2017 MAZDA MODEL CX-9 change time

6–32
Maintenance and Care
Owner Maintenance
Inspect fl uid level in the washer fl uid
reservoir; add fl uid if necessary.

L


Use plain water if washer fl uid is
unavailable.
But use only washer fl uid in cold weather
to prevent it from freezing.
NOTE
Front and rear washer fl uid is supplied
from the same reservoir.

Body Lubrication
All moving points of the body, such as
door and hood hinges and locks, should
be lubricated each time the engine oil is
changed. Use a nonfreezing lubricant on
locks during cold weather.

Make sure the hood's secondary latch
keeps the hood from opening when the
primary latch is released.
CX-9_8FS7-EA-16K_Edition2.indb 32CX-9_8FS7-EA-16K_Edition2.indb 322016/12/15 18:36:042016/12/15 18:36:04

6–48
Maintenance and Care
Owner Maintenance
*Some models.
CAUTION
When removing the lens or lamp unit
using a fl athead screwdriver, make
sure that the fl athead screwdriver does
not contact the interior terminal. If
the fl athead screwdriver contacts the
terminal, a short circuit may occur.

NOTE
 


 To replace the bulb, contact an
Authorized Mazda Dealer.
 


 Use the protective cover and carton for
the replacement bulb to dispose of the
old bulb promptly and out of the reach
of children.

Replacing Exterior Light Bulbs
Headlights (type A), Headlights/Daytime
running lights (type B), Front turn
signal lights (type A), Daytime running
lights/Parking lights (type A), Front
side-marker lights (type A), Signature
wing illumination (type A)
* , Fog lights * ,
Brake lights, Taillights, High-mount
brake light, Side turn signal lights, Rear
side-marker lights
The LED bulb cannot be replaced as a
single unit because it is an integrated unit.
The LED bulb has to be replaced with the
unit. We recommend an Authorized Mazda
Dealer when the replacement is necessary.
Front turn signal lights (type B),
Parking lights/Front side-marker lights
(type B)
NOTE
When replacing a bulb for the front turn
signal lights and parking lights/front
side-marker lights, turn the steering wheel
and change the direction in which the tires
are pointed to the position where the bulb
replacement can be done easily.
Turn the steering wheel after starting the
engine and stop the engine after you fi nish
turning the steering wheel.

1. If you are changing the right bulb, start
the engine, turn the steering wheel
all the way to the right, and turn off
engine. If you are changing the left
bulb, turn the steering wheel to the left,
and turn off engine.
2. Make sure the ignition is switched off,
and the headlight switch is off.
3. Turn the screw counterclockwise and
remove it.



CX-9_8FS7-EA-16K_Edition2.indb 48CX-9_8FS7-EA-16K_Edition2.indb 482016/12/15 18:36:122016/12/15 18:36:12

7–45
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Warning Sound is
Activated
Lights-On Reminder
The lights-on reminder is operable when
the time setting *1 of the auto headlight off
function is off.
If lights are on and the ignition is switched
to ACC or off, a continuous beep sound
will be heard when the driver's door is
opened.

*1 If the light switch is left on, the auto
headlight off function automatically
turns off the lights about 30 seconds
after switching the ignition off. The
time setting can be changed.
Refer to Personalization Features on
page 9-11 .

NOTE
 


 When the ignition is switched to ACC,
the “Ignition Not Switched Off (STOP)
Warning Beep” (page 7-46 ) overrides
the lights-on reminder.
 


 A personalized function is available to
change the sound volume for the lights-
on reminder.
  Refer to Personalization Features on
page 9-11 .

Air Bag/Seat Belt Pretensioner
System Warning Beep
If there is a problem with the air bag/seat
belt pretensioner systems and the warning
light illumination, a warning beep sound
will be heard for about 5 seconds every
minute.

The air bag and seat belt pretensioner
system warning beep sound will continue
to be heard for approximately 35
minutes. Have your vehicle inspected at
an Authorized Mazda Dealer as soon as
possible.
WARNING
Do not drive the vehicle with the air
bag/seat belt pretensioner system
warning beep sounding:
Driving the vehicle with the air bag/
seat belt pretensioner system warning
beep sounding is dangerous. In a
collision, the air bags and the seat belt
pretensioner system will not deploy
and this could result in death or serious
injury. Contact an Authorized Mazda
Dealer to have the vehicle inspected as
soon as possible.

