2017 MAZDA MODEL CX-5 engine

2–4
Essential Safety Equipment
Seats
NOTE
  When returning a rear seat to its original position, place the seat belt in its normal
position. Verify that the seat belt pulls out and retracts.
  (Power Seat)  The seat-bottom power adjustment is operated by motors. Avoid extended operation
because excessive use can damage the motors.
  To prevent the battery from running down, avoid using the power adjustment when the
engine is stopped. The adjuster uses a large amount of electrical power.
  Do not use the switch to make more than one adjustment at a time.

CX-5_8FN1-EA-16L_Edition1.indb 42016/12/12 10:05:15

2–8
Essential Safety Equipment
Seats
*Some models.
CAUTION
Do not use organic solvents to clean
the seat. It may damage the seat
surface and the heater.

NOTE
  If the ignition is switched off while the
seat warmer is operating (High, Mid or
Low) and then switched ON again, the
seat warmer will automatically operate
at the temperature set before switching
off the ignition.
  Use the seat warmer when the engine
is running. Leaving the seat warmer
on for long periods with the engine not
running could cause the battery power
to be depleted.
  The temperature of the seat warmer
cannot be adjusted beyond High, Mid
and Low because the seat warmer is
controlled by a thermostat.

Driving Position Memory *
The desired driving position can be called
up after programming the position.
The following driving positions can be
programmed.
  Driver’s seat position (seat slide, height
adjustment, front edge of seat bottom,
seat recline)
 Refer to Seat Operation on page 2-5 .   Active driving display (display position,
brightness level, display information)
 Refer to Active Driving Display on page 4-28 .

CAUTION
Do not place fi ngers or hands around
the bottom of the seat while the seat
memory function is operating. The
seat moves automatically while the
seat memory function is operating and
fi ngers or hands could get pinched and
injured.


SET button
1
2

The driving position can be programmed
or operated using the buttons on the side
of the seat or the key.
NOTE
   Lumbar support adjustment cannot be
programmed.
  Individual seat positions can be
programmed to the two available
programming buttons on the side of the
driver's seat, plus one seat position for
each registered key.
  If the vehicle has been serviced and
the battery cables disconnected, the
programmed seat positions will have
been erased. Re-program the seat
positions.

CX-5_8FN1-EA-16L_Edition1.indb 82016/12/12 10:05:15

2–9
Essential Safety Equipment
Seats
Programming
1. Make sure the parking brake is on.
2. (Automatic transaxle)
Make sure the selector lever is in the P position.
3. Start the engine.
4. Adjust the seat and the active driving display to the desired driving position.
5. Press the SET button on the seat until a beep sound is heard one time.
6. Perform one of the following settings within 5 seconds of completing step 5
above:
 Programming using a button on
the side of the seat
 Press the button you want to program,
either button 1 or 2, until a beep
sound is heard one time.
 Programming using the key  Press the key button until a beep
sound is heard one time.

NOTE
If a beep sound is heard three times, the
operation is canceled.

To move the driving position to a
programmed position
(Using a button on the side of the seat)
1. Make sure the parking brake is on.
2. (Automatic transaxle)
Make sure the selector lever is in the P position.
3. Start the engine.
4. Press the programming button for the driving position you want to call up
(button 1 or 2).
5. A beep sound is heard when the driving position adjustment is completed.

NOTE
  If the driving position movement is not
changed, only the beep sounds.
  A seat position can be called up even
with the engine not running.
  The driving position adjustment is
canceled in the following cases:
  Any of the seat adjustment switches
is operated.
  The SET button is pressed.  Programming button 1 or 2 is
pressed.
  The key button or button is
operated.
   The vehicle starts moving.  The active driving display is
adjusted.


(Using a programmed key)
1. Unlock the doors by pressing a request
switch or the key
button.
2. After unlocking the doors, the seat position adjustment begins within
40 seconds of opening the driver's door,
and a beep sounds when the operation
is fi nished.
3. Make sure the parking brake is on.
4. (Automatic transaxle)
Make sure the selector lever is in the P position.
5. Start the engine.
6. The active driving display adjustment begins.

CX-5_8FN1-EA-16L_Edition1.indb 92016/12/12 10:05:16

2–16
Essential Safety Equipment
Seats
WARNING
Be careful when using the seat warmer: The heat from the seat warmer may be
too hot for some people, as indicated
as follows, and could cause a low-
temperature burn.
 Infants, small children, elderly people, and physically challenged
people
 People with delicate skin People who are excessively fatigued People who are intoxicated People who have taken sleep-inducing medicine such as sleeping
pills or cold medicine

Do not use the seat warmer with
anything having high moisture-
retention ability such as a blanket or
cushion on the seat: The seat may be heated excessively
and cause a low-temperature burn.

Do not use the seat warmer even when
taking a short nap in the vehicle: The seat may be heated excessively
and cause a low-temperature burn.

Do not place heavy objects with sharp
projections on the seat, or insert
needles or pins into it: This could cause the seat to become
excessively heated and result in injury
from a minor burn.

CAUTION
 Before folding a rear seatback, make sure that the rear seat warmer switch is
off . If a rear seatback is folded while the
rear seat warmer is in operation, it may
heat the seat excessively and damage
the seat surface.
 Do not use organic solvents to clean the seat. It may damage the seat surface
and the heater.

NOTE
   Use the seat warmer when the engine
is running. Leaving the seat warmer
on for long periods with the engine not
running could cause the battery power
to be depleted.
  When the engine is stopped while
the seat warmers are operating and
then the ignition is switched ON, the
seat warmers will not turn back on
automatically. In addition, the seat
warmer operation stops automatically
after the seat warmers have operated
for about 90 minutes.
 To turn the seat warmer back on, press the switch.
  The temperature of the seat warmer
cannot be adjusted beyond High, Mid
and Low because the seat warmer is
controlled by a thermostat.

