2017 INFINITI QX30 headrest

1. Rear seat belts (Page. 1-7)
3. Roof-mounted curtain side impact and roll-over supplemental air bags (P. 1-39)
4. Front seat belts (P. 1-11)
5. Seat belt pretensioners (P. 1-54)
6. Air bag warning label (P. 1-55) 7. Driver Supplemental front-impact air bag
(P. 1-38)
8. Passenger supplemental front-impact air bag (P. 1-38)
9. Top tether strap anchors (P. 1-23) 10. LATCH (Lower Anchors and Tethers for
CHildren)/ ISOFIX child restraint system
(P. 1-21)
11. Rear seats (P. 1-5) — Child restraints (P. 1-20)
12. Head restraints/headrests (P. 1-7)
13. Front seat-mounted side impact supple- mental air bags (P. 1-39)
14. Front seats (P. 1-3) — Occupant Classification System (OCS)
(P. 1-47)
15. Front passenger air bag status light (P. 1-47)
16. Driver and passenger supplemental knee air bags (P. 1-39)
*: if equipped
NIC2847
SEATS, SEAT BELTS AND SUPPLEMENTAL
RESTRAINT SYSTEM (SRS)
0-2Illustrated table of contents

1 Safety — seats, seat belts and supplemental
restraint system
Seats............................. .1-2
Front seats .........................1-3
Seat heater (if equipped) .................1-5
Rear seats ..........................1-5
Armrest (if equipped) .................. .1-7
Head restraints/Headrests ..................1-7
Adjustable head restraint components ........1-8
Remove .......................... .1-8
Install ........................... .1-9
Adjust ........................... .1-9
Rear seat head restraints/headrests .........1-10
Seat belts .......................... .1-11
Precautions on seat belt usage ............1-11
Pregnant women .................... .1-13
Injured persons ..................... .1-13
Seat belt warning light .................1-14
Three-point type seat belt with retractor .......1-14
Seat belt extenders .................. .1-17
Seat belt maintenance ..................1-17
Child safety ..........................1-18
Infants .......................... .1-18Small children
..................... .1-19
Larger children ..................... .1-19
Child restraints ....................... .1-20
Precautions on child restraints ............1-20
Rear-facing child restraint installation using
LATCH .......................... .1-23
Rear-facing child restraint installation using
the seat belts ...................... .1-25
Forward-facing child restraint installation using
LATCH .......................... .1-28
Forward-facing child restraint installation
using the seat belts .................. .1-31
Booster seats ...................... .1-35
Supplemental Restraint System (SRS) ..........1-38
Precautions on Supplemental Restraint System
(SRS) ........................... .1-38
Supplemental air bag systems .............1-45
Supplemental air bag warning labels ........
.1-55
Supplemental air

bag warning light ..........1-55
Repair and replacement procedure ..........1-56

Lumbar support:
The lumbar support feature provides lower back
support to the driver.
Push each side of the adjusting switch to adjust
the seat lumbar area until the desired position
is achieved.
1To raise the seatback contour
2To soften the seatback contour
3To lower the seatback contour
4To harden the seatback contour
SEAT HEATER (IF EQUIPPED)
The seats can be warmed by built-in heaters.
The switches are located on the center console
(for front seats) and can be operated indepen-
dently of each other. For more information on
the seat heater, seeSeat heating (if
equipped) in the2. Instruments and controls
section.
REAR SEATS
WARNING
•Never allow anyone to ride in the cargo area
or on the rear seat when it is in the fold-
down position. Use of these areas by pas-
sengers without proper restraints could re-
sult in serious injury or deathin an accident
or sudden stop.
•Properly secure all cargo with ropes or straps
to help prevent it from sliding or shifting. Do
not place cargo higher than the seatbacks. In
a sudden stop or collision, unsecured cargo
could cause personal injury.
•Do not allow people to ride in any area of
your vehicle that is not equipped with seats
and seat belts. Be sure everyone in your
vehicle is in a seat and using a seat belt
properly.
•Do not allow more than one person to use
the same seat belt.
•Do not fold down the rear seats when occu-
pants are in the rear seat area or any lug-
gage is on the rear seats. – Make sure that the seat path is clear
before moving the seat.
– Be careful not to allow hands or feet to
get caught or pinched in the seat.
•Head restraints/headrests should be ad-
justed properly as they may provide signifi-
cant protection against injury in an acci-
dent. Always replace and adjust them
properly if they have been removed for any
reason.
•If the head restraints/headrests are re-
moved for any reason, they should be se-
curely stored to prevent them from causing
injury to passengers or damage to the ve-
hicle in case of sudden braking or an acci-
dent.
•When returning the seatbacks to the up-
right position, be certain they are com-
pletely secured in the latched position. If
they are not completely secured, passen-
gers may be injured in an accident or sud-
den stop.
NIC2607
Safety — seats, seat belts and supplemental restraint system1-5

