2017 DODGE DURANGO radio

instrument cluster will display the “SERVICE TPM SYS-
TEM” message and then display dashes (--) in place of the
pressure values. Beginning with the next ignition switch
cycle, the TPMS will no longer chime or flash the TPM
telltale and display the “SERVICE TPM SYSTEM” message
in the instrument cluster display but dashes (--) will remain
in place of the pressure values.
To reactivate the TPMS, replace all four wheel and tire
assemblies (road tires) with tires equipped with TPM sen-
sors. Then, drive the vehicle for up to 10 minutes above
15 mph (24 km/h). The TPMS will chime, the “TPM Telltale
Light” will flash on and off for 75 seconds and then turn off,
and the instrument cluster will display the “SERVICE TPM
SYSTEM” message. The instrument cluster will also display
pressure values in place of the dashes. On the next ignition
switch cycle the “SERVICE TPM SYSTEM” message will no
longer be displayed as long as no system fault exists.
General Information
The following regulatory statement applies to all radio
frequency (RF) devices equipped in this vehicle:
This device complies with Part 15 of the FCC Rules and
with Industry Canada license-exempt RSS standard(s).Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
NOTE:
Changes or modifications not expressly approved
by the party responsible for compliance could void the
user ’s authority to operate the equipment.
FUEL REQUIREMENTS
3.6L Engine
This engine is designed to meet all emis-
sions regulations and provide excellent
fuel economy and performance when
using high-quality unleaded “Regular”
gasoline having an octane rating of 87 as
specified by the (R+M)/2 method. The
use of higher octane “Premium” gaso-
line will not provide any benefit over “Regular” gasoline in
these engines.
444 STARTING AND OPERATING

WARNING!
•Take care to avoid the radiator cooling fan whenever
the hood is raised. It can start anytime the ignition
switch is ON. You can be injured by moving fan
blades.
• Remove any metal jewelry such as rings, watch
bands and bracelets that could make an inadvertent
electrical contact. You could be seriously injured.
• Batteries contain sulfuric acid that can burn your
skin or eyes and generate hydrogen gas which is
flammable and explosive. Keep open flames or
sparks away from the battery.
NOTE: Be sure that the disconnected ends of the cables do
not touch while still connected to either vehicle.
1. Set the parking brake, shift the automatic transmission into PARK and turn the ignition to LOCK.
2. Turn off the heater, radio, and all unnecessary electrical accessories.
3. Remove the protective cover over the remote positive (+) battery post. Pull upward on the cover to remove it. 4. If using another vehicle to jump-start the battery, park
the vehicle within the jumper cables reach, set the
parking brake and make sure the ignition is OFF.
WARNING!
Do not allow vehicles to touch each other as this could
establish a ground connection and personal injury
could result.
Jump-Starting Procedure
WARNING!
Failure to follow this jump-starting procedure could
result in personal injury or property damage due to
battery explosion.
CAUTION!
Failure to follow these procedures could result in
damage to the charging system of the booster vehicle
or the discharged vehicle.
NOTE: Make sure at all times that unused ends of jumper
cables are not contacting each other or either vehicle while
making connections.
6
WHAT TO DO IN EMERGENCIES 489

