Page 12 of 606

11
Quick Reference Guide
Instrument Panel (P71)
System Indicators
Malfunction Indicator 
Lamp
Low Oil Pressure 
Indicator
Charging System 
IndicatorAnti-lock Brake System 
(
ABS ) Indicator
Vehicle Stability Assist 
(VSA®
) System Indicator
VSA ® OFF Indicator
Electric Power Steering 
(EPS) System Indicator
Lights Indicators
Lights On Indicator
High Beam Indicator
Immobilizer System 
Indicator
Seat Belt Reminder 
Indicator
System Indicators
System Message 
IndicatorParking Brake and 
Brake System 
Indicator (Red)Supplemental 
Restraint System 
Indicator
Low Fuel Indicator
Gauges (P101)/Multi-Information Display (P102)/System Indicators (P72)
Low Tire Pressure/
TPMS Indicator Turn Signal and 
Hazard Warning 
Indicators
Smart Entry System 
Indicator Ambient Meter Shift Lever 
Position Indicator
Fuel Gauge
Tachometer
Temperature 
Gauge
Speedometer
Multi-Information Display
Brake System 
Indicator (Amber)
All-wheel drive system 
(AWD ) Indicator*
Blind spot information 
(BSI) Indicator*
System Indicators
Collision Mitigation Braking 
SystemTM (CMBSTM) Indicator*
Road Departure Mitigation 
(RDM) Indicator*
Security System Alarm 
Indicator
U.S.
Canada U.S.
Canada
Fog Light Indicator*
ECON Mode Indicator
Auto high-beam 
Indicator
*
Lane Keeping Assist 
System ( LKAS) Indicator*
CRUISE MAIN  
Indicator*
CRUISE CONTROL  
Indicator*
Adaptive Cruise 
Control (ACC ) 
Indicator
*
Intelligent Traction 
Management Indicator
Bed Lights On Indicator
*  Not available on all models 
     
        
        Page 79 of 606

78
uuIndicators u
Instrument Panel
IndicatorNameOn/BlinkingExplanationMessage
Electric Power 
Steering (EPS) 
System Indicator
●Comes on when you set the 
power mode to ON, and goes off 
when the engine starts.
●Comes on if there is a problem 
with the EPS system.
●Stays on constantly or does not come on 
at all - Have your vehicle checked by a 
dealer.
2If the Electric Power Steering (EPS) 
System Indicator Comes On  P. 573
Low Tire Pressure/
TPMS Indicator
●Comes on for a few seconds 
when you set the power mode to 
ON, then goes off.
●Comes on if the tire pressure of 
any of the tires becomes 
significantly low.
●Blinks for about one minute, and 
then stays on if there is a problem 
with the TPMS with Tire Fill 
Assist, or when a compact spare 
tire is temporarily installed.
●Comes on while driving - Stop in a safe 
place, check tire pres sures, and inflate the 
tire(s) if necessary.
●Blinks and remains on - Have your vehicle 
checked by a dealer. If the vehicle is fitted 
with a compact spare, get your regular tire 
repaired or replaced and put back on your 
vehicle as soon as you can.
Turn Signal and 
Hazard Warning 
Indicators●Blinks when you operate the turn 
signal lever.
●Blink when you press the hazard 
warning button.
●Does not blink or blinks rapidly  - A turn 
signal light bulb has blown. Change the 
bulb immediately.
2 Replacing Light Bulbs  P. 526, 527
—
High Beam 
Indicator●Comes on when the high beam 
headlights are on.—— 
     
        
        Page 172 of 606
171
uuInterior Lights/Convenience Items uInterior Convenience Items
Continued
Controls
Interior Convenience Items
Pull the lever to open the glove box. You can 
lock the glove box with the built-in key.
■Glove Box1Glove Box
3WARNING
An open glove box can cause serious injury 
to your passenger in a crash, even if the 
passenger is wearing the seat belt.
Always keep the glove box closed while 
driving.
Glove Box
To Lock 
     
        
        Page 180 of 606
Continued179
uuInterior Lights/Convenience Items uInterior Convenience Items
Controls
The power mode is in ON to use the seat 
heaters. The  HI setting heats the seats faster 
than the  LO setting.
The appropriate indicator  will be on while the 
seat heater is on. For low heat and high heat, 
press  LO and  HI respectively. Center the 
rocker switch to tu rn the heater off.
■Front Seat Heaters*1Front Seat Heaters*
Do not use the seat heaters even in  LO when the 
engine is off. Under such conditions, the battery may 
be weakened, making the engine difficult to start.
In the LO  setting, the heater runs continuously and 
does not automatically turn off.
3WARNING
Heat induced burns are possible when 
using seat heaters. 
Persons with a diminished ability to sense 
temperature (e.g., persons with diabetes, 
lower-limb nerve damage, or paralysis) or 
with sensitive skin should not use seat 
heaters.
* Not available on all models 
     
