2017 LEXUS LS600H warning

3604-5. Using the driving support systems
LS600h/LS600hL_EE(OM50G20E)
◆Warning for the approaching vehicle (emergency flashers)
When the system determines that there is a risk of a rear-end collision,
the emergency flashers flash to warn the driver of the vehicle
approaching from the rear.
◆Whiplash mitigation (pre-crash intelligent head restraints*)
When a vehicle draws near from behind and the system has deter-
mined that the possibility of a rear-end collision is very high, the sensor
in each front head restraint detects the position of the occupant’s head
and the pre-crash intelligent head restraint moves, contributing to
whiplash mitigation when a rear-end collision occurs.
*: For vehicles with a foldable head restraint, driver’s seat only.
Rear Pre-Crash Safety system
: If equipped
When the radar sensor detects the possibility of a rear-end collision,
the rear pre-crash safety system will operate to warn the approaching
vehicle and mitigate whiplash.
Rear-end collision
possibility is high
Rear-end collision
possibility is very highCollision
Emergency
light flashers Warning for the approaching
vehicle
Pre-crash
intelligent
head
restraints
Whiplash mitigation
Before operation After operation
State of
the vehicle

3614-5. Using the driving support systems
4
Driving
LS600h/LS600hL_EE(OM50G20E)
The rear radar sensor detects
objects approaching from behind
and determines whether a rear-end
collision is imminent based on the
position, speed and heading of the
object before it happens.
■System operating conditions
When the power switch is in ON mode and there is a possibility of a rear-end colli-
sion due to a vehicle in the same lane approaching from the rear, the system oper-
ates if all of the following conditions are met:
●Warning for the approaching vehicle (emergency flashers):
• The relative speed difference between your vehicle and the vehicle approach-
ing from behind is greater than about 30 km/h (18 mph).
• When the vehicle is stationary or moving forward while the brake pedal is
depressed.
• When the turn signal lights and emergency flashers are off.
●Whiplash mitigation (pre-crash intelligent head restraints):
• The relative speed difference between your vehicle and the vehicle approach-
ing from behind is greater than about 15 km/h (9 mph).
• Your vehicle is stopped or moving forward.
■Whiplash mitigation
The pre-crash intelligent head restraint may not stop in the proper position if a hat is
worn or the occupant’s hair is bound at the back.
Rear radar sensor

3624-5. Using the driving support systems
LS600h/LS600hL_EE(OM50G20E)
■Conditions in which it is hard for the sensor to detect objects
The rear pre-crash safety system is not a system that can detect all possible rear-end
collisions. The system may not operate in th e following situations. Always be aware of
the surrounding conditions.
●The vehicle posture is abnormal.
●The sensor may not detect objects such as bicycles and motorcycles.
●Raindrops, ice or snow are attached to the rear bumper.
●The road has curves or is bumpy.
●A rear-end collision occurs from an angle or with a large offset.
■Conditions that may trigger the system even if there is no danger of a rear-end col-
lision
●Another vehicle drives past just behind your vehicle when your vehicle is stopped
to turn right or left.
●Another vehicle drives past just beside your vehicle when your vehicle is stopped
on the side of the road.
●The vehicle behind you passes your vehicle from a short distance while your vehicle
is moving.
●The vehicle behind you approaches your vehicle rapidly to a close distance while
your vehicle is moving or stopped.
■When there is a malfunction in the system
Warning lights and/or warning messages will turn on or flash. ( P. 557, 563)

3674-5. Using the driving support systems
4
Driving
LS600h/LS600hL_EE(OM50G20E)
■The outside rear view mirror indicators visibility
When under strong sunlight, the outside rear view mirror indicator may be difficult to
see.
■Rear Crossing Traffic Alert buzzer hearing
Rear Crossing Traffic Alert function may be difficult to hear over loud noises such as
high audio volume.
■When there is a malfunction in the Blind Spot Monitor
If a system malfunction is detected due to any of the following reasons, warning mes-
sages will be displayed: ( P. 563)
●There is a malfunction with the sensors
●The sensors have become dirty
●The outside temperature is extremely high or low
●The sensor voltage has become abnormal
Outside rear view mirror indicators
Blind Spot Monitor function:
When a vehicle is detected in the blind spot, the outside rear view mirror indica-
tor comes on while the turn signal lever is not operated. If the turn signal lever is
operated toward the detected side, the outside rear view mirror indicator flashes.
Rear Crossing Traffic Alert function:
When a vehicle approaching from the right or left rear of the vehicle is detected,
the outside rear view mirror indicators flash.
Rear Crossing Traffic Alert buzzer (Rear Crossing Traffic Alert func-
tion only)
When a vehicle approaching from the right or left rear of the vehicle is detected,
a buzzer sounds from behind the rear seat.
2
3