WARNING!
•ONLY an authorized service technician should con-
nect equipment to the OBD II connection port in
order to diagnose or service your vehicle.
• If unauthorized equipment is connected to the OBD
II connection port, such as a driver-behavior tracking
device, it may:
• Be possible that vehicle systems, including safety
related systems, could be impaired or a loss of
vehicle control could occur that may result in an
accident involving serious injury or death.
• Access, or allow others to access, information
stored in your vehicle systems, including personal
information.
For further information, refer to “Privacy Practices — If
Equipped With Uconnect 8.4 Radio” and “Uconnect Cy-
berSecurity” in “All About Uconnect Access” in your
Owner ’s Manual Radio Supplement and “Cybersecurity”
in “Understanding Your Instrument Panel”.
EMISSIONS INSPECTION AND MAINTENANCE
PROGRAMS
In some localities, it may be a legal requirement to pass an
inspection of your vehicle’s emissions control system.
Failure to pass could prevent vehicle registration. For states that require an Inspection and Mainte-
nance (I/M), this check verifies the “Malfunction
Indicator Light (MIL)” is functioning and is not on
when the engine is running, and that the OBD II system is
ready for testing.
Normally, the OBD II system will be ready. The OBD II
system may notbe ready if your vehicle was recently
serviced, recently had a dead battery or a battery replace-
ment. If the OBD II system should be determined not ready
for the I/M test, your vehicle may fail the test.
Your vehicle has a simple ignition actuated test, which you
can use prior to going to the test station. To check if your
vehicle’s OBD II system is ready, you must do the follow-
ing:
1. Cycle the ignition switch to the ON position, but do not crank or start the engine.
NOTE: If you crank or start the engine, you will have to
start this test over.
506 MAINTAINING YOUR VEHICLE

CAUTION!
Damage caused by these type of products may not be
covered by your New Vehicle Limited Warranty.
CAUTION!
Do not use Alcohol and Alcohol-based and/or Keton
based cleaning products to clean leather seats, as
damage to the seat may result.
Cleaning Headlights
Your vehicle is equipped with plastic headlights and fog
lights that are lighter and less susceptible to stone breakage
than glass headlights.
Plastic is not as scratch resistant as glass and therefore
different lens cleaning procedures must be followed.
To minimize the possibility of scratching the lenses and
reducing light output, avoid wiping with a dry cloth. To
remove road dirt, wash with a mild soap solution followed
by rinsing.
Do not use abrasive cleaning components, solvents, steel
wool or other aggressive material to clean the lenses.
Glass Surfaces
All glass surfaces should be cleaned on a regular basis with
MOPAR Glass Cleaner, or any commercial household-type
glass cleaner. Never use an abrasive type cleaner. Use
caution when cleaning the inside rear window equipped
with electric defrosters or windows equipped with radio
antennas. Do not use scrapers or other sharp instrument
that may scratch the elements.
When cleaning the rear view mirror, spray cleaner on the
towel or cloth that you are using. Do not spray cleaner
directly on the mirror.
Cleaning Plastic Instrument Cluster Lenses
The lenses in front of the instruments in this vehicle are
molded in clear plastic. When cleaning the lenses, care
must be taken to avoid scratching the plastic.
1. Clean with a wet soft cloth. A mild soap solution may beused, but do not use high alcohol content or abrasive
cleaners. If soap is used, wipe clean with a clean damp
cloth.
2. Dry with a soft cloth.
532 MAINTAINING YOUR VEHICLE

Memory Seat............................. .130
Memory Seats And Radio .....................130
Methanol ............................... .446
Mirrors ..................................94
Electric Powered ........................ .100
Electric Remote ......................... .100
Exterior Folding ........................ .100
Heated ............................... .101
Outside ................................99
Rearview ...............................94
Vanity ............................... .101
Modifications/Alterations, Vehicle ................8
MOPAR Parts ......................... .507, 561
Multi-Function Control Lever ..................135
New Vehicle Break-In Period ...................83
Occupant Restraints .........................40
Octane Rating, Gasoline (Fuel) .................444
Oil, Engine ........................... .262, 508
Capacity .............................. .545
Change Interval ........................ .509
Dipstick .............................. .508
Disposal .............................. .510
Filter .................................511 Filter Disposal
.......................... .510
Identification Logo ...................... .509
Materials Added To ...................... .510
Pressure Warning Light ....................242
Recommendation .....................509, 545
Viscosity .......................... .510, 545
Oil Filter, Change ..........................511
Oil Filter, Selection ..........................511
Oil Pressure Light ......................... .242
Onboard Diagnostic System ...................505
Opener, Garage Door (HomeLink) ...............196
Operating Precautions ...................... .505
Operator Manual (Owner’s Manual) ...............6
Outside Rearview Mirrors .....................99
Overhead Console ......................... .194
Over

heating, Engine ....................... .474
Owner’s Manual (Operator Manual) ...........6,562
Paint Care ............................... .528
Panic Alarm ...............................20
Parking Brake ............................ .404
ParkSense System, Rear ..................... .183
Passing Light ............................ .142
Passive Entry ..............................30
Personalized Menu Bar ..................... .353
574 INDEX

