2017 MAZDA MODEL MX-5 RF height

6–15
Maintenance and Care
Owner Maintenance
3. Grasp the support rod in the padded
area and secure it in the support rod
hole indicated by the arrow to hold the
bonnet open.
Pad
Support rod
Clip
Closing the Bonnet
1. Check under the bonnet area to make
certain all ¿ ller caps are in place and all
loose items (e.g. tools, oil containers,
etc.) have been removed.
2. Lift the bonnet, grasp the padded area
on the support rod, and secure the
support rod in the clip. Verify that the
support rod is secured in the clip before
closing the bonnet.
Clip Pad
3. Lower the bonnet slowly to a height of
about 20 cm (7.9 in) above its closed
position and then let it drop.
CAUTION
When closing the bonnet, do not push
it excessively such as by applying your
weight. Otherwise, the bonnet could be
deformed.
/:A(.'',A'FKVKQPKPFD

6–36
Maintenance and Care
Owner Maintenance
*Some models.
If a tyre wears evenly, a wear indicator
will appear as a solid band across the
tread.
Replace the tyre when this happens.
New treadTread wear indicator
Worn tread
You should replace the tyre before the
band crosses the entire tread.
(With tyre pressure monitoring system)
After adjusting the tyre pressure,
initialization of the tyre pressure
monitoring system is necessary to make
the system operate normally.
Refer to Tyre Pressure Monitoring System
Initialization on page 4-143 .
Replacing a Wheel
WARNING
Always use wheels of the correct size
on your vehicle:
Using a wrong-sized wheel is
dangerous. Braking and handling
could be affected, leading to loss of
control and an accident.
CAUTION
A wrong-sized wheel may adversely
affect:
 
 Tyre ¿ t 
 Wheel and bearing life 
 Ground clearance 
 Snow-chain clearance 
 Speedometer calibration 
 Headlight aim 
 Bumper height 
 Tyre Pressure Monitoring System *
NOTE

 When replacing a wheel, make
sure the new one is the same as the
original factory wheel in diameter,
rim width, and offset (inset/outset).
  For details, contact an expert
repairer, we recommend an
Authorised Mazda Repairer.
Proper tyre balancing provides the best
riding comfort and helps reduce tread
wear. Out-of-balance tyres can cause
vibration and uneven wear, such as
cupping and À at spots.
/:A(.'',A'FKVKQPKPFD

7–64
If Trouble Arises
When the Roof Cannot be Closed
7. While one person pushes the rear roof
down, another person pulls the wire
until a latch sound is heard and the rear
roof unlocks.
Lock
Link Pin
Wire
Unlock
8. Do the same procedure on the other
side.
9. While standing on both sides of the
vehicle, lift the rear roof to the position
it stops while keeping the height of
its left and right sides as parallel as
possible.
CAUTION
  Do not let go of the rear roof on both
sides until it is fully open. The rear
roof could fall if it is released too
soon and cause injury.
  Do not attempt to forcefully lift the
rear roof. If the rear roof is forcefully
lifted without being unlocked, it
could damage vehicle parts.
  Lift the rear roof with its left and
right height as parallel as possible. If
the rear roof is lifted with the left or
right height slanted, it could deform
the link mechanism.
Closing the front roof
CAUTION
  Some steps in the procedure require
holding your body in a strained
position and if over exerted it could
result in injury.
  Do the procedure being very careful
not to get your hands and ¿ ngers
caught while closing the front roof.
Otherwise, your hands or ¿ ngers
could be injured.
  Removal of the headliner is included
in the procedure, however, never
drive the vehicle with the headliner
removed. Driving the vehicle with
the headliner removed is prohibited
by law. Correctly perform the
procedure while following the
instructions.
/:A(.'',A'FKVKQPKPFD

7–68
If Trouble Arises
When the Roof Cannot be Closed
14. Install the left and right link covers
from the vehicle interior.
Link cover
Closing the rear roof
CAUTION
  Slowly close the rear roof. If the
rear roof is closed suddenly, a hand
or other body part may be pinched,
leading to a serious injury.
  Do not attempt to forcefully push
the rear roof. Pushing the rear roof
forcefully may damage vehicle parts.
1. Fold the rope in half and hook it to the
link pin of the rear roof.
Rope
Link pin
2. Do the same procedure on the other
side.3. Close the rear roof uniformly on both
sides using two adults, one on each side
of the vehicle.
CAUTION
Close the rear roof with its left and right
positions as parallel as possible. If the
rear roof is closed with its left or right
height slanted, it could deform the link
mechanism.
4. Slowly close the rear roof while lightly
pulling the rope with one hand so that
the rope does not unhook.
Rope
NOTE
Route the rope rearward through the
clearance between the rear roof and
boot.
/:A(.'',A'FKVKQPKPFD

9–6
Speci¿ cations
Speci¿ cations
Capacities
(Approximate Quantities)
Item Capacity
Engine
oil With oil ¿ lter replacement 4.3 L (4.5 US qt, 3.8 Imp qt)
Without oil ¿ lter replacement 4.1 L (4.3 US qt, 3.6 Imp qt)
Coolant SKYACTIV-G 1.5 Left-hand drive model 5.6 L (5.9 US qt, 4.9 Imp qt)
Right-hand drive model 5.8 L (6.1 US qt, 5.1 Imp qt)
SKYACTIV-G 2.0 Manual
transmission Left-hand drive model 6.0 L (6.3 US qt, 5.3 Imp qt)
Right-hand drive model 6.2 L (6.6 US qt, 5.5 Imp qt)
Automatic
transmission Saudi Arabia 6.2 L (6.6 US qt, 5.5 Imp qt)
Right-hand drive model 6.0 L (6.3 US qt, 5.3 Imp qt)
Except above 5.9 L (6.2 US qt, 5.2 Imp qt)
Manual transmission oil 2.0 L (2.1 US qt, 1.8 Imp qt)
Automatic transmission À uid 7.2 L (7.6 US qt, 6.3 Imp qt)
Rear differential oil 0.6 L (0.6 US qt, 0.5 Imp qt)
Fuel tank 45.0 L (11.9 US gal, 9.90 Imp gal)
Check oil and À uid levels with dipsticks or reservoir gauges.
Dimensions
Item Vehicle speci¿ cation
Soft top model Retractable fastback
model
Overall length 3,915 mm (154.1 in) 3,915 mm (154.1 in)
Overall width 1,735 mm (68.3 in) 1,735 mm (68.3 in)
Overall height 16 inch wheel vehicle 1,225 mm (48.2 in) 1,230 mm (48.4 in)
17 inch wheel vehicle 1,230 mm (48.4 in) 1,235 mm (48.6 in)
Front tread 1,495 mm (58.9 in) 1,495 mm (58.9 in)
Rear tread 1,505 mm (59.3 in) 1,505 mm (59.3 in)
Wheelbase 2,310 mm (90.9 in) 2,310 mm (90.9 in)
/:A(.'',A'FKVKQPKPFD