CX-9_8FS7-EA-16K_Edition2.indb 45CX-9_8FS7-EA-16K_Edition2.indb 452016/12/15 18:36:472016/12/15 18:36:47

7–48
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Blind Spot Monitoring (BSM)
Warning Beep *
Driving forward
The warning beep operates when the turn
signal lever is operated to the side where
the Blind Spot Monitoring (BSM) warning
light is illuminated.
NOTE
A personalized function is available to
change the Blind Spot Monitoring (BSM)
warning beep sound volume.
Refer to Personalization Features on page
9-11 .

Reversing
If a moving object such as a vehicle or
two-wheeled vehicle approaches on the
left or right from behind your vehicle, the
Blind Spot Monitoring (BSM) warning
sound is activated.
Mazda Radar Cruise Control
(MRCC) System Warnings *
The Mazda Radar Cruise Control (MRCC)
system warnings notify the driver of
system malfunctions and cautions on use
when required.
Check based on the beep sound.

Cautions What to check
The beep sounds 1 time
while the Mazda Radar
Cruise Control (MRCC)
is operating The vehicle speed is
slower than 25 km/h (16
mph) and the Mazda
Radar Cruise Control
(MRCC) system has
been canceled.
The beep sounds
continuously while
driving The distance between
your vehicle and the
vehicle ahead is too
close. Verify the safety
of the surrounding area
and reduce vehicle
speed.
While the Mazda Radar
Cruise Control (MRCC)
is operating, the beep
sounds and the multi-
information display
indicates a problem
with the Mazda Radar
Cruise Control (MRCC)
system. A malfunction in
the system may be
indicated. Have your
vehicle inspected at
an Authorized Mazda
Dealer.

CX-9_8FS7-EA-16K_Edition2.indb 48CX-9_8FS7-EA-16K_Edition2.indb 482016/12/15 18:36:482016/12/15 18:36:48

7–49
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Lane Departure Warning Sound *
While the system is operating, if the
system determines that the vehicle may
depart from the lane, it sounds a warning
sound.
NOTE
 


 The volume of the Lane-keep Assist
System (LAS) & Lane Departure
Warning System (LDWS) warning sound
can be changed.
  Refer to Personalization Features on
page 9-11 .
 


 The type of the Lane-keep Assist System
(LAS) & Lane Departure Warning
System (LDWS) warning sound can be
changed.
  Refer to Personalization Features on
page 9-11 .

Collision warning *
If there is a possibility of a collision
with a vehicle ahead, a warning sound is
activated at the same time as the warning
indications are displayed in the instrument
cluster or active driving display.
Power Steering Warning Buzzer
If the power steering system has
a malfunction, the power steering
malfunction light turns on or fl ashes and
the buzzer operates at the same time.
Refer to Warning Indication/Warning
Lights on page 4-32 .
Electric Parking Brake (EPB)
Warning Beep
The warning buzzer is activated under the
following conditions:
 

 The vehicle is driven with the electric
parking brake (EPB) applied.
 

 The electric parking brake (EPB) switch
is pulled while the vehicle is driven.

Power Liftgate Warning Beep *
If system operation precautions are
necessary, the driver is notifi ed by the
warning sound.

Cautions What to check
The beep sounds 3 times The conditions required
for the power liftgate
to operate have not
been met, such as an
object being stuck in the
liftgate.
The beep sound
continues The vehicle is being
driven with the liftgate
open. Stop the vehicle
and close the liftgate.

CX-9_8FS7-EA-16K_Edition2.indb 49CX-9_8FS7-EA-16K_Edition2.indb 492016/12/15 18:36:492016/12/15 18:36:49

8–45
Customer Information and Reporting Safety Defects
Declaration of Conformity
NOTE
During printing time of this user manual the approvals listed above are granted.
WARNING
Change or modifi cations not expressively approved by the party responsible for
compliance could void the use's authority to operate the equipment.

