2017 MAZDA MODEL CX-5 lumbar support

2–6
Essential Safety Equipment
Seats
*Some models.
Seat Recline
(Manual Seat)
To change the seatback angle, lean forward slightly while raising the lev\
er. Then lean back
to the desired position and release the lever.
Make sure the lever returns to its original position and the seatback is\
locked in place by
attempting to push it forward and backward.
(Power Seat)
To change the seatback angle, press the front or rear side of the reclini\
ng switch. Release the
switch at the desired position.

Lumbar Support Adjustment (Driver's Seat) *
(Manual Seat)
To increase the seat fi rmness, move the lever downward. Move the lever upward to decrease
fi rmness.
(Power Seat)
To increase the seat fi rmness, press and hold the front part of the switch to the desired
position, then release it.
Press the rear part of the switch to decrease fi rmness.
CX-5_8FN1-EA-16L_Edition1.indb 62016/12/12 10:05:15

2–8
Essential Safety Equipment
Seats
*Some models.
CAUTION
Do not use organic solvents to clean
the seat. It may damage the seat
surface and the heater.

NOTE
  If the ignition is switched off while the
seat warmer is operating (High, Mid or
Low) and then switched ON again, the
seat warmer will automatically operate
at the temperature set before switching
off the ignition.
  Use the seat warmer when the engine
is running. Leaving the seat warmer
on for long periods with the engine not
running could cause the battery power
to be depleted.
  The temperature of the seat warmer
cannot be adjusted beyond High, Mid
and Low because the seat warmer is
controlled by a thermostat.

Driving Position Memory *
The desired driving position can be called
up after programming the position.
The following driving positions can be
programmed.
  Driver’s seat position (seat slide, height
adjustment, front edge of seat bottom,
seat recline)
 Refer to Seat Operation on page 2-5 .   Active driving display (display position,
brightness level, display information)
 Refer to Active Driving Display on page 4-28 .

CAUTION
Do not place fi ngers or hands around
the bottom of the seat while the seat
memory function is operating. The
seat moves automatically while the
seat memory function is operating and
fi ngers or hands could get pinched and
injured.


SET button
1
2

The driving position can be programmed
or operated using the buttons on the side
of the seat or the key.
NOTE
   Lumbar support adjustment cannot be
programmed.
  Individual seat positions can be
programmed to the two available
programming buttons on the side of the
driver's seat, plus one seat position for
each registered key.
  If the vehicle has been serviced and
the battery cables disconnected, the
programmed seat positions will have
been erased. Re-program the seat
positions.

CX-5_8FN1-EA-16L_Edition1.indb 82016/12/12 10:05:15