2017 MAZDA MODEL CX-5 change wheel

4–175
When Driving
Tire Pressure Monitoring System
When changing tires yourself
If you or someone else changes tires, you
or someone else can also undertake the
steps for the TPMS to complete the ID
signal code registration.

1. After tires have been changed, switch the ignition ON, then back to ACC or
OFF.
2. Wait for about 15 minutes.
3. After about 15 minutes, drive the vehicle at a speed of at least 25 km/h
(16 mph) for 10 minutes and the tire
pressure sensor ID signal code will be
registered automatically.

NOTE
If the vehicle is driven within about 15
minutes of changing tires, the tire pressure
monitoring system warning light will fl ash
because the sensor ID signal code would
not have been registered. If this happens,
park the vehicle for about 15 minutes,
after which the sensor ID signal code will
register upon driving the vehicle for
10 minutes.

Replacing tires and wheels
CAUTION
 When replacing/repairing the tires or wheels or both, have the work done by
an Authorized Mazda Dealer, or the tire
pressure sensors may be damaged.
 The wheels equipped on your Mazda are specially designed for installation
of the tire pressure sensors. Do not use
non-genuine wheels, otherwise it may
not be possible to install the tire pressure
sensors.

Be sure to have the tire pressure sensors
installed whenever tires or wheels are
replaced.
When having a tire or wheel or both
replaced, the following types of tire
pressure sensor installations are possible.
   The tire pressure sensor is removed from
the old wheel and installed to the new
one.
   The same tire pressure sensor is used
with the same wheel. Only the tire is
replaced.
   A new tire pressure sensor is installed to
a new wheel.

NOTE
   The tire pressure sensor ID signal
code must be registered when a new
tire pressure sensor is purchased. For
purchase of a tire pressure sensor and
registration of the tire pressure sensor
ID signal code, consult an Authorized
Mazda Dealer.
  When reinstalling a previously removed
tire pressure sensor to a wheel, replace
the grommet (seal between valve body/
sensor and wheel) for the tire pressure
sensor.

CX-5_8FN1-EA-16L_Edition1.indb 1752016/12/12 10:06:20

6–5
Maintenance and Care
Scheduled Maintenance
Schedule 1
U.S.A. and Puerto Rico residents - Engine oil fl exible maintenance interval
Use when the maintenance monitor for “Oil Change” is set to “Flexible”. For details,
see maintenance monitor. (page 6-16 )
Maintenance Interval Number of months or kilometers (miles), whichever comes
fi rst.
Months 12 24 36 48 60 72 84 96
×1000 km 12 24 36 48 60 72 84 96
×1000 miles 7.5 15 22.5 30 37.5 45 52.5 60
Spark plugs Replace every 120,000 km (75,000 miles).
Air fi lter Replace when any equivalent timing of replacing engine oil.
(Max interval: 36 months or 60,000 km (37,500 miles))
Drive belts I I
Engine oil & fi lter
*1 Replace when wrench indicator light is ON. (Max interval:
12 months or 12,000 km (7,500 miles))
Engine coolant
*2 Replace at
fi rst 192,000 km (120,000 miles) or 10 years;
after that, every 96,000 km (60,000 miles) or 5 years.
Fuel lines and hoses
*3 I I I I
Hoses and tubes for emission
*3 I I
Brake lines, hoses and connections I I I I
Disc brakes I I I I I I I I
Tire (Rotation) Rotate when any equivalent timing of replacing engine oil.
(Max interval: 12,000 km (7,500 miles))
Steering operation and linkages I I I I
Front and rear suspension, ball joints and wheel
bearing axial play I
I I I
Rear differential oil
*4
Transfer oil *4
Driveshaft dust boots I I I I
Bolts and nuts on chassis and body T T T T
Exhaust system and heat shields I
Emergency fl at tire repair kit (if installed)
*5 Inspect annually.
Cabin air fi lter Replace when any equivalent timing of replacing engine oil.
(Max interval: 24 months or 48,000 km (30,000 miles))
Chart symbols:
I: Inspect: Inspect and clean, repair, adjust, fi ll up, or replace if necessary.
C: Clean
T: Tighten
CX-5_8FN1-EA-16L_Edition1.indb 52016/12/12 10:07:05

6–6
Maintenance and Care
Scheduled Maintenance
Remarks:
*1 The engine oil and fi lter must be changed at least once a year or within 12,000 km (7,500 mi\
les) since last
engine oil and fi lter change. Reset the engine oil data whenever replacing the engine oil\
regardless of the
message/wrench indicator light display.
*2 Use of FL-22 is recommended when replacing engine coolant. Using engine \
coolant other than FL-22 may cause serious damage to the engine and cooling system.
*3 According to state/provincial and federal regulations, failure to perfor\
m maintenance on these items will not void your emissions warranties. However, Mazda recommends that all maintenance services be performed at the
recommended time or mileage/kilometer period to ensure long-term reliabi\
lity.
*4 If this component has been submerged in water, the oil should be replaced.
*5 Check the tire repair fl uid expiration date every year when performing the periodic maintenance.\
Replace the
tire repair fl uid bottle with new one before the expiration date.


