Page 448 of 489
447
uuJump Starting u
Handling the Unexpected
Once your vehicle’s engine has started, re move the jumper cables in the following 
order.
1. Disconnect the jumper cable from your vehicle’s stud bolt.
2. Disconnect the other end of the jumper cable from the booster battery -  
terminal.
3. Disconnect the jumper cable  from your vehicle’s battery + terminal.
4. Disconnect the other end of the jumper cable from the booster battery + 
terminal.
Have your vehicle inspected by a n earby service station or a dealer.
■What to Do After the Engine Starts
17 HR-V HDMC-31T7A6100.book  447 ページ  2016年7月20日 水曜日 午前9時50分 
         
        
        
     
        
        Page 450 of 489
449Continued
Handling the Unexpected
Overheating
How to Handle Overheating
Overheating symptoms are as follows:
•The high temperature indicator (red) co mes on or the engine suddenly loses 
power.
• Steam or spray comes out of the engine compartment.
■First thing to do
1. Immediately park the vehicle in a safe place.
2. Turn off all accessories and turn on the hazard warning lights.
u No steam or spray present:  Keep the engine running and open the hood.
u Steam or spray is present:  Turn off the engine and wait until it subsides.
Then open the hood.
1 How to Handle Overheating
NOTICE
Continuing to drive with the high temperature 
indicator on may da mage the engine.
3WARNING
Steam and spray from an overheated 
engine can seriously scald you.
Do not open the hood  if steam is coming 
out.
17 HR-V HDMC-31T7A6100.book  449 ページ  2016年7月20日 水曜日 午前9時50分 
         
        
        
     
        
        Page 451 of 489

uuOverheating uHow to Handle Overheating
450
Handling the Unexpected
■Next thing to do
1.Check that the cooling fan is operating and 
stop the engine once the high temperature 
indicator goes off.
u If the cooling fan is not operating, 
immediately stop the engine.
2. Once the engine has cooled down, inspect 
the coolant level an d check the cooling 
system components for leaks.
u If the coolant level in the reserve tank is 
low, add coolant until it reaches the 
MAX  mark.
u If there is no coolan t in the reserve tank, 
check that the radiator is cool. Cover the 
radiator cap with a heavy cloth and open 
the cap. If necessary, add coolant up to 
the base of the filler neck, and put the 
cap back on.
■Last thing to do
Once the engine has cooled sufficiently,  restart it and check the high temperature 
indicator.
If the high temperature indicator is off, resume  driving. If it stays on, contact a dealer 
for repairs.
1 How to Handle Overheating
If the coolant is leaking, contact a dealer for repairs.
Use water as an emergency/temporary measure only. 
Have a dealer flush the system with proper antifreeze 
as soon as possible.
3WARNING
Removing the radiator cap while the 
engine is hot can cause the coolant to spray 
out, seriously scalding you.
Always let the engine and radiator cool 
down before removing  the radiator cap.MAX
Reserve Tank
MIN
17 HR-V HDMC-31T7A6100.book  450 ページ  2016年7月20日 水曜日 午前9時50分 
         
        
        
     
        
        Page 452 of 489

451
Handling the Unexpected
Indicator, Coming On/Blinking
If the Low Oil Pressure Indicator Comes On
■Reasons for the indicator to come on
Comes on when the engine oil pressure is low.
■What to do as soon as  the indicator comes on
1. Immediately park the vehicle on level ground in a safe place.
2. If necessary, turn the hazard warning lights on.
■What to do after parking the vehicle
1. Stop the engine and let it sit for about three minutes.
2. Open the hood and check the oil level.
u Add oil as necessary.
2 Oil Check P. 388
3.Start the engine and check th e low oil pressure indicator.
u The indicator goes off: Start driving again.
u The indicator does not go off within 10 seconds: Stop the engine 
and contact a dealer for repairs immediately.
If the Charging System  Indicator Comes On
■Reasons for the indicator to come on
Comes on when the battery is not being charged.
■What to do when th e indicator comes on
Turn off the heating and cooling system*/climate control system*, rear 
defogger, and other electrical system s, and immediately contact a dealer 
for repairs.
1 If the Low Oil Pressure Indicator Comes On
NOTICE
Running the engine with low oil pressure can cause 
serious mechanical damage almost immediately.
1If the Charging System Indicator Comes On
If you need to stop temporarily, do not turn off the 
engine. Restarting the engi ne may rapidly discharge 
the battery.
* Not available on all models
17 HR-V HDMC-31T7A6100.book  451 ページ  2016年7月20日 水曜日 午前9時50分 
         
        
        
     
        