CX-5_8FN1-EA-16L_Edition1.indb 162016/12/12 10:05:17

3–1*Some models.
3Before Driving
Use of various features, including keys, doors, mirrors and windows.

Keys ...................................................... 3-2 Keys ............................................... 3-2
Keyless Entry System .................... 3-3

Advanced Keyless Entry System ..... 3-10 Advanced Keyless Entry
System
* ......................................... 3-10
Operational Range ....................... 3-11

Doors and Locks ................................ 3-12 Door Locks ................................... 3-12
Liftgate ......................................... 3-22

Fuel and Emission ............................. 3-30 Fuel and Engine Exhaust
Precautions ................................... 3-30
Fuel-Filler Lid and Cap ................ 3-33

Steering Wheel................................... 3-35 Steering Wheel ............................. 3-35

Mirrors ............................................... 3-36 Mirrors ......................................... 3-36

Windows ............................................. 3-39 Power Windows ........................... 3-39
Moonroof
* ................................... 3-42

Security System ................................. 3-45 Modifi cation and Add-On
Equipment .................................... 3-45
Immobilizer System ..................... 3-45
Theft-Deterrent System
* ............... 3-47
Driving Tips ....................................... 3-49 Break-In Period ............................ 3-49
Saving Fuel and Protection of the
Environment ................................. 3-49
Hazardous Driving ....................... 3-50
Floor Mat ..................................... 3-51
Rocking the Vehicle ..................... 3-51
Winter Driving ............................. 3-52
Driving In Flooded Area .............. 3-53
Overloading .................................. 3-54
Driving on Uneven Road ............. 3-55

Towing ................................................ 3-56 Trailer Towing
(U.S.A. and Canada) .................... 3-56
Recreational Towing .................... 3-64
CX-5_8FN1-EA-16L_Edition1.indb 12016/12/12 10:05:28

3–3
Before Driving
Keys
A code number is stamped on the plate
attached to the key set; detach this plate
and store it in a safe place (not in the
vehicle) for use if you need to make a
replacement key (auxiliary key).
Also write down the code number and
keep it in a separate safe and convenient
place, but not in the vehicle.

If your key (auxiliary key) is lost, consult
your Authorized Mazda Dealer and have
your code number ready.
NOTE
The driver must carry the key to ensure the
system functions properly.


Auxiliary key
Transmitter
Key code number plate

To use the auxiliary key, pull out the
auxiliary key from the transmitter while
pressing the knob.

Knob

Keyless Entry System
This system uses the key buttons to
remotely lock and unlock the doors and
the liftgate, and opens/closes the liftgate.
The system can start the engine without
having to take the key out of your purse or
pocket.
It can also help you signal for attention or
help.
Operating the theft-deterrent system is
also possible on theft-deterrent system-
equipped vehicles.

System malfunctions or warnings are
indicated by the following warning lights
or beeps.
For vehicles with the type A instrument
cluster, check the displayed message for
more information and, if necessary, have
the vehicle inspected at an Authorized
Mazda Dealer, according to the indication.
  KEY Warning Light (Red) Refer to Warning/Indicator Lights on
page 4-32 .
  Ignition Not Switched Off (STOP)
Warning Beep
 Refer to Ignition Not Switched Off (STOP) Warning Beep on page 7-40 .
  Key Removed from Vehicle Warning
Beep
 Refer to Key Removed from Vehicle Warning Beep on page 7-41 .

If you have a problem with the key,
consult an Authorized Mazda Dealer.

If your key is lost or stolen, consult an
Authorized Mazda Dealer as soon as
possible for a replacement and to make the
lost or stolen key inoperative.
CX-5_8FN1-EA-16L_Edition1.indb 32016/12/12 10:05:28

3–8
Before Driving
Keys
Panic button
If you witness from a distance someone
attempting to break into or damage your
vehicle, press and hold the panic button
to activate the vehicle's alarm. Call
emergency services if necessary.

NOTE
The panic button will work whether any
door or the liftgate is open or closed.

(Turning on the alarm)
Pressing the panic button for 1 second or
more will trigger the alarm for about
2 minutes and 30 seconds, and the
following will occur:
  The horn sounds intermittently.  The hazard warning lights fl ash.
(Turning off the alarm)
The alarm stops by pressing any button on
the key.
Operational Range
The system operates only when the driver
is in the vehicle or within operational
range while the key is being carried.
Starting the Engine
NOTE
   Starting the engine may be possible
even if the key is outside of the vehicle
and extremely close to a door and
window, however, always start the
engine from the driver's seat.
 If the vehicle is started and the key is not in the vehicle, the vehicle will
not restart after it is shut off and the
ignition is switched to off.
  The luggage compartment is out of the
assured operational range, however,
if the key (transmitter) is operable the
engine will start.

With the advanced keyless function


Interior antenna Operational range

Without the advanced keyless function


Interior antenna Operational range

CX-5_8FN1-EA-16L_Edition1.indb 82016/12/12 10:05:29

3–9
Before Driving
Keys
NOTE
The engine may not start if the key is
placed in the following areas:
  Around the dashboard  In the storage compartments such as
the glove compartment or the center
console

Key Suspend Function
If a key is left in the vehicle, the
functions of the key left in the vehicle are
temporarily suspended to prevent theft of
the vehicle.
To restore the functions, press the unlock
button on the functions-suspended key in
the vehicle.
CX-5_8FN1-EA-16L_Edition1.indb 92016/12/12 10:05:29