18
WIPER AND WASHER SWITCH
Move the lever to one of the following positions to operate the windshield wipers:
1 Mist (MIST) - One sweep operation of the
front wipers.
2 Auto (AUTO) - Operates the rain-sensing
wipers (if so equipped) intermittently.
The intermittent speed can be adjusted
by rotating the time control ring
3 to
increase or decrease wiper sensitivity.
4 Low (LO) - Front wipers operate at a continuous low-speed.
5 High (HI) - Front wipers operate at a continuous high-speed.
1
2
4
5
MIST
OFF
AUTO
LO
HI3
FIRST DRIVE FEATURES
HIGH BEAM SELECT
With the he adlights ON (either in the AUTO
or
position), push the headlight control
switch forward
4 to select the high beam
function. The blue indicator light
will
illuminate in the instrument panel. Pull the
headlight switch back to the original position
to select the low beam. The blue indicator light will extinguish.
Pull and release the headlight control switch 5 to flash the headlight high
beams on and off.
FOG LIGHT SWITCH
The headlights must be on and the low beams
selected for the fog lights
to operate.
Turn the switch (inside collar) to the
position
6 to turn the fog lights on.
Turn the switch (inside collar) to the OFF position to turn the fog lights off.
LANE CHANGE SIGNAL
Move the lever up or down until the turn signal begins to flash but the lever does not latch to signal a lane change. Hold the lever until the lane change
is completed.
Move the lever up or down until the turn signal begins to flash but the lever does not latch and release the lever. The turn signal will automatically flash
three times.
Choose the appropriate method to signal a lane change based on the road and
traffic conditions.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
45
6
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
19
6
MOONROOF/REAR SUNSHADE SWITCH (if so equipped)
OPENING/CLOSING THE MOONROOF AND SUNSHADE
To fully open the moonroof and sunshade, push the switch fully past the detent toward
the
OPEN position 1.
To fully close the moonroof and sunshade, push the switch fully past the detent toward
the
CLOSE position 2.
To open just the sunshade (moonroof will remain closed), push the switch
3 to
the detent toward the
OPEN position 1.
Push the switch
3 toward the open position 1 again to open the moonroof.
To close just the moonroof (sunshade will remain open), push the switch 3 to
the detent toward the
CLOSE position 2. Push the switch 3 toward the
CLOSE position 2 again to close the moonroof.
OPENING THE SUNSHADE/TILTING THE MOONROOF
Push the switch 3 once to open the
sunshade and tilt the moonroof.
Push the switch 3 again to close the
moonroof. Push the switch
3 to the detent
toward the
CLOSE position 2 to close
the sunshade.
REAR POWER SUNSHADE
The rear sunshade switch 4 is located
in the instrument panel to the lef t of the
steering wheel.
To raise the sunshade, push the upper side of the switch.
To lower the sunshade, push the lower side of the switch.
The switch does not need to be held do wn.
Please see your Owner’s Manual for important safety information, system limitations, and additional
operating and feature information.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
4
1
2
3
6 Pull the lever toward you to activate the
front washer. The wipers will operate
several times.
Please see your Owner’s Manual for important safety
information, system limitations, and additional operating and
feature information.
For more information, refer to the “Instruments and controls (section 2)” of your Owner’s Manual.
To view detailed instructional videos regarding these and other features, please go to www.nissanownersinfo.mobi.
