Page 90 of 595

89
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Road Departure 
Mitigation (RDM) 
Indicator
*
●Comes on for a few seconds 
when you turn the ignition switch 
to ON 
(w*1, then goes off.●Comes on if there is a problem 
with the RDM system.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
●Comes on when the RDM system 
shuts itself off.●Stays on  - The temperature inside the 
camera is too high.
Use the climate contro l system to cool 
down the camera.
The system activates when the 
temperature inside the camera cools 
down.
2 Front Sensor Camera* P. 414
●Stays on  - The area around the camera is 
blocked by dirt, mud, etc. Stop your 
vehicle in a safe place,  and wipe it off with 
a soft cloth.
●Have your vehicle checked by a dealer if 
the indicator and message come back on 
after you cleaned the area around the 
camera.
2 Front Sensor Camera* P. 414
* Not available on all models
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  89 ページ  2016年8月31日 水曜日 午後5時43分 
     
        
        Page 91 of 595

90
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Adaptive Cruise 
Control (ACC) 
with Low Speed 
Follow (LSF) 
Indicator 
(Amber)
*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on if there is a problem 
with ACC with LSF.
●Comes on while driving  - Have your 
vehicle checked by a dealer.
●Comes on if anything covers the 
radar sensor cover and prevents 
the sensor from detecting a 
vehicle in front.
●May come on when driving in bad 
weather (rain, snow, fog, etc.)
●ACC with LSF has been 
automatically canceled.
●When the radar sensor gets dirty, stop 
your vehicle in a safe place, and wipe off 
dirt using a soft cloth.
●Have your vehicle checked by a dealer if 
the indicator does not go off even after 
you clean the sensor cover.
Adaptive Cruise 
Control ( ACC) 
with Low Speed 
Follow (LSF) 
Indicator 
(Green)
*
●Comes on when you press the 
MAIN  button.2Adaptive Cruise Control (ACC) with 
Low Speed Follow (LSF)* P. 416—
●Comes on when ACC with LSF is 
in operation, but the temperature 
inside the front sensor camera is 
too high. ACC with LSF cancels 
automatically. The beeper sounds 
simultaneously.●Use the climate control system to cool 
down the camera.
●Goes off  - The camera has been cooled 
down. Pressing the  MAIN button can 
resume the system.
2 Front Sensor Camera* P. 414
2 Adaptive Cruise Control (ACC) with 
Low Speed Follow (LSF)
* P. 416
* Not available on all models
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  90 ページ  2016年8月31日 水曜日 午後5時43分 
     
        
        Page 92 of 595

91
uuIndicators u
Continued
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Lane Keeping 
Assist System 
(LKAS ) Indicator 
(Amber)
*
●Comes on for a few seconds 
when you turn the  ignition switch 
to ON 
(w*1, then goes off.●Comes on if there is a problem 
with the LKAS.
●Stays on constantly  - Have your vehicle 
checked by a dealer.
Lane Keeping 
Assist System 
( LKAS ) Indicator 
(Green)
*
●Comes on when you press the 
MAIN  button.2Lane Keeping Assist System (LKAS)* 
P. 434—
●Comes on when the LKAS is in 
operation, or the LKAS button is 
pressed, but the temperature 
inside the front sensor camera is 
too high. The LKAS cancels 
automatically. The beeper sounds 
simultaneously.●Use the climate control system to cool 
down the camera.
●Goes off  - The camera has cooled down 
and the system is working normally.
2 Front Sensor Camera* P. 414
●Comes on when the area around 
the camera is blocked by dirt, 
mud, etc. Stop your vehicle in a 
safe place, and wipe it off with a 
soft cloth.
●May come on when driving in bad 
weather (rain, snow, fog, etc.)
●Have your vehicle checked by a dealer if 
the indicator and message come back on 
after you cleaned the area around the 
camera.
* Not available on all models
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  91 ページ  2016年8月31日 水曜日 午後5時43分 
     
        
        Page 93 of 595
92
uuIndicators u
Instrument Panel
*1:Models with the smart entry system have an  ENGINE START/STOP button instead of an ignition switch.
IndicatorNameOn/BlinkingExplanationMessage*
Collision 
Mitigation 
Braking 
System
TM 
(CMBSTM) 
Indicator*
●Comes on for a few seconds when 
you turn the ignition switch to ON 
(w*1, then goes off.●Comes on when you deactivate 
the CMBSTM. A driver information 
interface message appears for five 
seconds.
●Comes on if there is a problem 
with the CMBSTM.
●Stays on constantly without the 
CMBSTM off  - Have your vehicle checked 
by a dealer.
2 Collision Mitigation Braking 
SystemTM (CMBSTM)* P. 459
●Comes on if the CMBSTM is 
deactivated temporarily after the 
battery has been disconnected, 
then re-connected.●Drive a short distance at more than 12 
mph (20 km/h). The indicator should go 
off. If it does not, have your vehicle 
checked by a dealer.
* Not available on all models
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  92 ページ  2016年8月31日 水曜日 午後5時43分 
     
