an opening (door, boot, etc.) is incorrectly
closed, the vehicle is not locked but the exterior
perimeter monitoring will be activated after
45
seconds at the same time as the interior
volumetric monitoring. Deactivation
F
P
ress the unlocking button on
the remote control.
Automatic activation (depending on
version)
The system is activated automatically 2 minutes
after the last door or the boot is closed.
Protection – exterior
perimeter monitoring alone
Deactivate the interior volumetric monitoring
(and anti-tilt monitoring if your vehicle has it)
to avoid unwanted triggering of the alarm in
certain cases such as:
-

w
hen a pet is in the vehicle,
-

a w
indow is open,
-
w

ashing your vehicle. Deactivating the volumetric monitoring
The anti-tilt alarm is also deactivated, if your
vehicle has one.
F

S
witch the ignition off.
F
W
ithin ten seconds, press the
button until the indicator lamp is
on fixed.
F
G
et out of the vehicle.
F
I
mmediately press the locking
button on the remote control.
The exterior perimeter monitoring
alone is activated: the indicator lamp
flashes once per second.
To be effective, the deactivation must
be carried out each time the ignition is
switched off.
The alarm monitoring system is
activated (armed): the indicator
lamp in the button flashes once per
second. The alarm system is deactivated: the
indicator lamp in the button goes off.
To avoid triggering the alarm on
entering the vehicle, first press the
unlocking button on the remote
control before opening.
Access

43
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the key in the driver's door lock.
Triggering of the alarm
When the alarm is triggered, the siren sounds
and the direction indicators flash for thirty
seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times
consecutively.
When the vehicle is unlocked using
the remote control, rapid flashing
of the indicator lamp in the button
informs you that the alarm was
triggered during your absence.
Upon ignition, this flashing stops
immediately.
Deactivate the monitoring
functions
To stop the alarm, for example if the remote
control is not working:
F

U
nlock the vehicle using the key in the
driver's door lock.
F

o
pen the door; the alarm is triggered,
F

S
witch on the ignition; this stops the alarm.
The indicator lamp goes off.
Malfunction
When the ignition is switched on,
fixed illumination of the button’s
indicator lamp indicates a fault in the
system.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
Electric windows
Manual mode
Open
Press the control, without passing
the point of resistance. The window
stops as soon as you release the
switch.
Close
Pull the control without going past
the point of resistance. The window
stops as soon as you release the
switch.
2
Access

44
Automatic mode
(depending on version)
Open
Press the control, beyond the
resistance point: the window opens
completely when the switch is
released. Pressing the switch again
stops the movement of the window.
Close
Pull the control, beyond the
resistance point: the window closes
completely when the switch is
released. Pressing the switch again
stops the movement of the window.
The electric window controls remain
operational for approximately 1


minute
after the key has been removed.
Once this time has elapsed, the electric
windows will not operate. To reactivate
them, switch the ignition on again.
Anti-pinch
Deactivating the rear door
electric windows
For the safety of your children, press
the switch to prevent operation of
the electric windows of the rear
doors, irrespective of their position.
With the warning lamp on, the rear switches
are deactivated. With the warning lamp off, the
switches are active.
Reinitialisation
Following reconnection of the battery, the
safety anti-pinch function must be reinitialised.
The safety anti-pinch is not active during these
operations:
-

b
ring the window down completely, then
bring it back up. It will go up by a few
centimetres with each press. Repeat the
operation until the window is fully closed,
-

c
ontinue to pull the switch upwards for at
least 1
second after reaching this position,
window closed.
Always remove the key when leaving the
vehicle, even for a short time.
In the event of contact during operation
of the windows, you must reverse the
movement of the window. To do this, press
the switch concerned.
When operating the passenger electric
window switches, the driver must ensure
that no one is preventing correct closing of
the windows.
The driver must ensure that the
passengers use the electric windows
c o r r e c t l y.
Be aware of children when operating the
windows.
(depending on version)
When the window rises and meets an obstacle,
it stops and immediately partially lowers again.
In the event of unwanted opening
of the window when closing
automatically, press the switch until
the window opens completely, then
pull the switch immediately until the
window closes. Continue to hold the
control for approximately 1

second
after the window has closed.
The safety anti-pinch function is not active
during this operation.
Access

45
PEUGEOT i-Cockpit
Before going out on the road and to benefit
from the ergonomic layout of the PEUGEOT
i-Cockpit, adjust in the following order:
-
h
eight of the head restraint,
-

b
ackrest angle,
-

c
ushion height,
-
l

ongitudinal position of the seat,
-
r

each and then height of the steering wheel,
-

r
ear view mirror and door mirrors.
Sitting comfortably
Whether or not your vehicle has certain seat
adjustments described in this section depends
on the trim level and country of sale.
Driver’s side
Sit fully back in the seat with your pelvis, back
and shoulders in contact with the seat backrest.
The cushion height should be set so your eyes
are looking at the centre of the windscreen.
The head room should be at least 4 in (10 cm).Adjust the longitudinal position of the seat so
you can fully press the pedals with legs slightly
flexed.
The knee room should be at least 4 in
(10
cm) from the dashboard for access to the
dashboard controls.
Adjust the backrest angle to as vertical a
position as possible; never tilt it more than 25°.
Adjust the head restraint so that its upper edge
is level with the top of your head.
Adjust the length of the seat cushion to support
your thighs.
Adjust the lumbar support so that it conforms to
the shape of your spine.
Adjust the steering wheel so that it is at least
10 in (25 cm) from your sternum and your arms
are slightly bent.
The steering wheel should not hide the
instrument panel.
As a safety precaution, adjust the seats
only when the vehicle is stationary.
If your vehicle has electric seats, the
ignition must be on to adjust them.
Once these adjustments have been made,
check the "head up" instrument panel
can be viewed correctly over the smaller
diameter steering wheel.
3
Ease of use and comfort