2017 MAZDA MODEL MX-5 RF belt

4–16
When Driving
Start/Stop Engine
NOTE
Under the following conditions, a period of time is required to stop engine idling
 
 The battery power is depleted for some reasons such as the vehicle has not been driven
for a long period.
  The ambient temperature is high or low. 
 After the battery terminals are disconnected for some reasons such as for battery
replacement.
Engine does not restart
If the following operations are performed while the idling is stopped, the engine will not
restart for safety reasons. In such cases, start the engine using the normal method.
 
 The bonnet is opened. 
(European model) The driver's seat belt is unfastened and the driver's door is opened. 
(Except European model)




(Manual transmission)
 With the shift lever in a position other than neutral, the driver's seat belt is
unfastened and the driver's door is opened.
 


(Automatic transmission)

 With the selector lever in the D or M (not in second gear ¿ xed mode), the driver's
seat belt is unfastened and the driver's door is opened.
Engine-stop period is short or time until next engine idle stop is long
 
 The ambient temperature is high or low. 
 The battery power is depleted. 
 Power consumption by the vehicle's electrical parts is high.
/:A(.'',A'FKVKQPKPFD

4–17
When Driving
Start/Stop Engine
NOTE
Engine restarts automatically while engine idling is stopped
Under the following conditions, the engine restarts automatically.
 
 The i-stop OFF switch is pressed until the beep sounds. 
 The ambient temperature is extremely high or low. 
(Manual Air-Conditioning)



 The airÀ ow mode dial of the air conditioner is in the ( ) position and the fan
control dial is in a position other than 0.
 


 The airÀ ow amount is the maximum airÀ ow amount. 

(Fully Automatic Air-Conditioning)



 The airÀ ow mode dial of the air conditioner is in the ( ) position.



 The temperature setting dial of the air conditioner is in the maximum heating or
maximum cooling (A/C ON) position.
 


 The cabin temperature differs greatly from the set temperature of the air conditioner. 

 The brakes are released slightly on a slope and the vehicle begins to move. 
 Two minutes have elapsed since the idling was stopped. 
 The battery power is depleted. 
(Automatic transmission)




 The accelerator pedal is depressed with the selector lever in the D or M (not in
second gear ¿ xed mode) position.




 The selector lever is shifted to the R position.



 The selector lever is shifted from N or P position to D or M (not in second gear ¿ xed
mode) position.
 


 The steering wheel is operated with the selector lever in the D or M (not in second
gear¿ xed mode) position.




 The selector lever is in the M position and the second gear ¿ xed mode is selected. 

(Retractable fastback model) The retractable fastback switch is operated. 
(Except European model)




(Manual transmission)
 With the shift lever in the neutral position, the driver's seat belt is unfastened and the
driver's door is opened.
 


(Automatic transmission)

 With the selector lever in the N or P position, the driver's seat belt is unfastened and
the driver's door is opened.
/:A(.'',A'FKVKQPKPFD

4–18
When Driving
Start/Stop Engine
NOTE
Selector lever is operated while engine idling is stopped (automatic transmission)
If the selector lever is shifted from D or M (not in second gear ¿ xed mode) position to
N or P position while engine idling is stopped, the engine does not restart even when the
brake pedal is released. The engine will restart if the brake pedal is depressed again or the
selector lever is shifted to the D, M (not in second gear ¿ xed mode), or R position. (For
the purposes of safety, always keep the brake pedal depressed when shifting the selector
lever while engine idling is stopped.)
 
(European model) If the selector lever is shifted from the D or M (not in second gear ¿ xed mode) position
to the N or P position, and the driver's seat belt is unfastened and the driver's door is
opened, the engine does not restart. Start the engine using the normal method.
 (Except European model) If the selector lever is shifted from the D or M (not in second gear ¿ xed mode) to the
N or P position, and the driver's seat belt is unfastened and the driver's door is opened,
the engine restarts.
Battery terminals are disconnected
Engine idling may not stop right after the battery terminals are disconnected. In addition,
if the battery is replaced, the i-stop functions must be veri¿ ed. Consult an expert repairer,
we recommend an Authorised Mazda Repairer.
i-stop Warning Light (Amber)/i-stop Indicator Light (Green)
To ensure safe and comfortable use of the vehicle, the i-stop system constantly monitors the
driver's operations, the vehicle's interior and exterior environment, and the operational status
of the vehicle, and uses the i-stop warning light (amber) and i-stop indicator light (green) to
inform the driver of various cautions and warnings.
NOTE
On vehicles equipped with the centre display, the i-stop operation status is displayed in the
fuel monitor control status display.
Refer to Control Status Display on page 4-94 .
/:A(.'',A'FKVKQPKPFD

4–19
When Driving
Start/Stop Engine
i-stop warning light (amber)
When the light is turned on
 




 The light turns on when the ignition is switched ON and turns off when the engine is
started.
 


 The light turns on when the i-stop OFF switch is pressed and the system is turned off.



 The light turns on if the following operations are performed while engine idling is
stopped. In such cases, the engine does not restart automatically to ensure safety. Start the
engine using the normal method.
 

 
 The bonnet is opened.


 
(European model)
 The driver's seat belt is unfastened and the driver's door is opened.


 
(Except European model)



 
(Manual transmission)
 With the shift lever in a position other than neutral, the driver's seat belt is unfastened
and the driver's door is opened.
 

 
(Automatic transmission)
 With the selector lever in the D or M (not in second gear ¿ xed mode) position, the
driver's seat belt is unfastened and the driver's door is opened.
NOTE
A problem in the system may be indicated under the following conditions. Have your
vehicle inspected at an expert repairer, we recommend an Authorised Mazda Repairer.
 
