2017 MAZDA MODEL CX-5 warning light

(SKYACTIV-D 2.2)
SKYACTIV-D 2.2 uses specified oil. Please confirm the specification in owner's manual. If
engine oil other than the specified oil is used, the Diesel Particulate Filter
effective period of
use will be shortened or the Diesel Particulate Filter may be damaged.
NOTE
(SKYACTIV-G 2.0 and SKYACTIV-G 2.5)
•It is normal for all engines to consume engine oil under normal driving conditions.
Engine oil consumption may be as high as 0.8 L/1,000 km (1 L/800 miles). This may be as
a result of evaporation, internal ventilation or burning of the lubricating oil in the
working engine. Oil consumption may be high er when the engine is new due to the
running-in process. Oil consumption is also dependant on engine speed and engine load.
Under extreme driving conditions, oil consumption may be higher.
(SKYACTIV-D 2.2)
•Whenever the engine oil is replaced, the vehicles engine control unit needs to be reset as
soon as possible. Otherwise the wrench indi cator light or engine oil warning light may
turn on. To reset the engine control unit, consult an expert repairer, we recommend an
Authorised Mazda Repairer or refer to the vehicle engine control unit reset procedure on
page 6-27.
•Inspect the engine oil level periodically. When inspecting the engine oil, if the engine oil
level is exceeds the “X” mark on the dipstick, replace the engine oil. This should be done
by an expert repairer, we recommend an Authorised Mazda Repairer. When replacing the
engine oil, inspect the oil level using the oil dipstick and refill so that the engine oil level
is within the range between MIN and MAX as shown in the figure.

X Mark
MAX
MIN
▼ Vehicle Engine Control Unit Reset Procedure
NOTE
This procedure is intended for vehicles
with SKYACTIV-D 2.2 and vehicles with
SKYACTIV-G 2.0 or SKYACTIV-G 2.5 which the engine oil flexible maintenance setting is
selected.
After replacing the engine oil, have a repair shop such as an A uthorised Mazda Repairer
perform the initialization (engine oil data resetting) of the r ecorded value. If the value
recorded by the computer is not initialized, the wrench indicat or light may not turn off or it
may turn on earlie r than normal.
Maintenance and Care
Owner Maintenance
6-27
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

NOTE
The initialization (engine oil data resetting) of the recorded value can be performed using
the following procedure:
1. Switch the ignition OFF.
2. Switch the ignition ON with the instrument panel illumination knob pressed, and press and hold the instrument panel illumination knob for about 5 seconds until the master
warning light
flashes.

Instrument panel illumination knob
3. After the master warning light flashes for several seconds, the initialization is
completed.
▼ Inspecting Engine Oil Level
1. Be sure the vehicle is on a level
surface.
2. Warm up the engine to normal operating temperature.
3. Turn it off and wait at least 5 minutes for the oil to return to the sump.
4. Pull out the dipstick, wipe it clean, and
reinsert it fully.
SKYACTIV-G 2.0 and
SKYACTIV-G 2.5

MAX
OK
MIN
Maintenance and Care
Owner Maintenance
6-28
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

DESCRIPTIONFUSE
RATING PROTECTED COMPONENT
35 ST.HEATER 15 A Heated steering wheel
*
36FOG 15 A
Fog lights*
377.5 A Engine control system
38 H/L LOW L 15 A Headlight low beam (LH)
39 ENGINE4 15 A Engine control system
*
40― ― ―
41 METER1 10 A Instrument cluster
42 SRS1 7.5 A Air bag
43 BOSE 25 A
Bose
® Sound System-equipped model*
44 AUDIO1 15 A Audio system
45 ABS/DSC S 30 A ABS, Dynami c stability control system
46 FUEL PUMP 15 A Fuel system
*
47 FUEL WARM 25 AFuel warmer*
48TAIL 15 A Tail lights, Number plate lights
49 SCR2
FUEL PUMP2 25 A
Fuel system
*
50 HAZARD 25 A Hazard warning flashers, Direc
tion indicator lights, Tail lights,
Position lights
51 H/L LOW R 15 A Headlight low beam (RH)
52 OUTLET 25 A Accessory sockets
53 STOP 10 A Brake lights
54 ROOM 15 A Overhead light
Maintenance and Care
Owner Maintenance
6-58*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

