Page 163 of 306

161
Changing a bulb
The headlamps have polycarbonate
lenses with a protective coating:
F
d
o not clean them using a dr y or
abrasive cloth, nor with a detergent
or solvent product,
F
u
se a sponge and soapy water or a
pH neutral product,
F
w
hen using a high pressure washer
on persistent marks, do not keep the
lance directed towards the lamps or
their edges for too long, so as not to
damage their protective coating and
seals.
Changing a bulb should only be done after
the headlamp has been switched off for
several minutes (risk of serious burns).
F
D
o not touch the bulb directly with
your fingers, use a lint-free cloth.
It is essential only to use anti-ultraviolet
(UV) type bulbs, so as not to damage the
headlamp.
Always replace a failed bulb with a new
bulb with the same type and specification. In some climate conditions (low
temperature, humidity), the presence
of mist on the internal sur face of the
headlamp and rear lamp glass is normal;
this disappears a few minutes after the
lights are switched on.Front lamps
Halogen headlamps
1
Direction indicators (PY21W).
2 Main beam headlamps (H1).
3 Dipped beam headlamps (H7LL).
4 Side lamps (W5W).
Halogen lamps with daytime
running lamps and fog lamps
1 Direction indicators (PY21W).
2 Main beam headlamps (H1).
3 Dipped beam headlamps (H7LL).
4 Daytime running lamps / Sidelamps (LEDs).
5 Fog lamps (H11).
Light-emitting diodes (LEDs)
For the replacement of this type of lamp,
go to a
CITROËN dealer or a qualified
workshop.
8
In the event of a breakdown
Page 166 of 306
164
F Press the locking clip and disconnected the connector.
F
T
urn the bulb holder a quarter turn anti-
clockwise.
F
R
emove the bulb holder.
F
R
emove the bulb and replace it.
For reassembly, carry out these operations in
reverse order. If you experience any difficulty in replacing
bulbs, contact your
CITROËN dealer or a
qualified workshop.
Direction indicator side repeaters
F Insert a screwdriver towards the centre of the flasher between the flasher and the
base on the body.
F
L
ever with the screwdriver to extract the
repeater and pull it out.
F
D
isconnect the wiring from the repeater.
F
R
eplace the module.
For reassembly, carry out these operations in
reverse order.
Contact a
CITROËN dealer or a qualified
workshop to obtain the module.
In the event of a breakdown
Page 168 of 306
166
Third brake lamp
You must access the box located on the rear
shelf from the rear seats:
F
P
ull the housing cover towards you and up
to disengage it.
F
D
isconnect the lamp connector. F
U
nclip the bulb holder by lifting the two lugs
and remove it.
F
R
eplace the faulty bulb.
For reassembly, carry out these operations in
reverse order.
Check that the housing cover is positioned
correctly on its support before clipping it
on.
Licence plate lamps
(W5W)
F Insert a thin screwdriver into one of the exterior holes of the transparent lens.
F
P
ush it outwards to unclip it and remove it.
F
R
emove the defective bulb and replace it.
For reassembly, carry out these operations in
reverse order.
(W5W)
In the event of a breakdown
Page 179 of 306

177
Towing the vehicle
Procedure for having your vehicle towed.
Access to the tools
The towing eye is installed in the boot under
t h e f l o o r.
To gain access to it:
F
O
pen the boot.
F
L
ift the floor and remove it.
F
R
emove the towing eye from the holder. General recommendations
Observe the legislation in force in your
c o unt r y.
Ensure that the weight of the towing vehicle
is higher than that of the towed vehicle.
The driver must remain at the wheel of the
towed vehicle and must have a valid driving
licence.
When towing a vehicle with all four wheels
on the ground, always use an approved
towing arm; rope and straps are prohibited.
The towing vehicle must move off gently.
When the vehicle is towed with its engine
off, there is no more braking and steering
assistance.
In the following cases, you must always call
on a professional recovery service:
-
v
ehicle broken down on a motor way or
fast road,
-
f
our-wheel drive vehicle,
-
w
hen it is not possible to put the gearbox
into neutral, unlock the steering, or
release the parking brake,
-
t
owing with only two wheels on the
ground,
- w here there is no approved towing arm
available...
8
In the event of a breakdown
Page 180 of 306
178
Towing your vehicle
F On the front bumper, unclip the cover by pressing on its left side.
F
S
crew the towing eye completely.
F
I
nstall the towing bar. With a manual transmission: move the
gear lever into neutral.
With an automatic or electronic gearbox,
place the gear selector into position N
.
Failure to observe this instruction could
result in damage to certain components
(braking, transmission...) and the absence
of braking assistance the next time the
engine is started.
F
U
nlock the steering by turning the ignition
key one notch and release the parking
brake.
F
S
witch on the hazard warning lamp on both
vehicles.
F
S
et off gently, drive slowly and for a short
distance.
Towing another vehicle
This towing is strictly prohibited (risk of
damaging your vehicle).
In the event of a breakdown
Page 181 of 306

