2017 Peugeot 208 lock

40
Central locking
This function allows the doors and boot to be
locked or unlocked simultaneously from inside
the vehicle.
Locking
F Press this button.
This locks the doors and the boot.The indicator lamp comes on.
If one of the doors is open, the central
locking from the inside does not take
place.
Release
F Press this button again. The indicator lamp goes off. When locking / deadlocking from the
outside
When the vehicle is locked or deadlocked
from outside, the switch does not operate.
F

A
fter normal locking, pull one of the
interior door levers to unlock the
vehicle.
F
A
fter deadlocking, it is necessary to
use the remote control, or the key to
unlock the vehicle.
Automatic central locking
The doors lock automatically while driving
(speed above 6 mph [10 km/h]).
F

T
o activate or deactivate this
function (activated by default),
press this button until a buzzer
sounds and/or a message
appears in the screen.
Driving with the doors locked may render
access by the emergency services to the
interior difficult in an emergency.
Boot
Opening
Unlock the vehicle.
F

P

ress the tailgate opening button to
release it, and then guide it open.
Closing
F Lower the tailgate using the interior grab handle.
F

I
f necessary, press down on the tailgate to
fully close it.
Access

41
Boot still open
With the engine running, this is
signalled by:
-

t
his warning lamp coming on,
-

a
n alert message displayed for
a few seconds.
Vehicle moving (speed above 6
mph
(10

km/h)), this is signalled by:
-

t

his warning lamp coming on,
-

a

n alert message displayed for a few
seconds,
-
an

audible signal.
Back-up release
System for mechanically unlocking the boot in
the event of a battery or central locking fault.
Release
F Fold back the rear seats to gain access to the lock from inside the boot. F

I
nsert a small screwdriver into hole A of the
lock to unlock the tailgate.
F
M
ove the latch to the left.
Alarm
The alarm provides the following types of
monitoring:
- Perimeter monitoring
The system checks for opening of the vehicle.
The alarm is triggered if anyone tries to open a
door, the boot, the bonnet, etc.
- Volumetric monitoring
The system checks for any variation in the
volume in the passenger compartment.
The alarm is triggered if anyone breaks a
window, enters the passenger compartment or
moves inside the vehicle.
- Anti-tilt (GTi version)
The system checks for any change in the
attitude of the vehicle.
The alarm is triggered if the vehicle is lifted,
moved or knocked.
2
Access

42
Self-protection function
The alarm is triggered if the battery, the
central control or the siren wiring are put
out of ser vice or damaged.
For all work on the alarm system, contact a
PEUGEOT dealer or a qualified workshop.
Total protection
Switching on
F S witch off the ignition and get out of the
vehicle.
F

P
ress the locking button on the
remote control.
The exterior perimeter monitoring is activated
after 5


seconds.
Interior volumetric monitoring is activated after
45


seconds.
If an opening (door, boot, etc.) is incorrectly
closed, the vehicle is not locked but the exterior
perimeter monitoring will be activated after
45
seconds at the same time as the interior
volumetric monitoring. Deactivation
F
P
ress the unlocking button on
the remote control.
Automatic activation (depending on
version)
The system is activated automatically 2 minutes
after the last door or the boot is closed.
Protection – exterior
perimeter monitoring alone
Deactivate the interior volumetric monitoring
(and anti-tilt monitoring if your vehicle has it)
to avoid unwanted triggering of the alarm in
certain cases such as:
-

w
hen a pet is in the vehicle,
-

a w
indow is open,
-
w

ashing your vehicle. Deactivating the volumetric monitoring
The anti-tilt alarm is also deactivated, if your
vehicle has one.
F

S
witch the ignition off.
F
W
ithin ten seconds, press the
button until the indicator lamp is
on fixed.
F
G
et out of the vehicle.
F
I
mmediately press the locking
button on the remote control.
The exterior perimeter monitoring
alone is activated: the indicator lamp
flashes once per second.
To be effective, the deactivation must
be carried out each time the ignition is
switched off.
The alarm monitoring system is
activated (armed): the indicator
lamp in the button flashes once per
second. The alarm system is deactivated: the
indicator lamp in the button goes off.
To avoid triggering the alarm on
entering the vehicle, first press the
unlocking button on the remote
control before opening.
Access

43
Locking the vehicle without
activating the alarm
F Lock or deadlock the vehicle using the key in the driver's door lock.
Triggering of the alarm
When the alarm is triggered, the siren sounds
and the direction indicators flash for thirty
seconds.
The monitoring functions remain active until
the alarm has been triggered eleven times
consecutively.
When the vehicle is unlocked using
the remote control, rapid flashing
of the indicator lamp in the button
informs you that the alarm was
triggered during your absence.
Upon ignition, this flashing stops
immediately.
Deactivate the monitoring
functions
To stop the alarm, for example if the remote
control is not working:
F