7If Trouble Arises
Helpful information on what to do if a problem arises with the vehicle.
Mazda ERA-GLONASS
(Russia)............................................... 7-2 Mazda ERA-GLONASS.............. 7-2
Indicator Light/Beep Sound....... 7-10
Test Mode................................... 7-11
Parking in an Emergency............... 7-14 Parking in an Emergency............7-14
Roadside Emergency Triangle
Retaining Strap
*......................... 7-14
Flat Tyre........................................... 7-15 Spare Tyre and Tool Storage...... 7-15
Emergency Flat Tyre Repair Kit
*......
.................................................... 7-19
Changing a Flat Tyre (With Spare
Tyre)........................................... 7-26
Battery Runs Out............................ 7-32 Jump-Starting............................. 7-32
Emergency Starting.........................7-35 Starting a Flooded Engine
(SKYACTIV-G 2.0 and SKYACTIV-
G 2.5).......................................... 7-35
Push-Starting.............................. 7-35
Running Out of Fuel (SKYACTIV-D
2.2).............................................. 7-36
Overheating......................................7-37
Overheating................................ 7-37
Emergency Towing.......................... 7-39 Towing Description.................... 7-39
Towing Hooks......... ................... 7-41
Warning/Indicator Lights and
Warning Sounds.............................. 7-43 If a Warning Light Turns On or
Flashes........................................ 7-43
Message Indicated in Multi-
information Display.................... 7-59
Message Indicated on
Display........................................7-61
Warning Sound is Activated....... 7-63
When Liftgate Cannot be
Opened..............................................7-70 When Liftgate Cannot be
Opened........................................7-70
Active Driving Display Does Not
Operate............................................. 7-71 If the Active Driving Display Does
Not Operate................................ 7-71
*Some models.7-1
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

After that, perform the following procedure.
Move the signal lever up to right
turn
Move the signal lever up to right
turn Move the signal lever down
to left turn
Move the signal lever down
to left turn
Return the signal lever to off
Return the signal lever to off
Return the signal lever to off
Return the signal lever to off
Return the signal lever to off
Move the signal lever up to right
turn Within five seconds
Within one second Within one second Within one second
Within one second
Within one second
Within one second
Within one second
Within one second Within five seconds
Within five second
Within one second
Turn on the hazard warning
lights.
Turn off the hazard warning
lights.
Both red and green Mazda
ERA-GLONASS switch
indicator lights turn on.
Press the Mazda
ERA-GLONASS switch for
one second or longer and
release it.
If Trouble Arises
Mazda ERA-GLONASS (Russia)
7-12
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Parking in an Emergency
The hazard warning lights should always
be used when you stop on or near a
roadway in an emergency.

The hazard warning lights warn other
drivers that your vehicle is a traffic hazard
and that they must take extreme caution
when near it.

Depress the hazard warning flasher and all
the direction indicators will flash. The
hazard warning indicator lights in the
instrument cluster flash simultaneously.
NOTE
•The direction indicators do not work
when the hazard warning lights are on.
•Check local regulations about the use of
hazard warning lights while the vehicle
is being towed to verify that it is not in
violation of the law.
Roadside Emergency
Triangle Retaining Strap
*
Keep the roadside emergency triangle in
the left side trim and secure it with the
strap.
Strap
If Trouble Arises
Parking in an Emergency
7-14*Some models.
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

