2017 MAZDA MODEL 2 weight

3–59
Before Driving
Towing
Germany and Austria/Gradient up to 8%
MODEL TOTAL TRAILER
WEIGHT GROSS
COMBINATION
WEIGHT
Engine
*1 Transaxle Emission
level i-stop
system i-ELOOP
system Trailer
without
brake Trailer with
brake Trailer with brake
SKYACTIV-G
1.5 LP Manual
transaxle EURO6 × — 515 kg
(1,135.3 lb) 1,100 kg
(2,425.0 lb) 2,600 kg (5,731.9 lb)
SKYACTIV-G
1.5 MP Manual
transaxle EURO6 × — 520 kg
(1,146.3 lb) 1,100 kg
(2,425.0 lb) 2,605 kg (5,742.9 lb)
SKYACTIV-G
1.5 MP Automatic
transaxle EURO6 × — 530 kg
(1,168.4 lb) 1,000 kg
(2,204.6 lb) 2,535 kg (5,588.6 lb)
SKYACTIV-G
1.5 HP Manual
transaxle EURO6 × — 520 kg
(1,146.3 lb) 1,100 kg
(2,425.0 lb) 2,605 kg (5,742.9 lb)
SKYACTIV-G
1.5 HP Manual
transaxle EURO6 × × 520 kg
(1,146.3 lb) 1,100 kg
(2,425.0 lb) 2,610 kg (5,754.0 lb)
SKYACTIV-D
1.5 Manual
transaxle EURO6 × — 550 kg
(1,212.5 lb) 1,100 kg
(2,425.0 lb) 2,675 kg (5,897.3 lb)
×: Available
—: Not available
TRAILER NOSE WEIGHT: 50 kg (110.2 lb)
*1 The alphabetical letters at the end of the engine types are short for the following:
LP: Low-Power
MP: Medium-Power
HP: High-Power


South Africa/Gradient up to 12% (Hatchback only)
MODEL TOTAL TRAILER
WEIGHT GROSS
COMBINATION
WEIGHT
Engine Transaxle Emission
level i-stop
system i-ELOOP
system Trailer
without
brake Trailer with
brake Trailer with brake
SKYACTIV-G
1.5 Manual
transaxle EURO4 — — 450 kg
(992.0 lb) 750 kg
(1,653.4 lb) 2,246 kg (4,951.5 lb)
SKYACTIV-G
1.5 Automatic
transaxle EURO4 — — 250 kg
(551.1 lb) 250 kg
(551.1 lb) 1,765 kg (3,891.1 lb)
SKYACTIV-D
1.5 Automatic
transaxle EURO4 × — 130 kg
(286.5 lb) 130 kg
(286.5 lb) 1,735 kg (3,824.9 lb)
×: Available
—: Not available
TRAILER NOSE WEIGHT: 50 kg (110.2 lb)

3–60
Before Driving
Towing
WARNING
Always keep tow loads within speci¿ ed limits as indicated in the Trailer Towing-Load
Table:
Attempting to tow loads greater than those speci¿ ed is dangerous as it may cause
serious handling and performance problems that could result in personal injury or
vehicle damage, or both.

Always keep the trailer nose weight within the speci¿ ed limits in the Trailer Towing-
Load Table:
Loading the trailer with more weight in the rear than in the front is dangerous. This
could cause loss of vehicle control and an accident.
NOTE
  The total trailer weight and nose weight can be determined by weighing the trailer on
platform scales at a highway weighing station or a trucking company.
  Appropriate total trailer weight and nose weight may prevent the danger of trailer sway
from crosswinds, rough roads, or other causes.

3–62
Before Driving
Towing
Safety Chains
Safety chains must be used as a precautionary measure should the trailer become
unintentionally unhitched. They should cross under the trailer tongue and attach to the hitch.
Leave enough slack to allow full turns. Consult literature published by your trailer or hitch
manufacturer for more details.
WARNING
Make sure the safety chain is securely attached to both the trailer and the vehicle prior
to departure:
Towing a trailer without using a safety chain securely attached to both the trailer and
the vehicle is dangerous. If damage occurs to the coupling unit or hitch ball, the trailer
could wander into another lane and cause a collision.
Trailer Lights
CAUTION
Do not connect a trailer lighting system directly to the lighting system of your Mazda.
This may damage your vehicle's electrical system and lighting systems. To connect the
lighting system, consult an Authorised Mazda Dealer.
Trailer Brakes
Check the Maximum trailer towing-load table in Weight Limits (page 3-56 ), and if your
trailer weight exceeds the value in the TOTAL TRAILER WEIGHT (Trailer without brake),
trailer brakes are required.
If your trailer has brakes, make sure they meet regulations.
WARNING
Do not connect a hydraulic trailer-brake system to your vehicle's brake system:
Connecting a hydraulic trailer-brake system directly to the vehicle brake system is
dangerous and will result in inadequate braking and possible injury.

3–63
Before Driving
Towing
Trailer Towing Tips
Before driving
 




 Verify that your Mazda maintains a near-normal attitude when a loaded or unloaded trailer
is connected. Do not drive if it has an abnormal front-up or front-down position. Inspect
for incorrect nose weight, worn suspension parts, and trailer overloading. Have the vehicle
inspected by an expert repairer, we recommend an Authorised Mazda Repairer.
 