        
        Page 97 of 595

96
uuIndicators uDriver Information Interface Wa rning and Information Messages*
Instrument Panel
Driver Information Interface Warning and Information Messages*
The following messages appear only on the dr iver information interface. Press the   (display/information) button to see the message 
again with the system  message indicator on.
MessageConditionExplanation
●Appears if either door or the trunk is not completely 
closed.
●Appears if either door or  the trunk is opened while 
driving. The beeper sounds.
●Goes off when both doors and the trunk are closed.
●Appears when the washer fluid gets low.●Refill the washer fluid.
2 Refilling Window Washer Fluid  P. 503
●Appears when the scheduled maintenance is due 
soon.
●Consequently, Maintenance Due Now  and 
Maintenance Past Due  follow.
2Maintenance Minder Messages on the Driver 
Information Interface  P. 485
●Appears when there is a problem with the sensor on 
the battery.●Have your vehicle checked by a dealer.
2Checking the Battery  P. 525
●Appears along with the battery charging system 
indicator when the batte ry is not charging.●Turn off the climate control system and rear defogger to 
reduce electricity consumption.
2If the Charging System Indicator Comes On  P. 555
●Appears when the engine coolant temperature gets 
abnormally high.
2 Overheating  P. 553
Canadian models
* Not available on all models
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  96 ページ  2016年8月31日 水曜日 午後5時43分 
     
        
        Page 103 of 595
102
uuIndicators uDriver Information Interface Wa rning and Information Messages*
Instrument Panel
MessageConditionExplanation
●Appears if the smart entry remote battery is too 
weak to start the engine or the key is not within 
operating range to start the engine.
A beeper sounds six times.●Bring the smart entry remote in front of the  ENGINE 
START/STOP  button to be touched with.
2If the Smart Entry Remote Battery is Weak  P. 547
●Appears when the starter system has a problem.●As a temporary measure, press and hold the ENGINE 
START/STOP  button for up to 15 seconds while pressing 
the brake pedal and manua lly start the engine.
Have your vehicle checked by a dealer.
●Appears as soon as a problem is detected in the 
smart entry system or pus h button starting system.●Appears constantly - Have your vehicle checked by a 
dealer.
U.S.
Canada
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  102 ページ  2016年8月31日 水曜日 午後5時43分 
     
        
        Page 182 of 595

Continued181
uuInterior Lights/Interior Convenience Items uInterior Convenience Items
Controls
To use the wireless charger, the power  mode must be in ACCESSORY or ON.
Charge a compatible device on the ar ea indicated by the   mark as follows:
1. To turn the system on and off, press and 
hold the   (power) button.
u When the system is activated, the green 
indicator light comes on.
2. Place the device you want to charge on the 
charging area.
u The system will au tomatically start 
charging the device, and the amber 
indicator light will come on.
u Make sure that the device is compatible 
with the system and placed with the 
chargeable side in the center of the 
charging area.
3. When charging is completed, the green 
indicator light will come on.
u Depending on the device, the amber 
indicator light will stay on.
■Wireless Charger*
Canadian models1Wireless Charger*
This system consumes a lot of power. Do not use the 
system for a long time when the engine is not 
running. This may weaken  the battery, making it 
difficult to start the engine.
When using the wireless charger, check the user’s manual 
that came with the compatible device you want to charge.
3CAUTION
Metal objects between the charge pad 
and the device to be charged will get 
hot and can burn you.
• Always remove foreign objects from 
the charge pad before charging the 
device.
• Be sure the surface is clear of dust and 
other debris before charging.
• Do not spill liquids (i. e. water, drinks, 
etc.) on the charger and the device.
• Do not use oil, grease, alcohol, 
benzine or thinner for cleaning the 
charge pad.
• Do not cover the system with towels, 
clothing, or other objects while 
charging etc.
• Avoid spraying aerosols which may 
come in contact with the charge pad 
surface.
Green Indicator
Amber Indicator
Charging Area (Power) Button
* Not available on all models
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  181 ページ  2016年8月31日 水曜日 午後5時43分 
     
        
        Page 197 of 595
196
uuAudio System uAudio System Theft Protection
Features
Audio System Theft Protection
The audio system is disabled when it is di sconnected from the power source, such as 
when the battery is disconnected or goes dead. In certain conditions, the system 
may display a code entry screen. If this occurs, reactivate the audio system.
■Reactivating th e audio system
1. Turn the ignition  switch to ON 
(w*1.
2. Turn on the audio system.
3. Press and hold the audio  system power button for  more than two seconds.
u The audio system is reac tivated when the audio co ntrol unit establishes a 
connection with the vehicle control unit. If the control unit fails to recognize 
the audio unit, you must go to a dealer and have the audio unit checked.
*1: Models with the smart entry system have an  ENGINE START/STOP button instead of an 
ignition switch.
17 CIVIC 2D HCM (KA KC KL)-31TBG6100.book  196 ページ  2016年8月31日 水曜日 午後5時43分