WARNING
Never operate the compressor above
300 kPa (3.1 kgf/ c m
2, 3 bar, 43.5 psi):
Operating the compressor above 300
kPa (3.1 kgf/cm
2, 3 bar, 43.5 psi) is
dangerous. When the inflation pressure
rises above 300 kPa (3.1 kgf/cm
2, 3 bar,
43.5 psi), heated air will be exhausted
from the back of the compressor and
you could be burned.
NOTE
•Check the tyre inflation pressure
label (driver's door frame) for the
correct tyre inflation pressure.
•Do not use the compressor for
longer than 10 minutes because
using the compressor for long
periods could damage it.
•If the tyre does not inflate, repair of
the tyre may not be possible. If the
tyre does not reach the correct
inflation pressure within a 10-minute
period, it probably has received
more extensive damage. When this
happens, the emergency flat tyre
repair kit cannot be used to repair
the tyre. Contact an expert repairer,
we recommend an Authorised Mazda
Repairer.
•If the tyre has been over-inflated,
loosen the screw cap on the
compressor and bleed some of the
air out.
16. When the tyre has been inflated to the proper inflation pressure, turn the
compressor switch off and remove the
compressor hose from the tyre valve.
17. Install the tyre valve cap.
18. Put the emergency flat tyre repair kit in the boot and continue driving.
CAUTION
Drive carefully to an expert repairer,
we recommend an Authorised
Mazda Repairer and keep the vehicle
speed below 80 km/h (50 mph).
 If the vehicle is driven 80 km/h (50
mph) or higher, the vehicle might
begin to vibrate.
NOTE
(With Tyre Pressure Monitoring
System)
If the tyre is not properly inflated, the
tyre pressure monitoring system
warning light will illuminate (page
4-42).
19. After driving the vehicle for 10 minutes or 5 km (3 miles), check the
tyre pressure with the tyre pressure
gauge equipped with the compressor. If
the tyre pressure ha s fallen below the
correct tyre pressure, inflate the tyre to
the correct pressure again following
the steps from number 14.
CAUTION
 If the tyre inflation pressure falls
below 130 kPa (1.3 kgf/cm
2 or bar,
18.9 psi), repair cannot be done with
the repair kit. Park the vehicle on a
level surface off the right-of-way and
contact an expert repairer, we
recommend an Authorised Mazda
Repairer.
If Trouble Arises
Flat Tyre
7-24
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2

Overheating
If the temperature gauge indicates
overheating or the high engine coolant
temperature warning light turns on, the
vehicle loses power, or you hear a loud
knocking or pinging noise, the engine is
probably too hot.
WA R N I N G
Pull over to a safe location, then switch
the ignition off and make sure the fan is
not running before attempting to work
near the cooling fan:
Working near the cooling fan when it is
running is dangerous. The fan could
continue running indefinitely even if the
engine has stopped and the engine
compartment temperature is high. You
could be hit by the fan and seriously
injured.
Do not remove either cooling
system cap when the engine and radiator
are hot:
When the engine and radiator are hot,
scalding coolant and steam may shoot out
under pressure and cause serious injury.
Open the bonnet ONLY after steam is no
longer escaping from the engine:
Steam from an overheated engine is
dangerous. The escaping steam could
seriously burn you.
If the temperature gauge indicates
overheating or the high engine coolant
temperature warning light turns on:

1. Drive safely to the side of the road and park off the right-of-way.
2. Put a vehicle with an automatic transaxle in park (P), a manual
transaxle in neutral.
3. Apply the parking brake.
4. Turn off the air conditioner.
5. Check whether coolant or steam is escaping from the engine
compartment.

If steam is coming from the engine
compartment:
Do not go near the front of the vehicle.
Stop the engine.
Wait until the steam dissipates, then
open the bonnet and start the engine.

If neither coolant nor steam is
escaping:
Open the bonnet and idle the engine
until it cools.
CAUTION
If the cooling fan does not operate
while the engine is running, the engine
temperature will increase. Stop the
engine and call an expert repairer, we
recommend an Authorised Mazda
Repairer.
6. Make sure the cooling fan is operating, then turn off the engine after the
temperature has decreased.
If Trouble Arises
Overheating
7-37
2017-6-7 7:51:19 Form No. CX-5 8FY4-EE-17E+L_Edition2