2017 MAZDA MODEL MX-5 RF brake
[x] Cancel search: brakePage 530 of 609
7–36
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Signal Warning
Automatic
Transmission
Indication/Warning
Light
*
The indication/light illuminates when the transmission has a problem.
CAUTION
If the automatic transmission warning indication/light illuminates, the transmission has
an electrical problem. Continuing to drive your Mazda in this condition could cause
damage to your transmission. Consult an expert repairer, we recommend an Authorised
Mazda Repairer as soon as possible.
(Illuminate)
TCS/DSC Indicator
Light If the light stays on, the TCS, DSC or the brake assist system may have a malfunction and
they may not operate correctly. Take your vehicle to an expert repairer, we recommend an
Authorised Mazda Repairer.
Air Bag/Seat Belt
Pretensioner System
Warning Light A system malfunction is indicated if the warning light constantly À ashes, constantly
illuminates or does not illuminate at all when the ignition is switched ON. If any of these
occur, consult an expert repairer, we recommend an Authorised Mazda Repairer as soon as
possible. The system may not operate in an accident. WARNING
Never tamper with the air bag/pretensioner systems and always have an expert
repairer, we recommend an Authorised Mazda Repairer perform all servicing and
repairs:
Self-servicing or tampering with the systems is dangerous. An air bag/pretensioner
could accidentally activate or become disabled causing serious injury or death.
Active Bonnet
Warning Light *
The light turns on when the ignition is switched on for an operation check, and turns off a
few seconds later.
A problem in the system may be indicated under the following conditions. Have your
vehicle inspected at an expert repairer, we recommend an Authorised Mazda Repairer.
The light does not turn on when the ignition is switched ON. Remains turned on/ À ashing.
WARNING
Do not drive the vehicle with the active bonnet warning light turned on or À ashing:
Driving the vehicle with the active bonnet warning light turned on or À ashing is
dangerous as the active bonnet mechanism may not activate normally and function
as intended in the event the vehicle were to contact a pedestrian.
/ : A ( . ' ' , A ' F K V K Q P K P F D
Page 540 of 609
7–46
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Message Indicated in Multi-information Display *
I f t h e r e i s a n o t i ¿ cation from the vehicle, a message is displayed in the multi-information
display. Check the information and take the necessary action.
(Display example)
If the warning light turns on/ À ashes simultaneously or a symbol is indicated in the display,
check the information regarding the warning light or symbol. (page 4-42 )
Display Content Action to be taken
Indicated when the push button start is
pressed while the shift lever is not in
the P position. Shift the shift lever to the P position.
Indicated when a seat belt is
unfastened and the driver's door is
opened while the i-stop function is
operating. Press the push button start again
to start the engine. For automatic
transmission vehicles, shift the shift
lever to the P position before starting
the engine.)
Indicated when the push button start is
pressed without depressing the brake
pedal. Depress the brake pedal and press the
push button start.
Indicated when the push button start is
pressed without depressing the clutch
pedal. Depress the clutch pedal and press the
push button start.
Indicated while the steering wheel is
locked. Release the steering lock.
/ : A ( . ' ' , A ' F K V K Q P K P F D
Page 556 of 609
7–62
If Trouble Arises
When the Roof Cannot be Closed
Manual closing
Before closing manually
WARNING
Verify that the ignition is switched off
before manually operating the roof:
Manually closing the roof with the
ignition not switched off is dangerous
as the motors could turn on suddenly
and cause injury resulting from
hands or ¿ ngers being pinched in the
mechanism.
1. Park on a hard, level surface off the
right-of-way and ¿ rmly set the parking
brake.
2. Put a vehicle with an
automatictransmission in Park (P), a
manual transmission in Neutral.
3. Switch the ignition off while depressing
the brake pedal.
4. Turn on the hazard warning À asher if it
is needed.
Tool preparation
Take out the ¿ ve tools stored in the seat
side box.
Refer to Seat Side Box on page 5-131 .