HomeLink Wireless Control System
CAUTION
HomeLink has been tested and complies with FCC and Industry Canada rules. Changes or
modifi cations not expressly approved by the party responsible for compliance could void
the user's authority to operate the device.

NOTE
FCC ID: NZLMOBHL4
CANADA:4112A-MOBHL4
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
1- This device may not cause harmful interference, and
2- This device must accept any interference received, including interference that may cause
undesired operation.

CX-9_8FS7-EA-16K_Edition2.indb 45CX-9_8FS7-EA-16K_Edition2.indb 452016/12/15 18:37:052016/12/15 18:37:05

9–13
Specifi cations
Personalization Features
Item Feature Factory
Setting Available
Settings Settings
Change
Method


Distance
Recognition
Support System
(DRSS) (page
4-97 ) The system can be changed so that Distance
Recognition Support System (DRSS) does not
operate.
*1 On On/Off A —

The distance at which the vehicle ahead and your
vehicle indicated in the display fl ashes in white
can be changed. Near Far/Medium/
Near A —


Parking sensor
system (page
4-166 ) Display/non-display On On/Off A —


Vehicle
Door locks
(page 3-17 ) Operation condition of auto lock/unlock function Lock:
When
Driving
Unlock:
IGN Off Lock: When
Driving
Unlock: In
Park/
Lock: Out of
Park Unlock: In
Park/
Lock: Shifting
Out of Park/
Lock: When
Driving
Unlock: IGN
Off/
Lock: When
Driving/
Off A D


Keyless entry
system (page
3-3 ) Method for unlocking door using transmitter Driver's:
Once, All
Doors:
Twice All Doors:
Once/
Driver's: Once,
All Doors:
Twice A E


Time for locking door automatically 60
seconds 90 seconds/
60 seconds/
30 seconds A —


Advanced
keyless entry
system (page
3-9 ) Method for unlocking door using request switch/
transmitter Driver's:
Once, All
Doors:
Twice All Doors:
Once/
Driver's: Once,
All Doors:
Twice A E,
F

Time for locking door automatically 60
seconds 90 seconds/
60 seconds/
30 seconds A —


Auto-lock function operation/non-operational
Off On/Off A —


Beep volume when locking/unlocking
Medium High/
Medium/
Low/
Off A E,
F

CX-9_8FS7-EA-16K_Edition2.indb 13CX-9_8FS7-EA-16K_Edition2.indb 132016/12/15 18:37:152016/12/15 18:37:15

9–14
Specifi cations
Personalization Features
Item Feature Factory
Setting Available
Settings Settings
Change
Method


Illuminated
entry system
(page 5-85 ) Time until interior lights turn off after closing
door 15
seconds 60 seconds/
30 seconds/
15 seconds/
7.5 seconds A —


Time until interior lights turn off automatically
when any door is not closed completely 30
minutes 60 minutes/
30 minutes/
10 minutes A —


Auto-wiper
control (page
4-55 ) Operational/non-operational
On On/Off
*3 A —

Daytime
running lights
(page 4-53 ) Operational/non-operational
On On/Off — —


Auto headlight
off
*4 (page
4-48 ) Time until headlights turn off 30
seconds 120 seconds/
90 seconds/
60 seconds/
30 seconds/
Off
*5 A —


Auto-light
control (page
4-48 ) Timing by which lights turn on
Medium Light/
Medium Light/
Medium/
Medium Dark/
Dark A —


High Beam
Control System
(HBC) (page
4-88 ) Operational/non-operational
*1
On On/Off A —

Adaptive Front
Lighting System
(AFS) (page
4-87 ) Operational/non-operational
*1
On On/Off A —

Lights-on
reminder
*6 (page
7-45 ) Warning beep volume
Off High/Low/Off A —

Coming home
light (page
4-52 ) Time until headlights turn off 30
seconds 120 seconds/
90 seconds/
60 seconds/
30 seconds/
Off A —


Leaving home
light (page
4-53 ) Operational/non-operational
On On/Off A —


Turn indicator
(page 4-54 ) Beep volume
High High/Low A —


CX-9_8FS7-EA-16K_Edition2.indb 14CX-9_8FS7-EA-16K_Edition2.indb 142016/12/15 18:37:162016/12/15 18:37:16