
157
uuOperating the Switches Around the Steering Wheel uWipers and Washers
Continued
Controls
Wipers and Washers
The windshield wipers and washers can be 
used when the power mode is in ON.
■MIST
The wipers run at high speed until you release 
the lever.
■Wiper switch (OFF, INT, LO, HI)
Move the lever up or down to change the 
wiper settings.
■Adjusting wiper operation
Turn the adjustment ring to adjust the wiper 
operation.
■Washer
Sprays while you pull the lever toward you.
When you release the le ver for more than one 
second, the spray stops, the wipers sweep two 
or three more times to  clear the windshield, 
then stop.
■Windshield Wipers/Washers1 Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get sc ratched, or the rubber 
blades will get damaged.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
When the wiper motor is  kept running under heavy 
load for extended periods  of time, this protection 
feature is activated,  and the wiper speed may 
decrease or motor operat ion may stop temporarily. 
This function will be canceled within a few minutes 
once the load has been reduced; the wiper operation 
returns to normal.
If the vehicle speeds up while the wipers are 
operating intermittently,  the length of the wipe 
interval shortens.
When the vehicle speeds  up, the wiper operation’s 
shortest delay se tting ( ) and the  LO setting 
become the same.
NOTICE
In cold weather, the blades may freeze to the 
windshield.
Operating the wipers in th is condition may damage 
the wipers. Use the defroster to warm the 
windshield, then turn the wipers on.
MIST
OFF
LO : Low speed wipe
HI: High speed wipe Pull to 
use 
washer.
INT
Intermittent Time 
Adjustment Ring
Lower speed, fewer sweeps
Higher speed, more sweeps
17 CLARITY BEV CSS-31TRV6000.book  157 ページ  2017年4月14日 金曜日 午前11 時8分 

Continued185
uuClimate Control System uUsing Automatic Climate Control
Controls
■Switching the vent mode
1.Press the  CLIMATE  button.
2. Select a desired vent mode icon.
■A/C on and off
1.Press the  CLIMATE  button.
2. Select  On or  Off .
1Using Automatic Climate Control
When you unlock the doors with your remote, the 
driver’s ID (DRIVER 1 or DRIVER 2) is detected, and 
the climate control settings are turned to the 
respective mode automatically when you set the 
power mode to ON.
The High Voltage battery level being low may reduce 
the climate control system performance.
If any icons are not select ed within several seconds 
after the display is switched, it returns to the previous 
screen. In this case, press the  CLIMATE button again.
You can change the length of time the climate 
control display stays on. 2 Customized Features  P. 280
While ECON mode is active, the climate control 
system may have reduced  cooling performance.
17 CLARITY BEV CSS-31TRV6000.book  185 ページ  2017年4月14日 金曜日 午前11 時8分 

Continued237
uuAudio System Basic Operation uPlaying SiriusXM ® Radio
Features
The system can record up to the last 60  minutes of your currently tuned channel’s 
broadcast, as well as the last 30 minutes  of your preset channel’s broadcast, starting 
from the moment you turn the vehicle on.  If you tuned to a preset channel, the 
system records up to 60 minutes of a broadcast instead of up to 30 minutes. You 
can rewind and replay the last 30 or 60 minutes of a broadcast.
1. Select .
2. Select  Playback.
3. Move the time marker to the position you want to replay.
The following items are availa ble on the pop-up screen:
 (Skip Down): Skips to the  previously stored channel. Select and hold to fast-
rewind the current selection.  (Skip Up): Skips to the next channel.  Select and hold to fast-forward the 
current selection.
 (15sec Back): Select to skip back 15 se conds in the current selection. Select and 
hold to fast-rewind th e current selection.
 (15sec Skip): Select to sk ip forward 15 seconds in th e current selection. Select 
and hold to fast-forward  the current selection.
u Select  OK to close the pop-up menu. Replay in playback mode continues.
To play or pause on playback mode:
1. Select .
2. Select  Play/Pause .
■Replay Function1Replay Function
The system starts storing broadcast in memory when 
the power mode is turned ON. You can go back to 
the program from that point.
You can no longer repl ay any program once the 
power mode is turned off as it erases memory.
You can check how long the program has been 
stored in memory from th e audio/information screen.
After 30 or 60 minutes of recording the system will 
automatically start deleting the oldest data.
(A): Shows how much time the replayed segment is 
behind the real-time broadcast
(B): Replayed segment
(C): Length stored in memory
When you listen a multi-channel preset while at the 
playback mode, the repl ayed segment is not 
displayed.
Audio/Information Screen
(C)(B)
(A)
17 CLARITY BEV CSS-31TRV6000.book  237 ページ  2017年4月14日 金曜日 午前11
時8分 