WireGear
(tool kit)Rope
L-shaped
hexagonal wrench
(Small)L-shaped
hexagonal wrench
(Large)
Opening the rear roof
CAUTION
When turning the bolt, cover the
front roof using a cloth. The front
roof may be damaged if the L-shaped
hexagonal wrench contacts it.
Because the clearance with the stored
front roof is narrow, be careful not
to let the L-shape hexagonal wrench
contact the roof when turning the
bolt.
NOTE
Moving the seats as far forward as
possible and folding the seatbacks
forward will facilitate the procedure.
Refer to Seat Operation on page 2-5 .
1. Remove the aerial if it is installed.
Refer to When the Aerial on page
5-14 .
2. Insert the short end of the L-shaped
hexagonal wrench (Large) into the
motor bracket bolt.
Bolt
/ : A ( . ' ' , A ' F K V K Q P K P F D
Page 569 of 609
8–5
Customer Information
Recording of Vehicle Data
Recording of Vehicle Data
This vehicle is equipped with a computer which records the following main vehicle data
related to vehicle controls, operation, and other driving conditions.
Recorded data
Vehicle conditions such as engine speed and vehicle speed
Driving operation conditions such as accelerator and brake pedals, and information related
to the environmental circumstances while the vehicle is driven
Malfunction diagnosis information from each on-vehicle computer
Information related to controls of other on-vehicle computers
NOTE
The recorded data may vary depending on the vehicle grade and optional equipment.
Voice and images are not recorded.
Data handling
Mazda and its subcontracting parties may obtain and use the recorded data for vehicle
malfunction diagnosis, research and development, and quality improvement.
Mazda will not disclose or provide any of the obtained data to a third party unless:
An agreement from the vehicle owner (agreements from lessor and lessee for leased
vehicle) is obtained
Of ¿ cially requested by the police or other law enforcement authorities
For statistical processing by a research institution after processing the data so that
identi ¿ cation of the owner or the vehicle is impossible
/ : A ( . ' ' , A ' F K V K Q P K P F D
Page 583 of 609
8–19
Customer Information
Electromagnetic Compatibility
Electromagnetic Compatibility
Your Mazda has been tested and certi ¿ ed to the UNECE *1 10 regulation as related to
electromagnetic compatibility. Radio Frequency (RF) transmitter equipment (e.g. cellular
telephones, amateur radio transmitters, etc.) may only be ¿ tted to your Mazda if they
comply with the parameters shown in the table below.
*1 UNECE stands for United Nations Economic Commission for Europe.
It is your responsibility to ensure that any equipment you have ¿ tted complies with
applicable local legislations. Have any equipment ¿ tted by properly trained technicians.
CAUTION
Do not mount any transceiver, microphones, speakers, or any other item in the
deployment path of the air bag system.
Do not fasten aerial lead to original vehicle wiring, fuel pipes or brake pipes. Avoid
running the aerial lead parallel with the wire harness to the best extent possible.
Keep the aerial and power leads at least 100 mm (3.9 in) from any electronic modules
and the air bags.
Avoid using the cigar lighter or accessory socket as a power source for the RF-
transmitting equipment.
/ : A ( . ' ' , A ' F K V K Q P K P F D
Page 591 of 609
9–5
Speci ¿ cations
Speci ¿ cations
Lubricant Quality
Lubricant Classi ¿ cation
Europe Except Europe
Engine oil
*1
Recommended Oils *2 Oil Quality
Mazda Original Oil Supra 0W-20
API SG/SH/SJ/SL/SM/SN or
ILSAC GF-II/GF-III/GF-IV/GF-V Mazda Original Oil Ultra 5W-30
Alternative Oil Quality
*3
API SL/SM/SN or
ACEA A3/A5 0W-20
5W-30
Coolant FL-22 type
Manual transmission oil Mazda Original Long Life Gear Oil IS
*4
Automatic transmission À uid JWS3309
Rear differential oil Mazda Long Life Hypoid Gear Oil SG1
Brake/Clutch À uid SAE J1703 or FMVSS116 DOT-3 or DOT-4
*1 Refer to Recommended Oil on page 6-17 .