Schedule 2
U.S.A. and Puerto Rico residents - Severe driving conditions maintenance interval
Maintenance Interval Number of months or kilometers (miles), whichever comes
fi rst.
Months 6 12 18 24 30 36 42 48 54 60 66 72
×1000 km 8 16 24 32 40 48 56 64 72 80 88 96
×1000 miles 5 10 15 20 25 30 35 40 45 50 55 60
Spark plugs Replace every 120,000 km (75,000 miles).
Air fi lter
*1 Replace when any equivalent timing of replacing engine oil.
(Max interval: 36 months or 60,000 km (37,500 miles))
Drive belts I I
Engine oil & fi lter Flexible
*2
Replace when wrench indicator light is ON. (Max interval: 12
months or 12,000 km (7,500 miles))
Fixed R R R R R R R R R R R R
Engine coolant
*3 Replace at
fi rst 192,000 km (120,000 miles) or 10 years;
after that, every 96,000 km (60,000 miles) or 5 years.
Engine coolant level I I I I I I I I I I I I
Fuel lines and hoses
*4 I I I
Hoses and tubes for emission
*4 I
Function of all lights I I I I I I I I I I I I
Brake lines, hoses and connections I I I
Brake and clutch fl uid level I I I I I I I I I I I I
Disc brakes I I I I I I
Tire (Rotation) Rotate when any equivalent timing of replacing engine oil.
(Max interval: 8,000 km (5,000 miles))
Tire in fl ation pressure and tire wear I I I I I I I I I I I I
Steering operation and linkages I I I
Front and rear suspension, ball joints and wheel
bearing axial play I
I I
Rear differential oil
*5
CX-5_8FN1-EA-16L_Edition1.indb 62016/12/12 10:07:05

7–42
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Power Liftgate Warning Beep *
If system operation precautions are
necessary, the driver is notifi ed by the
warning sound.

Cautions What to check
The beep sounds 3 times The conditions required
for the power liftgate
to operate have not
been met, such as an
object being stuck in the
liftgate.
The beep sound
continues The vehicle is being
driven with the liftgate
open. Stop the vehicle
and close the liftgate.

Electric Parking Brake (EPB)
Warning Beep
The warning buzzer is activated under the
following conditions:
   The vehicle is driven with the electric
parking brake (EPB) applied.
   The electric parking brake (EPB) switch
is pulled while the vehicle is driven.

AUTOHOLD Warning Beep
Warning light fl ashes/message is
displayed and beep sound is activated
simultaneously for about fi ve seconds
when using AUTOHOLD function or
when AUTOHOLD switch is operated.
Because a problem with AUTOHOLD
function has occurred, AUTOHOLD
function does not operate even if
AUTOHOLD switch is operated.

If the warning light fl ashes/message is
displayed and the beep sound is activated
simultaneously, have your vehicle
inspected at an Authorized Mazda Dealer.
Power Steering Warning Buzzer
If the power steering system has
a malfunction, the power steering
malfunction light turns on or fl ashes and
the buzzer operates at the same time.
Refer to Warning Indication/Warning
Lights on page 4-33 .
Tire Infl ation Pressure Warning
Beep *
The warning beep sound will be heard
for about 3 seconds if the tire pressures
decrease.
If the tire pressure decreases extremely,
a beep sound will be heard for
approximately 30 seconds.
Refer to Tire Pressure Monitoring System
on page 4-172 .
Blind Spot Monitoring (BSM) Warning Beep *
Driving forward
The warning beep operates when the turn
signal lever is operated to the side where
the Blind Spot Monitoring (BSM) warning
light is illuminated.
NOTE
A personalized function is available to
change the Blind Spot Monitoring (BSM)
warning beep sound volume.
Refer to Personalization Features on page
9-11 .

Reversing
If a moving object such as a vehicle or
two-wheeled vehicle approaches on the
left or right from behind your vehicle, the
Blind Spot Monitoring (BSM) warning
sound is activated.
CX-5_8FN1-EA-16L_Edition1.indb 422016/12/12 10:07:29

9–12
Specifi cations
Personalization Features
Item Feature Factory
Setting Available
Settings Settings
Change
Method


Lane-keep Assist
System (LAS) &
Lane Departure
Warning System
(LDWS) (page
4-135 ) The system can be changed so that the
steering wheel assist does not operate.
On On/Off A —


When the steering wheel
operation assistance is
turned on The cancel
sensitivity of
the steering
assistance for the
Lane-keep Assist
System (LAS) &
Lane Departure
Warning System
(LDWS) can be
changed.
High High/Low A —


The system can
be changed so
that the Lane
Departure
Warning does not
activate. On On/Off A —


When the steering wheel
operation assistance is
turned off The warning
timing in which
the Lane-keep
Assist System
(LAS) & Lane
Departure
Warning System
(LDWS) system
determines that
the vehicle may
be deviating
from its lane can
be changed.
At At/Before A —


The sensitivity
of the warning
for the Lane-
keep Assist
System (LAS) &
Lane Departure
Warning System
(LDWS) can be
changed. Often Often/Rare A —


The type of Lane-keep Assist System (LAS)
& Lane Departure Warning System (LDWS)
warning can be changed. Vibration
Vibration/Beep/
Rumble A —


The warning intensity/
volume of the Lane-keep
Assist System (LAS) &
Lane Departure Warning
System (LDWS) system
can be changed. Vibration
Low High/Low A —


Rumble Low High/Mid/Low A —


Beep Low High/Low A —


CX-5_8FN1-EA-16L_Edition1.indb 122016/12/12 10:07:39