10
Remote Start (if so equipped)1
To start your vehicle remotely, press the
button 1 on the Infiniti Intelligent
Key, and within 5 seconds, press and
hold the remote engine start
button
2 for at least 2 seconds.
•
Automatic climate control will begin
heating or cooling the vehicle based
on the temperature inside and
outside the vehicle.
•
The hybrid system will run for 10
minutes and then turn off. To extend
the time for an additional 10-minute
period, repeat the procedure.
•
To start driving, depress the brake
pedal and press the ignition switch
START/STOP button.
Remote start can be enabled or disabled through the vehicle
information display.
HEATED STEERING WHEEL (if so equipped)
The heated steering wheel may be activated during remote
engine start when outside and cabin temperatures are low.
During remote start, the heated steering wheel switch will be
inoperable until the ignition switch is turned on.
1
2
Automatic Drive Positioner (if so equipped)
2 1
Two positions for the driver’s seat, steering column and outside mirr\
ors can be stored
in the automatic drive positioner memory. To set a memory position:
1.
Push the ignition switch to the ON or ACC position. (The vehicle should\
be stopped
while setting the memory.)
2.
Adjust the driver’s seat, steering column and outside mirrors to the \
desired
positions using the adjusting switches for each feature.
3.
Push the
SET switch
1 , and within 5 seconds, push the memory switch
(1 or 2)
2 . The indicator light for the memory switch you select will illuminate for
approximately 5 seconds and a chime will sound when the memory is stored\
.
4.
Press the unlock button on the key fob to link the memorized position to\
your
Infiniti Intelligent Key.
The driver’s seat and steering column will automatically move when th\
e shift lever
is in the
P (PARK) position to allow the driver to get in and out of the driver’s seat \
more easily. “Exit Seat Slide” and “Exit Steering UP” can be\
disabled in the vehicle
information display under “Vehicle Settings”.
1 For disclaimer, refer to page 17 of this guide.
For more information, refer to your Owner
11
Heater and Air Conditioner (automatic)
• Press the AUTO button 1 to turn the system on and automatically control the
inside temperature.
•
Press the CLIMATE button
2 to adjust the automatic climate controls using the
climate settings on the control panel display screen.
•
Use the driver’s side 3 or passenger’s side 4 control buttons (warmer air) or
(cooler air) to control the desired side’s temperature.
•
Press the air flow control button 5 to manually cycle through the available
air flow modes.
•
Press the DUAL button
6 to turn the system on and off.
•
Press the fan speed control buttons 7 to increase or decrease the fan speed.
•
Press the front defroster button 8 to turn the front defroster system on and off,
and use the temperature control buttons
3 to change the temperature.
•
To defrost the rear window and outside mirrors, press the rear defroster\
switch
9 to turn the system on and off.
1 2
4 3
5 6
7 8109
REAR CONTROLS
•
Press the
REAR ON-OFF button
12 to turn the rear air conditioner on
and off.
•
Press the
OFF button
13 to turn the system off.
•
Adjust the fan speed up or down using the control buttons 14.
•
Press the AUTO button
15 to turn on the automatic mode.
•
Adjust the temperature up or down using the
TEMP buttons
16.
1112
13
15
1416
• Press the intake air control button 10 to recirculate the air inside
the vehicle.
•
Press the OFF button
11 to turn the climate control system off.
For more information, refer to your Owner
