6-17
What to do in an emergency
6
If  it  is  hard  to  loosen  the  tyre  hold-
down  wing  bolt  by  hand,  you  can
loosen it easily using the jack handle.
1. Put  the  jack  handle  (1)  inside  of
the tyre hold-down wing bolt.
2. Turn  the  tyre  hold-down  wing  bolt
anticlockwise with the jack handle.
Changing tyres
OLF064005
•Never  attempt  vehicle  repairs
in  the  traffic  lanes  of  a  public
road or highway.
•Always move the vehicle com-
pletely  off  the  road  and  onto
the  shoulder  before  trying  to
change a tyre. The jack should
be  used  on  firm  level  ground.
If  you  cannot  find  a  firm  level
place  off  the  road, call  a  tow-
ing  service  company  for
assistance.
•Be  sure  to  use  the  correct
front  and  rear  jacking  posi-
tions  on  the  vehicle; never
use  the  bumpers  or  any  other
part  of  the  vehicle  for  jacking
support.
•The  vehicle  can  easily  roll  off
the  jack  causing  serious
injury or death.
(Continued)
WA R N I N G    
(Continued)
•Do  not  get  under  a  vehicle
that is supported by a jack.
•No  person  should  place  any
portion  of  their  body  under  a
vehicle  that  is  supported  by  a
jack.
•Chock  the  wheel  diagonally
opposite the flat tyre.
•Do not start or run the engine
whilst  the  vehicle  is  on  the
jack.
•Do not allow anyone to remain
in  the  vehicle  whilst  it  is  on
the jack.
•Make  sure  any  children  pres-
ent are in a secure place away
from  the  road  and  from  the
vehicle  to  be  raised  with  the
jack. 
6-19
What to do in an emergency
6
7. Place  the  jack  at  the  designated
jacking  position  under  the  frame
closest  to  the  tyre  you  are  chang-
ing. The  jacking  positions  are
plates  welded  to  the  frame  with
two  notches  and  two  dimples.
Never  jack  any  other  position  or
part of the vehicle. It may damage
the side seal molding.
8. Insert the jack handle into the jack
and  turn  it  clockwise,  raising  the
vehicle  until  the  tyre  clears  the
ground. Make  sure  the  vehicle  is
stable on the jack.
9. Loosen the lug nuts with the wheel
nut wrench and remove them with
your  fingers. Remove  the  wheel
from the studs and lay it flat on the
ground  out  of  the  way. Remove
any  dirt  or  debris  from  the  studs,
mounting surfaces, and wheel.
10. Install  the  spare  tyre  onto  the
studs of the hub.
11. Tighten the lug nuts with your fin-
gers  onto  the  studs  with  the
smaller  end  of  the  lug  nuts  clos-
est to the wheel.
12. Lower  the  vehicle  to  the  ground
by  turning  the  jack  handle  anti-
clockwise.
OAD065008
■Front■Rear
OLF064012