Pets.....................................83
Placard, Tire And Loading Information ...........424
Power Brakes ............................... .406
Distribution Center (Fuses) ..................534
Door Locks ..............................27
Inverter .............................. .210
Lift Gate ...............................38
Mirrors ............................... .100
Outlet (Auxiliary Electrical Outlet) ............206
Seats ..............................110,111
Steering ........................... .403, 549
Sunroof .............................. .203
Tilt/Telescoping Steering Column .............148
Windows ...............................34
Power Seats Forward ............................110,111
Rearward ...........................110,111
Recline ................................110
Pregnant Women And Seat Belts .................48
Preparation For Jacking ..................... .480
Pretensioners Seat Belts ...............................49
Programming Key Fobs (Remote Keyless Entry) ......19Quadra-Trac
............................. .395
Radial Ply Tires ........................... .429
Radiator Cap (Coolant Pressure Cap) .............523
Radio Frequency General Information .............14, 16, 23, 26, 33
Radio Operation .......................... .334
Radio Remote Controls ..................... .332
Radio (Sound Systems) ..................... .314
Rain Sensitive Wiper System ...................146
Rear Air Conditioning ...................... .343
Rear Axle (Differential) ..................... .526
Rear Camera ............................. .192
Rear Cross Path ........................... .107
Rear Cupholder ............................211
Rear ParkSense System ..................... .183
Rear Seat, Folding ......................... .123
Rear Window Features ...................... .222
Rear

Wiper/Washer ........................ .222
Reclining Front Seats ........................113
Recreational Towing ........................ .466
Shifting Into Transfer Case Neutral (N) .........468
Shifting Out Of Transfer Case Neutral (N) .......470
Reformulated Gasoline ...................... .445
Refrigerant .............................. .513
10
INDEX 575

Reminder, Seat Belt..........................41
Remote Control Starting System ...........................23
Remote Keyless Entry ........................19
Arm The Alarm ..........................16
Disarm The Alarm ........................17
Panic Alarm .............................20
Programming Additional Key Fobs ..........16, 21
Remote Sound System (Radio) Controls ...........332
Remote Starting Exit Remote Start Mode .....................25
Uconnect Customer Programmable Features . . .26, 285
Uconnect Settings ..................... .26, 285
Remote Starting System .......................23
Replacement Bulbs ........................ .540
Replacement Keys ...........................15
Replacement Parts ......................... .507
Replacement Tires ......................... .436
Reporting Safety Defects .....................561
Restraints, Child ............................63
Retractable Cargo Area Cover ..................220
Roll Over Warning ...........................5
Roof Type Carrier ......................... .223
Rotation, Tires ............................ .438Safety Checks Inside Vehicle
...................85
Safety Checks Outside Vehicle ..................88
Safety Defects, Reporting .....................561
Safety, Exhaust Gas ..........................85
Safety Information, Tire ..................... .417
Safety Tips ................................84
Schedule, Maintenance ...................... .552
Seat Belt Adjustable Upper Shoulder Belt Anchorage .......47
Automatic Locking Retractor (ALR) ............49
Energy Management Feature .................49
Lap/Shoulder Belt Operation .................45
Lap/Shoulder Belts ........................43
Lap/Shoulder Belt Untwisting ................46
Pregnant Women .........................48
Seat Belt Extender .........................48
Seat Belt Pretensioner ......................49
Seat Belt Reminder ........................41
Seat Belt Maintenance ...................... .533
Seat Belt Reminder ..........................41
Seat Belts ............................. .41, 85
Adjustable Shoulder Belt ....................47
Adjustable

Upper Shoulder Anchorage ..........47
Child Restraint ...........................63
Extender ...............................48
576 INDEX

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.