3874-6. Driving tips
4
Driving
LS600h/LS600hL_EE(OM50G20E)
CAUTION
■Driving with snow tires
Observe the following precautions to reduce the risk of accidents.
Failure to do so may result in a loss of vehicle control and cause death or serious
injury.
●Use tires of the specified size.
●Maintain the recommended level of air pressure.
●Do not drive at speeds in excess of the speed limit or the speed limit specified for
the snow tires being used.
●Use snow tires on all, not just some wheels.
■Driving with tire chains
Observe the following precautions to reduce the risk of accidents.
Failure to do so may result in the vehicle being unable to be driven safely, and may
cause death or serious injury.
●Do not drive in excess of the speed limit specified for the tire chains being used,
or 50 km/h (30 mph), whichever is lower.
●Avoid driving on bumpy road surfaces or over potholes.
●Avoid sudden acceleration, abrupt steering, sudden braking and shifting opera-
tions that cause sudden engine braking.
●Slow down sufficiently before entering a curve to ensure that vehicle control is
maintained.
●Do not use LKA (Lane-Keeping Assist) system. (if equipped)
NOTICE
■Repairing or replacing snow tires
Request repairs or replacement of snow ti res from Lexus dealers or legitimate tire
retailers.
This is because the removal and attachment of snow tires affects the operation of
the tire pressure warning valves and transmitters.
■Fitting tire chains
The tire pressure warning valves and transmitters may not function correctly when
tire chains are fitted.

5016-3. Do-it-yourself maintenance
6
Maintenance and care
LS600h/LS600hL_EE(OM50G20E)
If any washer does not work or the
warning message appears on the
multi-information display, the
washer tank may be empty. Add
washer fluid.
Washer fluid
CAUTION
■When adding washer fluid
Do not add washer fluid when the hybrid system is hot or operating as washer fluid
contains alcohol and may catch fire if spilled on the engine etc.
NOTICE
■Do not use any fluid other than washer fluid
Do not use soapy water or engine antifreeze instead of washer fluid.
Doing so may cause streaking on the vehicle’s painted surfaces.
■Diluting washer fluid
Dilute washer fluid with water as necessary.
Refer to the freezing temperatures listed on the label of the washer fluid bottle.

5076-3. Do-it-yourself maintenance
6
Maintenance and care
LS600h/LS600hL_EE(OM50G20E)
Rotate the tires in the order shown.
To equalize tire wear and help extend tire life, Lexus recommends that tire
rotation is carried out approximately every 5000 km (3000 miles).
Do not fail to initialize the tire pressure warning system after tire rotation.
Tire rotation
Vehicles with a spare tireVehicles with an emergency tire
puncture repair kit
FrontFront

5086-3. Do-it-yourself maintenance
LS600h/LS600hL_EE(OM50G20E)
Your vehicle is equipped with a tire pressure warning system that uses tire
pressure warning valves and transmitters to detect low tire inflation pres-
sure before serious problems arise.
●If the tire pressure drops below a predetermined level, the driver is
warned by a screen display and a warning light. ( P. 559, 563)
◆Installing tire pressure wa rning valves and transmitters
When replacing tires or wheels, tire pressure warning valves and trans-
mitters must also be installed.
When new tire pressure warning valves and transmitters are installed,
new ID codes must be registered in the tire pressure warning computer
and the tire pressure warning system must be initialized. Have tire pres-
sure warning valve and transmitter ID codes registered by any autho-
rized Lexus dealer or repairer, or another duly qualified and equipped
professional. ( P. 510)
◆Initializing the tire pressure warning system
■The tire pressure warning system must be initialized in the following
circumstances:
●When rotating the tires.
●When the tire inflation pressure is changed such as when changing
traveling speed. ( P. 630)
When the tire pressure warning system is initialized, the current tire
inflation pressure is set as the benchmark pressure.
Tire pressure warning system
●The tire pressure detected by the tire pressure
warning system can be displayed on the multi-
information display. ( P. 125)