Do not use oils which do not meet the above speci ¿ cation or requirements. Use of unsuitable oil may lead to
engine damage which is not covered by the Mazda Warranty.
*2 Mazda Original Oils are specially designed/tested for the respective engine. For optimum performance we
recommend to use Mazda Original Oils at all times.
*3 If you are unable to ¿ nd a Mazda Original Oil, alternative oils meeting the listed speci ¿ cation may also be used.
*4 Mazda Original Long Life Gear Oil IS is superior oil for optimum shift-feel. Using Mazda Original Long Life
Gear Oil IS is recommended.
If Mazda Original Long Life Gear Oil IS cannot be obtained, use standard oil (API Service GL-4 (SAE 75W-
90)). However, shifting in very low temperatures may become dif ¿ cult.
/ : A ( . ' ' , A ' F K V K Q P K P F D
Page 593 of 609
9–7
Speci ¿ cations
Speci ¿ cations
*Some models.
Light Bulbs
Exterior light
Light bulb Category
Wattage UNECE *1 (SAE)
Headlights High beam LED *2 — (—)
Low beam LED *2 — (—)
Running lights LED type LED *2 — (—)
Bulb type 21 W21W (7440)
Position lights LED
*2 — (—)
Front direction indicator lights 21 WY21W
(7443NA)
Side direction indicator lights 5
*3 WY5W (—)
High-mount brake light LED *2 — (—)
Rear direction indicator lights 21 WY21W
(7443NA)
Brake lights LED
*2 — (—)
Tail lights LED *2 — (—)
Reverse lights 21 W21W (7440)
Rear fog light
* 21 W21W (7440)
Number plate lights 5 W5W (—)
*1 UNECE stands for United Nations Economic Commission for Europe.
*2 LED is the abbreviation for Light Emitting Diode.
*3 Bulb replacement is not possible because it is built into the unit. Replace the unit.
Interior light
Light bulb Category
Wattage UNECE *1
Overhead light 10 —
Boot light 5 —
*1 UNECE stands for United Nations Economic Commission for Europe.
/ : A ( . ' ' , A ' F K V K Q P K P F D
Page 595 of 609
9–9
Speci ¿ cations
Speci ¿ cations
Standard tyre
(Except Arab Gulf Cooperation Council)
Tyre size In À ation pressure
Front Rear
195/50R16 84V 200 kPa (2.0 bar, 29 psi) 200 kPa (2.0 bar, 29 psi)
195/50RF16 84V 200 kPa (2.0 bar, 29 psi) 200 kPa (2.0 bar, 29 psi)
205/45R17 84W 200 kPa (2.0 bar, 29 psi) 200 kPa (2.0 bar, 29 psi)
(Arab Gulf Cooperation Council)
Tyre size In À ation pressure
Front Rear
195/50RF16 84V 200 kPa (2.0 bar, 29 psi) 200 kPa (2.0 bar, 29 psi)
Winter tyre
Tyre size In À ation pressure
Front Rear
195/50R16
*1 M S 200 kPa (2.0 bar, 29 psi) 220 kPa (2.2 bar, 32 psi)
205/45R17
*2 M S 200 kPa (2.0 bar, 29 psi) 220 kPa (2.2 bar, 32 psi)
*1 Load index and Speed Symbol: 84Q/84S/84H/84V
*2 Load index and Speed Symbol: 84Q/84S/84H/84V/84W
Wheel nut tightening torque
When installing a tyre, tighten the wheel nut to the following torque.
108—147 N·m (12—14 kgf·m, 80—108 ft·lbf)
Fuses
Refer to Fuses on page 6-47 .
Brakes
If you require information regarding the wear limit speci ¿ cation for the brake disc plates
and the measurement method, please contact an expert repairer, we recommend an
Authorised Mazda Repairer. The information is made freely available.
/ : A ( . ' ' , A ' F K V K Q P K P F D