 Make sure the trailer cargo is secure to prevent it from shifting.



 Make sure the mirrors meet all government regulations. Inspect them.



 Before starting out, inspect the operation of all vehicle and trailer lights and all vehicle-
to-trailer connections. Stop and re-inspect all lights and connections after driving a short
distance.

Driving
 




 Your Mazda will handle differently with a trailer in tow, so practice turning, backing, and
stopping in a traf¿ c-free area.




 Take time to get accustomed to the extra weight and length.



 Do not exceed 100 km/h (62 mph) with a trailer in tow. If the local legal maximum speed
with a trailer in tow is less than 100 km/h (62 mph), do not exceed the legal speed.
CAUTION
If the vehicle exceeds 100 km/h (62 mph) with a trailer in tow, the vehicle could be
damaged.
 


 When ascending a hill, shift into a lower gear to reduce the possibility of overloading or
overheating the engine, or both.
 


 When descending a hill, shift into a lower gear and use engine compression as a braking
effect. Pay constant attention to speed and use the brakes only as needed. Holding the
brake pedal down for a prolonged period may cause the brakes to overheat and lose
power.

4–60
When Driving
Automatic Transaxle
Driving Tips
WARNING
Do not let the vehicle move in a
direction opposite to the direction
selected by the selector lever:
Do not let the vehicle move backward
with the selector lever in a forward
position, or do not let the vehicle move
forward with the selector lever in the
reverse position. Otherwise, the engine
may stop, causing the loss of the power
brake and power steering functions,
and make it dif¿ cult to control the
vehicle which could result in an
accident.
Passing
For extra power when passing another
vehicle or climbing steep grades, depress
the accelerator fully. The transaxle will
shift to a lower gear, depending on vehicle
speed.
NOTE
  The accelerator pedal may initially
feel heavy as it is being depressed,
then feel lighter as it is depressed
further. This change in pedal force
aids the engine control system
in determining how much the
accelerator pedal has been depressed
for performing kickdown, and
functions to control whether or not
kickdown should be performed.
 
 While the selector lever is in the M
position and the DSC is turned off,
manual shift mode does not switch
to automatic shift mode even if
the accelerator pedal is completely
depressed. Operate the selector lever.
Climbing steep grades from a stop
To climb a steep grade from a stopped
position:

1. Depress the brake pedal.
2. Shift to D or M1, depending on the
load weight and grade steepness.
3. Release the brake pedal while gradually
accelerating.

Descending steep grades
When descending a steep grade, shift to
lower gears, depending on load weight and
grade steepness. Descend slowly, using the
brakes only occasionally to prevent them
from overheating.

4–68
When Driving
Switches and Controls
*Some models.
Headlight Levelling *
The number of passengers and weight of
cargo in the luggage compartment change
the angle of the headlights.

Auto type
The angle of the headlights will be
automatically adjusted when turning on
the headlights.

Manual type
The headlight levelling switch is used
to adjust the angle of the headlights
manually.



Select the proper headlight angle from the
following chart.
Front seat
Rear
seat Load Switch
Position
Driver Passenger
× — — — 0
× × — — 0.5
× × × — 1.5
× × × × 2.5
× — — × 3.5
× : Y e s
—: No

Running Lights *
Some countries require moving vehicles to
have their lights on (running lights) during
the daytime.

The running lights turn on automatically
when the vehicle starts moving.

They turn off when the parking brake is
operated or the selector lever is shifted
to the P position (automatic transaxle
vehicle).
NOTE
(Except countries prohibited by law)
The running lights can be deactivated.
Refer to Personalisation Features on
page 9-13 .

4–201
When Driving
Rear View Monitor
NOTE
Because there may be a difference between the displayed image, such as indicated below,
and the actual conditions when parking, always verify the safety at the rear of the vehicle
and the surrounding area directly with your eyes.
 
 In the image of the parking space (or garage) displayed on the screen, the back end and
distance guide lines may appear aligned in the monitor, but they may not actually be
aligned on the ground.
  When parking in a space with a division line on only one side of the parking space, the
division line and the vehicle width guide line appear aligned in the monitor, but they
may not actually be aligned on the ground.


Variance Between Actual Road Conditions and Displayed Image
Some variance occurs between the actual road and the displayed road. Such variance in
distance perspective could lead to an accident. Note the following conditions that may cause
a variance in distance perspective.
When the vehicle is tilted due to the weight of passengers and load
When the vehicle rear is lowered, the object displayed on the screen appears farther than the
actual distance.

VarianceObject

6–20
Maintenance and Care
Owner Maintenance
Closing the Bonnet
1. Check under the bonnet area to make
certain all ¿ ller caps are in place and all
loose items (e.g. tools, oil containers,
etc.) have been removed.
2. Lift the bonnet, grasp the padded area
on the support rod, and secure the
support rod in the clip. Verify that the
support rod is secured in the clip before
closing the bonnet.


Clip
ClipClip

3. Lower the bonnet slowly to a height of
about 20 cm (7.9 in) above its closed
position and then let it drop.

CAUTION
When closing the bonnet, do not push
it excessively such as by applying your
weight. Otherwise, the bonnet could be
deformed.