 The light does not turn on when the ignition is switched ON. 
 The light continues to remain on even though the i-stop OFF switch has been pressed
while the engine is running.
When the light is À ashing
The light continues to À ash if the system has a malfunction. Have your vehicle inspected at
an expert repairer, we recommend an Authorised Mazda Repairer.
/:A(.'',A'FKVKQPKPFD

4–43
When Driving
Instrument Cluster and Display
*Some models.
Signal Warning Lights Page
(Amber) Electric Vacuum Pump Warning Light
*1 7-34
ABS Warning Light *1
Electronic Brake Force
Distribution System
Warning
7-31
ABS warning
7-34
Check Engine Light *1 7-34
(Amber)
* i-stop Warning Light *1 7-34
(Amber) * i-ELOOP Warning Indication/Warning Light *1 7-34
* Automatic Transmission Warning Indication/Warning Light *1 7-34
Air Bag/Seat Belt Pretensioner System Warning Light *1 7-34
* Active Bonnet Warning Light *1 7-34
* Tyre Pressure Monitoring System Warning Light *1
Flashing
7-34
Illuminate
7-41
* Flat Tyre Warning Light *1 7-34
(Red)
* KEY Warning Indication/Warning Light *1
Malfunction

7-34
Except malfunction

7-41
(Amber)
* KEY Warning Indication
7-34
* Lane Departure Warning System (LDWS) Warning Indication/
Warning Light *1
Illuminated

7-34
Flashing
4-111
/:A(.'',A'FKVKQPKPFD

4–44
When Driving
Instrument Cluster and Display
*Some models.
Signal Warning Lights Page
(Amber)
* High Beam Control System (HBC) Warning Indication/
Warning Light *1 7-34
* Blind Spot Monitoring (BSM) Warning Indication 7-34
* Retractable Fastback Warning Indication 7-34
LED Headlight Warning Light *1 7-34
Seat Belt Warning Light 7-41
* Door-Ajar Warning Light 7-41
* Door-Ajar Warning Indication 7-41
* Boot lid-Ajar Warning Indication 7-41
* Low Fuel Warning Indication/Warning Light 7-41
* 120 km/h Warning Light *1 7-41
* Low Washer Fluid Level Warning Indication/Warning Light 7-41
*1 The light turns on when the ignition is switched on for an operation check, and turns off a few seconds later or
when the engine is started. If the light does not turn on or remains turned on, have the vehicle inspected at an
expert repairer, we recommend an Authorised Mazda Repairer.
*2 The light turns on continuously when the parking brake is applied.
/:A(.'',A'FKVKQPKPFD

4–49
When Driving
Transmission
NOTE
  A natural driving posture can be
realized by lightly gripping the shift
lever from the side without having to
rest your elbow on the centre console
box.

  If shifting to R is dif¿ cult, shift back
into neutral, release the clutch pedal,
and try again.
 (With i-stop function) If the engine has stopped due to
stalling, it can be restarted by
depressing the clutch pedal within 3
seconds of the engine stopping.
 The engine cannot be restarted even
if the clutch pedal is depressed under
the following conditions:
 


 The driver's door is open.



 The driver's seat belt is unfastened.



 The clutch pedal is not released
completely after the engine stalled.
 


 The clutch pedal is depressed with
the engine not stopped completely.
NOTE
 (With parking sensor system) When the shift lever is shifted to the
R position with the ignition switched
ON, the parking sensor system is
activated and a beep sound is heard.
 Refer to Parking Sensor System on
page 4-148 .
Gear Shift Indicator
The gear shift indicator supports you to
obtain optimum fuel economy and smooth
driving. It displays the selected gear
position in the instrument cluster as well
as noti¿ es the driver to change to the most
suitable gear position corresponding to the
actual driving condition.
Selected gear position Suitable gear position
Indication Condition
Numeral The selected gear position is
displayed.
and numeral Shift up or down to the indicated
gear position is recommended.
/:A(.'',A'FKVKQPKPFD

6–3
Maintenance and Care
Scheduled Maintenance
S c h e d u l e d M a i n t e n a n c e
NOTE
After the prescribed period, continue to follow the described maintenance at the
recommended intervals.
Emission control and related systems
The ignition and fuel systems are highly important to the emission control system and to
ef¿ cient engine operation. Do not tamper with them.
All inspections and adjustments must be made by an expert repairer, we recommend an
Authorised Mazda Repairer.
Europe
Maintenance Interval Number of months or kilometres (miles), whichever comes ¿ rst.
Months 12 24 36 48 60 72 84 96 108
×1000 km 20 40 60 80 100 120 140 160 180
×1000 miles 12.5 25 37.5 50 62.5 75 87.5 100
112.5
Spark plugs *1 Replace every 120,000 km (75,000 miles).
Air ¿ lter
*2 R R R
Evaporative system (if installed) I I I
Drive belts
*3 I I I
Engine oil & ¿ lter Flexible
*4 Replace when indicator is ON. (Max interval: 12
months/20,000 km (12,500 miles))
Other than
À exible
*5 R R R R R R R R R
Cooling system I I I I
Engine coolant
*6 Replace at ¿ rst 200,000 km (125,000 miles) or 10 years; after
that, every 100,000 km (62,500 miles) or 5 years.
Fuel lines and hoses I I I I
Battery
*7 I I I I I I I I I
Brake lines, hoses and connections I I I I I I I I I
Brake À uid
*8 R R R R
Parking brake I I I I I I I I I
Disc brakes I I I I I I I I I
Steering operation and linkages I I I I
Manual transmission oil R
Rear differential oil
*9
Front and rear suspension, ball joints and wheel
bearing axial play I I I I
/:A(.'',A'FKVKQPKPFD