291
uuCustomized Features u
Continued
Features
*1:Default SettingSetup 
Group Customizable Features Descri
ption Selectable Settings
Camera
Rear 
Camera
Fixed Guideline
Selects whether the fixed guidelines come on 
the rear camera monitor.
2 Multi-View Rear Camera P. 421
On*1/Off
Dynamic Guideline
Selects whether the guid elines adjust to the 
movement of the steering wheel.
2 Multi-View Rear Camera P. 421
On*1/Off
DefaultCancels/Resets all cust omized items in the Rear 
Camera  setting group as default.Yes/No
LaneWatch
Show with Turn Signal
Selects whether the LaneWatch display comes 
on when you move the turn signal lever to 
indicate a right turn.
On*1/ Off
Display Time after Turn 
Signal OffChanges the length of time the LaneWatch 
display stays on after the turn signal lever 
returns to the center.0 second*1/
2 seconds
Reference LineSelects whether the refere nce lines come on the 
LaneWatch monitor.On*1/ Off
DefaultCancels/Resets all cust omized items in the 
LaneWatch  group as default.Yes/No
17 CLARITY BEV CSS-31TRV6000.book  291 ページ  2017年4月14日 金曜日 午前11 時8分 

300
uuCustomized Features u
Features
*1:Default SettingSetup 
Group Customizable Features Description Selectable Settings
System Others Climate Screen Timeout
Changes the length of time the climate control 
display stays on when you press the 
CLIMATE 
button. Never/
5 Seconds /10 
Seconds
*1/ 20 
Seconds
Detail Information Displays the details of the head unit and 
operating system information.
Default Cancels /Resets all cust
omized items in the 
System  group as default. Yes
/No
Vehicle
TPMS CalibrationCancels/Calibrates the TPMS.Cancel /Calibrate
Driver 
Assist 
System 
Setup
Forward Collision Warning 
DistanceChanges the distance at which CMBSTM alerts.Long /Normal*1/Short
ACC Forward Vehicle 
Detect BeepCauses the system to beep when the system 
detects a vehicle, or when  the vehicle goes out of 
the ACC with LSF range.
On /Off*1
Lane Keeping Assist 
Suspend BeepCauses the system to  beep when LKAS is 
suspended.On /Off*1
Road Departure Mitigation 
SettingChanges the setting for the road departure 
mitigation system.Normal*1/Wide /
Warning Only
17 CLARITY BEV CSS-31TRV6000.book  300 ページ  2017年4月14日 金曜日 午前11 時8分 

303
uuCustomized Features u
Continued
Features
*1:Default SettingSetup 
Group Customizable Features Desc
ription Selectable Settings
VehicleLighting 
Setup
Interior Light Dimming 
TimeChanges the length of time the interior lights stay 
on after you close the doors.15seconds/
30seconds*1/
60seconds
Headlight Auto Off TimerChanges the length of time the exterior lights 
stay on after you clos e the driver’s door.
0seconds/
15seconds*1/
30seconds /
60seconds
Auto Light SensitivityChanges the timing for th e headlights to come 
on.Max /High /Mid*1/
Low/ Min
Auto Interior Illumination 
SensitivityChanges the sensitivity of the brightness of the 
instrument panel when the headlight switch is in 
the AUTO  position.Max/High /Mid*1/
Low/ Min
Auto Headlight ON With 
Wiper ONChanges the settings for the wiper operation 
when the headlights automa tically come on while 
the headlight switch is in the  AUTO position.
On*1/Off
17 CLARITY BEV CSS-31TRV6000.book  303 ページ  2017年4月14日 金曜日 午前11 時8分 

403
uuWhen Driving uLaneWatchTM
Driving
■Customizing the La neWatch settings
You can customize the following items using the audio/information screen.
• Show with Turn Signal : Selects whether LaneWatch monitor comes on when 
you operate the turn signal light lever.
• Display Time after Turn Signal Off : Changes the length of time the LaneWatch 
display stays on after you pull  the turn signal lever back.
• Reference Line : Selects whether the reference lines appear on the LaneWatch 
monitor.
• Display : Allows for display adjustments of item s, such as brightness, contrast and 
black level. This setting is part of the  System setup group.
2Customized Features  P. 280
■Reference Lines
Three lines that appear on the screen can give 
an idea of how far the vehicles or objects on 
the screen are from your vehicle, respectively. 
If an object is near line 1 (in red), it indicates 
that it is close to your vehicle whereas an 
object near line 3 farther away.
1LaneWatchTM
The LaneWatch camera view  is restricted. Its unique 
lens makes objects on the screen slightly look 
different from what they are.
LaneWatch display does not come on when the gear 
position is in 
( R.
For proper LaneWatch operation:
•The camera is located in  the passenger side door 
mirror. Always keep this area clean. If the camera 
lens is covered with dirt  or moisture, use a soft, 
moist cloth to keep the lens  clean and free of debris.
•Do not cover the camera lens with labels or stickers 
of any kind.
•Do not touch the camera lens.
23
1
1Reference Lines
The area around the reference line 1 (red) is very close 
to your vehicle. As always, make sure to visually 
confirm the safety of a la ne change before changing 
lanes.
The distance betwee n your vehicle and lines 1, 2 and 
3 on the screen vary depending on road conditions 
and vehicle loading. For ex ample, the reference lines 
on the screen may seem to appear closer than the 
actual distances when the rear of your vehicle is more 
heavily loaded.
Consult an authorized Honda Clarity Electric dealer if:
•The passenger side door mirr or, or area around it is 
severely impacted, resulting in changing the 
camera angle.
•The LaneWatch display doe s not come on at all.
17 CLARITY BEV CSS-31TRV6000.book  403 ページ  2017年4月14日 金曜日 午前11 時8分