        Page 453 of 489

452
uuIndicator, Coming On/Blinking uIf the Malfunction Indicato r Lamp Comes On or Blinks
Handling the Unexpected
If the Malfunction Indicator Lamp Comes On or 
Blinks
■Reasons for the indicator la mp to come on or blink
• Comes on when there is a problem with the engine emissions control 
system, or the fuel fill cap is missing, or loose.
• Blinks when engine misfiring is detected.
■What to do when the indicator lamp comes on
Avoid high speeds and immediately get your vehicle inspected at a 
dealer.
■What to do when the indicator lamp blinks
Park the vehicle in a safe place with no flammable items and wait at least 
10 minutes or more with the engine stopped until it cools.
■The message appears on when:
An evaporative system leak is detected. This  may be caused by the fuel fill cap being 
loose or not being installed.
■What to do when the message appears:
1. Stop the engine.
2. Check that the fuel fill cap is fully installed.
u If not, loosen the cap, and then reti ghten it until it clicks at least once.
3. Drive for several days of normal driving.
u The message should go off.
■When the malfunction indicator lamp comes on
The malfunction indicator lamp comes on if the system continues to detect a leak of 
gasoline vapor. If this happens, check the fuel fill cap using the procedures described 
above.
■Check Fuel Cap Message
1 If the Malfunction Indicato r Lamp Comes On or Blinks
NOTICE
If you drive with the malf unction indicator lamp on, 
the emissions control system and the engine could be 
damaged.
If the malfunction  indicator lamp blinks again when 
restarting the engine, drive  to the nearest dealer at 
31 mph (50 km/h) or less. Have your vehicle 
inspected.
17 HR-V HDMC-31T7A6100.book  452 ページ  2016年7月20日 水曜日 午前9時50分 
         
        
        
     
        
        Page 454 of 489

453
uuIndicator, Comin g On/BlinkinguIf the Brake System Indicator (Red) Comes On
Handling the Unexpected
If the Brake System Indicator (Red) Comes On
■Reasons for the indicator to come on
• The brake fluid is low.
• There is a malfunction in the brake system.
■What to do when the indicator comes on while driving
Depress the brake pedal lightly to check pedal pressure.
• If normal, check the brake fluid  level the next time you stop.
• If abnormal, take immediate acti on. If necessary, downshift the 
transmission to slow the vehicle using engine braking.
If the Electric Power Steeri ng (EPS) System Indicator 
Comes On
■Reasons for the indicator to come on
• Comes on when there is a problem with the EPS system.
• If you depress the accelerator pedal  repeatedly to increase the engine 
speed while the engine is idling, the indicator comes on, and 
sometimes the steering wheel becomes harder to operate.
■What to do when th e indicator comes on
Stop the vehicle in a safe  place and restart the engine.
If the indicator comes on and stays on, immediately have your vehicle 
inspected by a dealer.
1 If the Brake System Indicator (Red) Comes On
Have your vehicle re paired immediately.
It is dangerous to drive with  low brake fluid. If there 
is no resistance from  the brake pedal, stop 
immediately in a safe plac e. If necessary downshift 
the gears.
If the brake system indicator and  ABS indicator come 
on simultaneously, the elec tronic brake distribution 
system is not working. Th is can result in vehicle 
instability under sudden braking.
Have your vehicle inspecte d by a dealer immediately.U.S.
Canada
17 HR-V HDMC-31T7A6100.book  453 ページ  2016年7月20日 水曜日 午前9時50分 
         
        
        
     
        
        Page 457 of 489

456
Handling the Unexpected
Fuses
Fuse Locations
If any electrical devices are not working, 
turn the ignition switch to LOCK 
(0*1 and 
check to see if any appl icable fuse is blown.
■Fuse box A
Located near the brake fluid reservoir. Push 
the tabs to open the box.
Fuse locations are shown on the fuse box 
cover. Locate the fuse in question by the 
fuse number and box cover number.
■Engine Compartment Fuse Box
Tab
■Circuit protected and fuse rating
Circuit ProtectedAmps
1Headlight Low Beam Main20 A
2CDC*(30 A)
3Hazard10 A
4DBW15 A
5Wiper*(30 A)
6Stop10 A
7IGP15 A
8IG Coil15 A
9EOP*(10 A)
10INJ*(20 A)
11VST2*(30 A)
12Main Fan30 A
13Starter SW*(30 A)
14MG Clutch7.5 A
15Battery Sensor(7.5 A)
16Small Light10 A
17AFP Main*(10 A)
18Horn10 A
19Fog Light*(10 A)
20SBW*(10 A)
*1:Models with the sma rt entry system have 
an  ENGINE START/STOP  button 
instead of an ignition switch.
Circuit ProtectedAmps
21Back Up Main10 A
22Audio(10 A)
23Sub Fan(30 A)
24VST1*(30 A)
25STRLD*(7.5 A)
26IGP CAM*(7.5 A)
27––
28––
29Back Up*(30 A)
30IGP LAF(7.5 A)
31IGPS(7.5 A)
32Right Headlight Low Beam10 A
33Left Headlight Low Beam10 A
* Not available on all models
17 HR-V HDMC-31T7A6100.book  456 ページ  2016年7月20日 水曜日 午前9時50分 
         
        
        
     
        
        Page 458 of 489
457
uuFuses uFuse Locations
Continued
Handling the Unexpected
■Fuse box B
Tab
a
bcd
Pull up the cover on the  + terminal, then 
remove it while pulling out the tab as 
shown.
Replacement of engine compartment fuses 
should be done by a dealer.■Circuit protected and fuse rating
Circuit ProtectedAmps
aBattery Main100 A
bRB Main 170 A
cRB Main 280 A
dCAP Main70 A
17 HR-V HDMC-31T7A6100.book  457 ページ  2016年7月20日 水曜日 午前9時50分