2017 MAZDA MODEL CX-5 lock

7–13
If Trouble Arises
Flat Tire
8. Place the luggage board on the damaged tire.


Luggage board
9. Remove the tire blocks and store the tools and jack.
10. Check the infl ation pressure. Refer to
Tires on page 9-9 .
11. Have the fl at tire repaired or replaced
as soon as possible.

WARNING
Do not drive with any tires that have
incorrect air pressure: Driving on tires with incorrect air
pressure is dangerous. Tires with
incorrect pressure could aff ect
handling and result in an accident.
When you check the regular tires' air
pressure, check the spare tire, too.

NOTE
To prevent the jack and tool from rattling,
store them properly.

CX-5_8FN1-EA-16L_Edition1.indb 132016/12/12 10:07:21

7–24
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Signal Warning


Electronic Brake Force Distribution System Warning If the electronic brake force distribution control unit determines that \
some components
are operating incorrectly, the control unit may illuminate the brake system warning
light and the ABS warning light simultaneously. The problem is likely to be the
electronic brake force distribution system. WARNING
Do not drive with both the ABS warning light and brake warning light illuminated.
Have the vehicle towed to an Authorized Mazda Dealer to have the brakes
inspected as soon as possible:
Driving when the brake system warning light and ABS warning light are
illuminated simultaneously is dangerous.
When both lights are illuminated, the rear wheels could lock more quickly in an
emergency stop than under normal circumstances.


Charging System
Warning Indication/ Warning Light If the warning light illuminates while driving, it indicates a malfuncti\
on of the
alternator or of the charging system.
Drive to the side of the road and park off the right-of-way. Consult an Authorized
Mazda Dealer.
CAUTION
Do not continue driving when the charging system warning light is illuminated
because the engine could stop unexpectedly.


Engine Oil Warning Light This warning light indicates low engine oil pressure.
CAUTION
Do not run the engine if the oil pressure is low. Otherwise, it could result in extensive
engine damage.
If the light illuminates or the warning indication is displayed while dr\
iving:
1. Drive to the side of the road and park off the right-of-way on level ground.
2. Turn off the engine and wait 5 minutes for the oil to drain back into the oil p\
an.
3. Inspect the engine oil level 6-25 . If it's low, add the appropriate amount of engine oil while being careful not to over fi ll.
CAUTION
Do not run the engine if the oil level is low. Otherwise, it could result in extensive
engine damage.
4. Start the engine and check the warning light.

If the light remains illuminated even though the oil level is normal or \
after adding oil,
stop the engine immediately and have your vehicle towed to an Authorized Mazda
Dealer.
CX-5_8FN1-EA-16L_Edition1.indb 242016/12/12 10:07:24

7–35
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Message Indicated in Multi-information Display *
If there is a notifi cation from the vehicle, a message is displayed in the multi-information\

display. Check the information and take the necessary action.


(Display example)

If the warning light turns on/ fl ashes simultaneously or a symbol is indicated in the display,
check the information regarding the warning light or symbol. (page 4-32 )

Display Content Action to be taken

Indicated when the push button start is
pressed while the shift lever is not in the
P position.
Shift the shift lever to the P position.

Indicated when the push button start is
pressed without depressing the brake
pedal.
Depress the brake pedal and press the
push button start.

Indicated while the steering wheel is
locked.
Release the steering lock.

Indicates when the Electric Parking
Brake (EPB) switch is operated without
depressing the brake pedal.
Operate the Electric Parking Brake
(EPB) switch while depressing the brake
pedal.
CX-5_8FN1-EA-16L_Edition1.indb 352016/12/12 10:07:27

7–40
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
Seat Belt Warning Beep
Except Mexico
If the driver's seat belt is not fastened
when the ignition is switched ON, a beep
sound will be heard for about 6 seconds. If
the driver or the front passenger's seat belt
is not fastened and the vehicle is driven at
a speed faster than about 20 km/h
(12 mph), a beep sound will be heard
again for a specifi ed period of time.
Until a seat belt is fastened or a given
period of time has elapsed, the beep sound
will not stop even if the vehicle speed falls
below 20 km/h (12 mph).
NOTE
   To allow the front passenger occupant
classifi cation sensor to function
properly, do not place and sit on an
additional seat cushion on the front
passenger's seat. The sensor may not
function properly because the additional
seat cushion could cause sensor
interference.
   If a small child is seated on the front
passenger's seat, the warning beep may
not operate.