179
Engines and
specifications
The engine specifications (displacement, max.
power, max. speed, energy, CO
2 emissions,
etc.) associated with your vehicle are
mentioned in the registration certificate, and in
the commercial documents.
These characteristics correspond to the values
type-approved on a test bed, under conditions
defined in European legislation (Directive
1999/99/EC).
For more information, contact a
CITROËN
dealer or a qualified workshop.
Weights and towed
loads
The weights and towed loads relating to your
vehicle are stated in the registration certificate,
and in the sales documentation.
These values are also shown on the
manufacturer's nameplate or label.
For more information, contact a
CITROËN
dealer or a qualified workshop.
The mass in working order is equal to the
weight when empty + driver (75 kg).
The GTW values and the towable loads
listed are valid for a maximum altitude of
1,000
additional metres.
The weight of the braked trailer can be
increased, within the GTW limit, if the GV W
of the towing vehicle is reduced by an equal
amount.
The recommended nose weight corresponds
to the weight permitted on the tow-bar
(dismantlable with or without a tool).
GV W: Gross vehicle weight, the maximum
authorised vehicle weight.
GT W: Gross train weight High ambient temperatures may result
in a reduction in the per formance of the
vehicle to protect the engine. When the
ambient temperature is above 37°C, limit
the weight towed.
Towing with a towing vehicle which is only
slightly laden may negatively affect its
handling.
Towing a trailer increases the braking
distance.
The speed of a towing vehicle must not
exceed 62 mph (100 km/h) (comply with
the legislation in force in your country).
When the ambient temperature is high,
leaving the engine running for 1 to
2
minutes after stopping the vehicle to
allow it to cool is recommended.
9
Technical data
Page 182 of 306
180
Petrol
EnginesPureTech 82PureTech 82 S&S V T i 115
Gearboxes Manual 5-speed
(BVM5) Electronic (5-speed)
(ETG5) Manual 5-speed
(BVM5) Automatic 6-speed
( E AT 6)
Code EB2 F MAEC5 F
Version variant types: DD... HMZ6HMZ6/PS NFP0
NFP6NFPT
Capacity (cm
3) 1,1 9 91,1 9 9 1,5 87
Max power: EU standard (kW)* 6060 85
Fuel Unleaded 91 RON to
98 RON Unleaded 91 RON to
98 RON Unleaded 91 RON to 98 RON
Braked trailer (within the GTW limit)
on a 10% or 12% gradient 450
500 750
Unbraked trailer 450450 580
Recommended towing bar weight 5555 55
* The maximum power corresponds to the value type approved on a test bed, under conditions defined by European legislation (Directive 1999/99/EC).
Technical data
Page 183 of 306
181
Diesel
EngineHDi 92BlueHDi 100
Gearboxes Manual 5-speed
(BVM5) Manual 5-speed
(BVM5)
Code DV6 DM (euro 4)DV6 DDV6 FD
Version variant types: DD... 9HJC9HP0BHY6
Capacity (cm
3) 1,5 6 01,5 6 0
Max power: EU standard (kW)* 6873
Fuel DieselDiesel
Braked trailer (within the GTW limit)
on a 10% or 12% gradient 750
750
Unbraked trailer 580580
Recommended towing bar weight 5555
*
T
he maximum power corresponds to the value type approved on a engine bench, under conditions defined by European legislation (Directive
1999/99/EC).
9
Technical data