Folding
The luggage compartment loading capacity can
be increased by folding the rear seat backs
forward.
To fold the seat back
:
1. Ensure head restraints are properly stowed,see Head restraints/Headrests later in this
section.
2. Release the seat back lock by pulling the release handle.
3. Fold the seat back forward . 4. Insert the seat belt into the seat belt holder.
To return the seat back to an upright position
:
1. Make sure the seat belts are clear of the seat
back latch mechanism.
2. Lift the seat back up and push firmly to lock.
3. If the red marker is visible then the seat back has not latched properly — release and then
re-latch the seat.
4. If the head restraint/headrest was removed, reinstall and properly adjust the head
restraint/headrest before an occupant uses
the seating position. See Head
restraints/Headrests later in this section.
WARNING
Always use the seat belt holder, and ensure
that the seat belt is not trapped in the seat
back latch mechanism. Failure to do so may
cause damage to the seat belt, and this may
increase the risk of serious injury or death in a
collision.
NPA1293NIC2669
1-6Safety — seats, seat belts and supplemental restraint system

ARMREST (IF EQUIPPED)
Rear
Pull the tab and draw the armrest1forward
until it is horizontal.
Indicates that the seating position is
equipped with a head restraint.
Indicates that the seating position is
equipped with a non-removable head rest.
WARNING
Head restraints/headrests supplement the
other vehicle safety systems. They may pro-
vide additional protection against injury in cer-
tain rear end collisions. Adjustable head
restraints/headrests must be adjusted prop-
erly, as specified in this section. Check the
adjustment after someone else uses the seat.
Do not attach anything to the head restraint/
headrest stalks or remove the head restraint/
headrest. Do not use the seat if the head
restraint/headrest has been removed. If the
head restraint/headrest was removed, rein- stall and properly adjust the head restraint/
headrest before an occupant uses the seating
position. Failure to follow these instructions
can reduce the effectiveness of the head
restraints/headrests. This may increase the
risk of serious injury or death in a collision.
•Your vehicle is equipped with head
restraints/headrests that may be integrated,
adjustable or non-adjustable.
•Adjustable head restraints/headrests have
multiple notches along the stalk to lock them
in a desired adjustment position.
•The non-adjustable head restraints/
headrests have a single locking notch to
secure them to the seat frame.
•Proper Adjustment:
– For the adjustable type, align the head restraint/headrest so the center of your
ear is approximately level with the center
of the head restraint/headrest.
– If your ear position is still higher than the recommended alignment, place the head
restraint/headrest at the highest
position.
NIC2611NPA1500
HEAD RESTRAINTS/HEADRESTS
Safety — seats, seat belts and supplemental restraint system1-7

•If the head restraint/headrest has been re-
moved, ensure that it is reinstalled and
locked in place before riding in that desig-
nated seating position.
NOTE
For vehicles with sports seats you cannot adjust
the front head restraints/headrests or the outer
rear head restraints/headrests.
ADJUSTABLE HEAD RESTRAINT
COMPONENTS
1. Removable head restraint/headrest
2. Multiple notches
3. Lock knob
4. Stalks
REMOVE
Use the following procedure to remove the head
restraint/headrest.
1. Pull the head restraint/headrest up to the highest position.
2. Push and hold the lock knob.
3. Remove the head restraint/headrest from the seat.
4. Store the head restraint/headrest properly in a secure place so it is not loose in the
vehicle.
5. Reinstall and properly adjust the head restraint/headrest before an occupant uses
the seating position.
SSS0992ZSSS1037Z
1-8Safety — seats, seat belts and supplemental restraint system

INSTALL
1. Align the head restraint/headrest stalks withthe holes in the seat. Make sure that the
head restraint/headrest is facing the correct
direction. The stalk with the adjustment
notch
1must be installed in the hole with
the lock knob
2.
2. Push and hold the lock knob and push the head restraint/headrest down.
3. Properly adjust the head restraint/headrest before an occupant uses the seating posi-
tion.
ADJUST
For adjustable head restraint/ headrest
Adjust the head restraint/headrest so the cen-
ter is level with the center of your ears. If your
ear position is still higher than the recom-
mended alignment, place the head restraint/
headrest at the highest position.
Raise
To raise the head restraint/headrest, pull it up.
Make sure the head restraint/headrest is posi-
tioned from the stored position or any non-latch
position so the lock knob is engaged in the
notch before riding in that designated seating
position.
SSS1038ZSSS0997ZSSS1035Z
Safety — seats, seat belts and supplemental restraint system1-9

Lower
To lower, push and hold the lock knob1and
push the head restraint/headrest down.
Make sure the head restraint/headrest is posi-
tioned so the lock knob is engaged in the notch
before riding in that designated seating posi-
tion.
Fore-aft
This function allows you to adjust the distance
between the head restraint/headrest and the
back of the head.
•To move forwards: pull the head restraint/
headrest forwards in the direction of the
arrow until it engages. There are a number of
detents.
•To move backwards: press and hold button
1and push the head restraint/headrest
backwards.
•When the head restraint/headrest is in the
desired position, release the button and
make sure that the head restraint/headrest
is engaged in position.
REAR SEAT HEAD RESTRAINTS/
HEADRESTS
Adjusting the rear seat head
restraint/headrest height
Use the head restraint/headrest in the notched
stem positions after pulling it up from the
stowed position to a position in which it locks
securely in place.
•To raise: pull the head restraint/headrest up
to the desired height.
•To lower: press release catch1and push
the head restraint/headrest down until it is
in the desired position.
SSS1036ZNIC2610NIC2609
1-10Safety — seats, seat belts and supplemental restraint system