        
        Page 181 of 606

uuInterior Lights/Convenience Items uInterior Convenience Items
180
Controls
If the power mode is in ON:
Seat heater - The HI setting heats the seats 
faster than the LO setting.
Seat ventilation -  The HI setting ventilates 
the seats faster than the LO setting.
Press the seat heater or the seat ventilation 
button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF setting (no indicators on)
When a comfortable temperature is reached 
while using the seat heaters in HI, select MID 
or LO to keep the seat warm.
■Front Seat Heaters and Seat Ventilation*1 Front Seat Heaters and Seat Ventilation*
Do not use the seat heater s and the seat ventilation 
even in LO when the engine is off. Under such 
conditions, the battery ma y be weakened, making 
the engine difficult to start.
3WARNING
Heat induced burns are possible when 
using seat heaters. 
Persons with a diminished ability to sense 
temperature (e.g., persons with diabetes, 
lower-limb nerve damage, or paralysis) or 
with sensitive skin should not use seat 
heaters.
* Not available on all models 
     
        
        Page 182 of 606

181
uuInterior Lights/Convenience Items uInterior Convenience Items
Controls
If the power mode is in ON: The HI setting 
heats the seats faster than the LO setting.
There is no heater in the rear center seating 
position.
Press the seat heater button:
Once - The HI setting (three indicators on)
Twice - The MID setting (two indicators on)
Three times - The LO setting (one indicator on)
Four times - The OFF setting (no indicators on)
Once a comfortable temperature has been 
reached using HI setting, select MID or LO to 
keep the seat warm.
■Rear Outer Seat Heaters*1Rear Outer Seat Heaters*
Do not use the seat heaters even in LO when the 
engine is off. Under such conditions, the battery may 
be weakened, making the engine difficult to start.
3WARNING
Heat induced burns are possible when 
using seat heaters.
Persons with a diminished ability to sense 
temperature (e.g., persons with diabetes, 
lower-limb nerve damage, or paralysis) or 
with sensitive skin should not use seat 
heaters.
* Not available on all models 
     
        
        Page 447 of 606

uuWhen Driving uAdaptive Cruise Control (ACC)*
446
Driving
The system may automatically shut off and the  ACC indicator will come on under 
certain conditions. Some examples of th ese conditions are listed below. Other 
conditions may reduce some of the ACC functions.
2 Front Sensor Camera* P. 434
■Environmental conditions
Driving in bad weather (r ain, fog, snow, etc.).
■Roadway conditions
Driving on a snowy or wet roadway (obscure d lane marking, vehicle tracks, reflected 
lights, road spray, high contrast).
■Vehicle conditions
• The outside of the windshie ld is blocked by dirt, mud, leaves, wet snow, etc.
• An abnormal tire or wheel condition (wro ng sized, varied size or construction, 
improperly inflated, comp act spare tire, etc.).
• The camera temperature gets too high.
• The parking brake is applied.
• When the radar sensor cover is dirty.
• When the front of the vehicle tilts up due to heavy cargo in the trunk or rear seats.
• When tire chains are installed.
■ACC Conditions and Limitations1ACC Conditions and Limitations
The radar sensor for ACC is shared with the collision 
mitigation braking system
TM (CMBSTM).
2 Collision Mitigation Braking SystemTM 
(CMBSTM)* P. 478
Do not put a sticker on the radar sensor cover or 
replace the radar sensor cover.
Have your vehicle checked by a dealer if you find any 
unusual behavior of the system (e.g., the warning 
message appears too frequently).
If the front of the vehicle  is impacted in any of the 
following situations, the ra dar sensor may not work 
properly. Have your vehi cle checked by a dealer:
•The vehicle mounted onto a bump, curb, chock, 
embankment, etc.
•You drive the vehicle where the water is deep.
•Your vehicle has a frontal collision.
You can read about handling information for the 
camera equipped with this system. 2 Front Sensor Camera
* P. 434
* Not available on all models 
     
        
        Page 554 of 606

553Continued
Handling the Unexpected
If a Tire Goes Flat
Changing a Flat Tire
If a tire goes flat while driving, grasp the steering wheel firmly, and brake gradually 
to reduce speed. Then, stop in a safe plac e. Replace the flat tire with a compact 
spare tire. Go to a dealer as soon as possib le to have the full-size tire repaired or 
replaced.
1. Park the vehicle on firm, level, non-slip pery surface and apply the parking brake.
2. Move the shift lever to 
(P.
3. Turn on the hazard warning lights and set the power mode to VEHICLE OFF 
(LOCK).
1Changing a Flat Tire
Follow compact spare precautions:
Periodically check the tire pressure of the compact 
spare. It should be set to the specified pressure. 
Specified Pressure: 60 psi (420 kPa, 4.2 kgf/cm
2)
When driving with the compact spare tire, keep the 
vehicle speed under 50 mph (80 km/h). Replace with 
a full-size tire as soon as possible.
The compact spare tire and wheel in your vehicle are 
specifically for this model. Do not use them with 
another vehicle. Do not us e another type of compact 
spare tire or wheel with your vehicle.
Do not mount tire chains  on a compact spare tire. 
If a chain-mounted front tire  goes flat, remove one of 
the full-size rear tires and replace it with the compact 
spare tire. Remove the flat front tire and replace it 
with the full-size tire that was removed from the rear. 
Mount the tire chains on the front tire.
Do not use a puncture-repairi ng agent on a flat tire, 
as it can damage the tire pressure sensor.