Mexico
If the vehicle speed exceeds about
20 km/h (12 mph) with the driver or front
passenger's seat belt unfastened, a warning
beep sounds continuously. If the seat belt
remains unfastened, the beep sound stops
once and then continues for about
90 seconds. The beep stops after the driver
or front passenger's seat belt is fastened.
Until a seat belt is fastened or a given
period of time has elapsed, the beep sound
will not stop even if the vehicle speed falls
below 20 km/h (12 mph).
NOTE
  Placing heavy items on the front
passenger's seat may cause the front
passenger's seat belt warning function
to operate depending on the weight of
the item.
  To allow the front passenger seat weight
sensor to function properly, do not place
and sit on an additional seat cushion on
the front passenger's seat. The sensor
may not function properly because the
additional seat cushion could cause
sensor interference.
  If a small child is seated on the front
passenger's seat, the warning beep may
not operate.

Ignition Not Switched Off (STOP) Warning Beep
If the driver's door is opened with the
ignition switched to ACC, a beep will
be heard continuously in the cabin to
notify the driver that the ignition has not
been switched OFF (STOP). Under this
condition, the keyless entry system will
not operate, the vehicle cannot be locked,
and the battery voltage will be depleted.
CX-5_8FN1-EA-16L_Edition1.indb 402016/12/12 10:07:29

7–41
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Key Removed from Vehicle Warning Beep
Vehicles with advanced keyless function
If the key is taken out of the vehicle while
the ignition is not switched OFF and
all the doors are closed, the beep which
sounds outside of the vehicle will be heard
6 times, the beep which sounds inside
the vehicle will be heard 6 times, and the
KEY warning light (red) in the instrument
cluster fl ashes continuously to notify
the driver that the ignition has not been
switched OFF.
Vehicles without advanced keyless
function
If the key is taken out of the vehicle while
the ignition is not switched OFF and all
the doors are closed, a beep will be heard
in the cabin 6 times and the KEY warning
light (red) in the instrument cluster turns
on continuously to notify the driver that
the ignition has not been switched OFF.
NOTE
Because the key utilizes low-intensity
radio waves, the Key Removed From
Vehicle Warning may activate if the key is
carried together with a metal object or it
is placed in a poor signal reception area.

Request Switch Inoperable Warning Beep (With the advanced
keyless function)
If the request switch is pressed with the
door open or ajar, or the ignition is not
switched OFF with a key being carried, a
beep will be heard outside for about
2 seconds to notify the driver that the door
or liftgate cannot be locked.
Key Left-in-luggage Compartment Warning Beep (With the advanced
keyless function)
If the key is left in the luggage
compartment with all the doors locked and
the liftgate closed, a beep will be heard
outside for about 10 seconds to notify
the driver that the key is in the luggage
compartment. In this case, take out the
key by pressing the electric liftgate opener
and opening the liftgate. The key taken
out of the luggage compartment may
not operate because its functions have
been temporarily stopped. To restore the
key's functions, perform the applicable
procedure (page 3-9 ).
Key Left-in-vehicle Warning Beep (With the advanced keyless
function)
If all the doors and luggage compartment
are locked using another key while the key
is left in the cabin, the beep which sounds
outside of the vehicle will be heard for
about 10 seconds to notify the driver that
the key is in the cabin. In this case, take
out the key by opening the door. A key
taken out of the vehicle using this method
may not operate because its functions have
been temporarily stopped. To restore the
key's functions, perform the applicable
procedure (page 3-9 ).
Electronic Steering Lock Warning Beep *
The warning beep operates if the steering
wheel is not unlocked after the push button
start is pressed. (page 4-4 )
CX-5_8FN1-EA-16L_Edition1.indb 412016/12/12 10:07:29

7–43
If Trouble Arises
Warning/Indicator Lights and Warning Sounds
*Some models.
Lane Departure Warning Sound *
While the system is operating, if the
system determines that the vehicle may
depart from the lane, it sounds a warning
sound.
NOTE
  The volume of the Lane-keep Assist
System (LAS) & Lane Departure
Warning System (LDWS) warning sound
can be changed.
 Refer to Personalization Features on page 9-11 .
  The type of the Lane-keep Assist System
(LAS) & Lane Departure Warning
System (LDWS) warning sound can be
changed.
 Refer to Personalization Features on page 9-11 .

