Page 91 of 527

89
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Third-row seats
Concertina boards
Folding the concertina boards
F Remove the luggage net.
F or more information on the luggage net
and the Interior fittings , refer to the
corresponding section.
F
R
eturn the second-row continuity panels to
their initial position and lock them in place.
F
F
old the concertina boards and position
them vertically.
F
P
ull on the strap F located behind the seat
backrest. The backrest pivots rear wards,
pulling the seat base with it. The seat locks
in the open position.
Each of the two floor panels can
support a load of 100 kg.
Pull on the control, the 3 sections of the board
will fold like a concertina.
When the third-row seats are upright, these
concertina boards can be left either:
-
f
lat behind the seats,
-
i
n the vertical position,
thereby leaving a storage area available.
Repositioning the
seats
Two rigid concertina boards, which cannot
be separated from the vehicle, cover the
2
third-row seats, when these are in the folded
position.
3
Ease of use and comfort
Page 92 of 527

90
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
F Return the second-row continuity panels to their initial position and lock them.
F
L
ower the head restraints.
F
C
orrectly position the concertina board
vertically behind the seat.
F
C
heck that the seat belts for the 3
rd row
seats are correctly fixed to the loops and
are not folded.
F
P
ull the strap G , located at the bottom of
the seat backrest. The seat unlocks. Before moving the third-row seats,
return the rigid floor plates of the
second-row seats to the upright position
and lock them in place.
Do not try to fold a third-row seat that
has not first had the backrest fully
locked in place.
Do not leave objects either on or
underneath the seat bases of the third-
row seats when you are folding them.
Do not leave your hand on the control
G
as you fold the seats, as you risk
trapping your fingers.
Do not allow children to operate the
seats without supervision.
F
N
ext push the backrest gently for wards.
The backrest pivots, folding onto the seat
base. The seat base then folds into the
stowage area provided for that purpose.
F
R
eposition the concertina boards over the
folded seats.
Folding the seats
Ease of use and comfort
Page 93 of 527
91
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Seat modularity and configurations
Examples of configurations
5 seats
4 seats3 seats
Maximum loadspace
3
Ease of use and comfort
Page 94 of 527
92
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Examples of seat configurations
7 seats
6 seatsMaximum loadspace
5 seats 4 seats
For easy modification of your
interior
vehicle space, all the rear seats
can be individually folded: onto the
second-row floor, and under the third-
row floor. You can then have a load
floor that is continuous up to the front
seat backrests.
The seats must only be folded and
unfolded with the vehicle stationary.
Ease of use and comfort
Page 104 of 527
102
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
"Rear" function
F Press this button to activate / deactivate the "Rear" function.
From the secondary page of the Air
conditioning
menu:
This function gives rear passengers access to
the adjustment controls and allows:
-
t
he distribution of air conditioned air to the
vents for the 2
nd row of seats,
-
t
he distribution of ambient air to the vents
for the 3
rd row of seats.
F
T
urn the upper knob to open or close the
rear vent.
F
T
urn the lower knob to reduce (to the left)
or increase (to the right) the air flow.
Settings for passengers
in the 2nd row of seats"Mono" function
The comfort setting for the passenger's side
can be indexed to the driver's comfort setting
(mono-zone).
In the Air conditioning menu:
F
P
ress this button to activate /
deactivate the "Mono" function.
The function is deactivated automatically when
the passenger uses their temperature setting
buttons.
Ease of use and comfort
Page 105 of 527
103
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Settings for
passengers
in the 3
rd row of seats
F Press the vent cover.
F A djust the flow of air to the two vents using
the four-position knob (off, low, medium,
hi g h).
F
D
irect the vent by turning the cover.
Ventilation with ignition on
function
With the ignition on, you can use the
ventilation system and have access to the Air
conditioning menu to adjust the air flow and
air distribution in the passenger compartment.
This function is available for a few minutes,
depending on the state of charge of the battery
of your vehicle.
This function does not activate the air
conditioning.
You can make use of the residual heat in the
engine to warm the passenger compartment
using the temperature setting buttons.
3
Ease of use and comfort
Page 114 of 527

112
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
To remove the mat on the driver's side:
F m ove the seat as far back as possible,
F
u
nclip the fixings,
F
r
emove the mat.
Mats
When fitting the mat for the first time, on the
driver's side use only the fixings provided in the
wallet attached.
The other mats are simply placed on the
carpet. To avoid any risk of jamming of the
pedals:
-
o
nly use mats which are suited to
the fixings already present in the
vehicle; these fixings must be used,
-
n
ever fit one mat on top of another.
The use of mats not approved by
CITROËN may inter fere with access to
the pedals and hinder the operation of
the cruise control / speed limiter.
The mats approved by CITROËN have
two fixings located below the seat.
To refit the mat on the driver's side:
F
p
osition the mat correctly,
F
r
efit the fixings by pressing,
F
c
heck that the mat is secured correctly.
Fitting
Removal
Refitting
Storage boxes
F Raise the grip and lower the storage box
c ove r.
Opening
Do not place heavy objects in the
boxes.
Depending on equipment, storage boxes are
located under the front seats.
Ease of use and comfort
Page 115 of 527
113
C4-Picasso-II_en_Chap03_ergonomie-confort_ed02-2016
Storage below
the steering wheel
This storage compartment below the steering
wheel is intended for stowing your vehicle's
handbook pack.
Rear fittings
Aircraft-style rear tables
These tables, fitted to the backs of the front
seats, incorporate a cup-holder recess A and a
retaining strap B .
F
P
ull the table downwards to open.
F
T
o stow the table, raise it until the latch
locks.
For safety reasons, these tables collapse
downwards if excessive pressure is exerted on
them. Reading lamps C may be fitted in the front seat
backrests, behind the tables. They illuminate
the sur face of the tables without disturbing the
other passengers.
They can be used only while the table is down.
F
P
ress the "
On/Of
f " button to turn the lamp
on or off.
Individual reading lamps
Rear table stowed
Rear table opened
3
Ease of use and comfort