U
nlock the vehicle using the key in the
driver's door lock.
F

o
pen the door; the alarm is triggered,
F

S
witch on the ignition; this stops the alarm.
The indicator lamp goes off.
Malfunction
When the ignition is switched on,
fixed illumination of the button’s
indicator lamp indicates a fault in the
system.
Have it checked by a PEUGEOT dealer or a
qualified workshop.
Electric windows
Manual mode
Open
Press the control, without passing
the point of resistance. The window
stops as soon as you release the
switch.
Close
Pull the control without going past
the point of resistance. The window
stops as soon as you release the
switch.
2
Access

46
Steering wheel adjustmentPassenger’s side
Sit fully back in the seat with your pelvis, back
and shoulders in contact with the seat backrest.
Adjust the longitudinal position of the seat
so that you are at a distance of at least 10 in
(25 cm) from the dashboard.
Adjust the head restraint so that its upper edge
is level with the top of your head. F

W
hen stationary
, pull the control lever
to release the steering wheel adjustment
mechanism.
F A djust the height and reach to suit your
driving position.
F

P
ush the control lever to lock the steering
wheel adjustment mechanism.
For safety reasons, these adjustments
must only be made with the vehicle
stationary.
Mirrors
Door mirrors
As a safety measure, the mirrors should
be adjusted to reduce the "blind spot".
Manual adjustments
F Operate the lever in the four directions to adjust the angle of the mirror glass.
Folding
F

F
old the mirror manually to protect it when
the vehicle is parked.
F

U
nfold it before moving off again.
They do not have automatic demisting.
Ease of use and comfort

47
Electric adjustments
F Move control A to the right or to the left to select the corresponding mirror.
F

M
ove control B in any of the four directions
to adjust.
F

R
eturn control A to its home position
(c e nt r e).
Folding / unfolding When locking the vehicle, the mirrors
fold automatically.
When unlocking the vehicle, the
mirrors unfold automatically.
F

W
ith the ignition on, pull control A
rear wards to fold the mirrors.
F

P
ull it again to unfold them. If the mirrors are folded using control A
,
they will not unfold when the vehicle is
unlocked. Pull again on control A .
Objects seen in the mirror are in reality
closer than they appear.
Take this into account when assessing
the distance of vehicles approaching from
behind.
The folding and unfolding of the door
mirrors using the remote control can be
deactivated by a PEUGEOT dealer or a
qualified workshop.
Fold the mirrors when putting your vehicle
through an automatic car wash.
If necessary, the mirrors can be folded
manually.
Rear view mirror
Equipped with an anti-dazzle system, which
darkens the mirror glass and reduces the
nuisance to the driver caused by the sun,
headlamps from other vehicles, etc.
Manual model
Adjustment
F A djust the mirror so that the mirror is
directed correctly in the "day" position.
Day / night position
F

P
ull the lever to change to the "night" anti-
dazzle position.
F

P
ush the lever to change to the normal
"day" position.
3
Ease of use and comfort

61
Rear screen demist –
defrost
The control button is located on the air
conditioning or heating system control panel.
Rear screen demisting – defrosting can only be
operated when the engine is running.
Switching on
F Press this button to demist /defrost the rear screen and,
depending on version, the
electric door mirrors. The
indicator lamp associated with
the button comes on.
Switching off
Demisting / defrosting switches off automatically
to prevent excessive electrical consumption.
F It is possible to stop the demisting/defrosting operation
before it is switched off
automatically by pressing the
button again. The indicator lamp
associated with the button goes
of f.
Courtesy lampTo demist or defrost the electric door
mirrors, with the engine running
press the heated rear window
switch.
Switch off the demisting/defrosting of
the rear screen and electric door mirrors
as soon as appropriate, as lower current
consumption results in reduced fuel
consumption.
1.Courtesy lamp
2. Map reading lamps
In this position, the light comes
on gradually:
-

w
hen you unlock the vehicle,
-

w
hen the key is removed from the ignition,
-
w

hen opening a door,
-
w

hen unlocking remotely.
3
Ease of use and comfort

62
It switches off gradually:
- w hen the vehicle is locked,
-

w
hen the ignition is switched on,
-

3
0 seconds after the last door is closed.
Permanently off.
Permanent lighting.
In "permanent lighting" mode, the lighting
time varies according to the circumstances:
-
w
hen the ignition is off, approximately
ten minutes,
-

i
n energy economy mode,
approximately 30


seconds,
-
w

ith the engine running, unlimited.
Map reading lamps
F With the ignition on, press the corresponding switch.
Take care not to put anything in contact
with the courtesy lamp.
Interior ambient lighting
Switching on
At night, panoramic sunroof light-emitting
diodes (LEDs) come on automatically when the
sidelamps are switched on.
Switching off
The interior ambient lighting switches off
automatically when the sidelamps are switched
of f. The guide-me-home lighting can be
configured in the menu Driving /
Vehicle.
Ease of use and comfort