Collision warning *
If there is a possibility of a collision with
a vehicle ahead or an obstruction at the
rear of the vehicle, the warning light in the
instrument cluster fl ashes at the same time
as the warning indication is displayed in
the multi-information display or the active
driving display, and a warning sound is
activated intermittently.
Mazda Radar Cruise Control with Stop & Go function (MRCC with
Stop & Go function) System
Warnings
*
The Mazda Radar Cruise Control with
Stop & Go function (MRCC with Stop &
Go function) system warnings notify the
driver of system problems and precautions
on use when required. Check after hearing
a warning beep sound.

Warning beep What to check
While the Mazda Radar
Cruise Control with
Stop & Go function
(MRCC with Stop &
Go function) system is
operating, a single beep
sound is heard when
“Front radar blocked” is
displayed in the multi-
information display. Cancel the Mazda Radar
Cruise Control with
Stop & Go function
(MRCC with Stop &
Go function) system if
the radar sensor (front)
becomes dirty. Clean the
area around the radar
sensor (front).
The beep sounds
intermittently while the
vehicle is being driven. The distance between
your vehicle and the
vehicle ahead is too
close. Verify the safety
of the surrounding area
and reduce vehicle
speed.
While the Mazda Radar
Cruise Control with
Stop & Go function
(MRCC with Stop &
Go function) system is
operating, a single beep
sound is heard when
“Front radar sensor
system malfunction” is
displayed in the multi-
information display. A malfunction in the
system may be indicated.
Check the center display
to verify the problem
and then have your
vehicle inspected by
an Authorized Mazda
Dealer.

CX-5_8FN1-EA-16L_Edition1.indb 432016/12/12 10:07:29

7–44
If Trouble Arises
When Liftgate Cannot be Opened
When Liftgate Cannot be
Opened
If the battery is dead, the liftgate cannot be
unlocked and opened.
In this case, the liftgate can be unlocked
by taking care of the dead battery
situation.
Refer to Jump-Starting on page 7-14 .
If the liftgate cannot be unlocked even
if the dead battery situation has been
resolved, the electrical system may have a
malfunction.
In this case, the liftgate can be opened
using the following procedure as an
emergency measure.

1. Remove the cover on the interior surface of the liftgate with a fl athead
screwdriver.


Cover
2. (Without power liftgate)
Turn the lever to the right to unlock the
liftgate.


Lever

(With power liftgate)
Push the liftgate while pressing the lever down.


Lever

After performing this emergency
measure, have the vehicle inspected at
an Authorized Mazda Dealer as soon as
possible.
CX-5_8FN1-EA-16L_Edition1.indb 442016/12/12 10:07:30

9–11
Specifi cations
Personalization Features
Personalization Features
The following personalization features can be set or changed by the customer or an
Authorized Mazda Dealer. Consult an Authorized Mazda Dealer for details.
Additionally, some of the personalization features can be changed by the customer
depending on the feature.
Personalization features and settings which can be changed differ depending on the market
and specifi cation.
Settings Change Method

Settings can be changed by operating the center display screen.
A: Refer to Settings on page 5-124 .
B: Refer to Fuel Economy Monitor on page 4-86 .
C: Refer to Active Driving Display on page 4-28 .

Settings can be changed by operating the vehicle switches.
D: Refer to Auto Lock/Unlock Function on page 3-17 .
E: Refer to Transmitter on page 3-5 .
F: Refer to Locking, Unlocking with Request Switch (With the advanced keyless function) on page 3-14 .

Settings can be changed by an Authorized Mazda Dealer.
Item Feature Factory
Setting Available
Settings Settings
Change
Method


Safety
Smart City Brake
Support (SCBS)
(page 4-148 )
Smart Brake
Support (SBS)
(page 4-153 ) The system can be changed so that Smart
City Brake Support (SCBS)/Smart Brake
Support (SBS) does not operate.
*1
On On/Off A —

The distance at which the collision warning
activates can be changed. Mid Near/Mid/Far A —


The volume of the collision warning can be
changed. High High/Low/Off A —


CX-5_8FN1-EA-16L_Edition1.indb 112016/12/12 10:07:39