18
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
This locks and unlocks the vehicle's doors, opens and closes the fuel filler
cap, as well as starting and stopping
the
engine.
KEYR EMOTE CONTROL
Unlocking
Locking
Press this button to lock all of your
vehicle's doors.
The
direction indicators flash once.
If one of the doors is open or is not
closed
correctly, the central locking will
not
work.
Deadlocking
A second press on the closed
padlock on the remote control within
five seconds
after locking changes the
locking
to deadlocking.
This
is confirmed by fixed lighting
of the direction indicators for
approximately
two seconds.
Deadlocking
renders the exterior
and interior door opening handles
inoperative:
do not leave anyone inside
the
vehicle when it is deadlocked.
If
deadlocking is activated from inside
the vehicle using the remote control, it
will
change to normal locking when the
vehicle
is started.
Press
this
button
to
unlock
all
of
your
vehicle's
doors.
The
direction
indicators
flash
twice.
Access
22
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
SLIDING SIDE DOORS
From the outside
Pull the handle towards you then
towards the rear and open the side
door guiding the rearward sliding to
beyond the point of resistance to hold
it open.
A mechanical system prevents opening
of the left-hand side door when the fuel
filler
flap is open.
From the inside
Unlock the side door using this handle and open it, guiding the rearward
sliding to the point of resistance. Pass
this
point to hold the door open.
Close the side door using the handle
to start the sliding and pass the point
of
resistance.
Then,
use the shaped
recess at the top of the door pilla
r to
guide
the door until it locks.
Do not use the grab handle to slide the
door.
Good practice
Take care not to block the guide space on the floor to allow the door to slide
correctly
.
If
your vehicle is parked on a slope,
guide
the sliding of the side door. In
fact, the door could open or close more
rapidly due to the slope of the ground
and
could cause injury.
For safety and operation reasons, do
not drive with the sliding side doors
open.
Access
28
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Dials
1. Distance recorder in kilometres / miles.
2.
Display
screen.
3.
Fuel gauge, coolant temperature
gauge.
4.
Rev
counter.
5.
T
rip distance recorder / service
indicator
reset.
6.
Instrument
panel lighting dimmer.Level 1
INSTRUMENT PANELDisplay screens
Screens
The format of the information
presented in the screen depends on
the
vehicle's equipment level.
Level 2
with the touch screen tablet
34
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp isindicatesSolution - action
Front / lateral
airbag flashing
or
remaining
on.a
failure of an airbag.Have
the system checked by a CITROËN dealer
or
a qualified workshop without delay.
Chapter
5, "Airbags" section.
Front
passenger's
airbag
deactivated on. the intentional deactivation
of this airbag in the
presence of a rearward
facing
child seat.Chapter
5, "Airbags" or "child safety" section.
Low fuel
level on with gauge
needle in the
red
zone.When
it first comes on,
there remains around
8 litres
of fuel in the tank.
The distance you can drive
on this fuel depends on
your style of driving and the
engine
type.You
must fill up with fuel to avoid running out.
This warning lamp comes on each time you
switch
on the ignition until you have filled up.
Capacity
of the tank: approximately 60 litres (or
55
litres according to version).
Never
risk driving until the tank is empty, this
could
damage the emissions and injection
systems.
flashing. cutting of
f of the fuel supply
following
a serious impact.Restore
the supply.
Chapter
7, "Fuel" section.
EOBD
emission
control
system flashing
or
remaining
on.a
failure of the system.There
is a risk of damage to the catalytic
converter
. Have it checked by a CITROËN
dealer
or a qualified workshop.
Battery
charge on.
a fault in the charging
circuit. Check
the battery terminals, …
Chapter
8, "Battery" section.
flashing. placing of the active
functions on standby
(economy
mode).Chapter
8, "Battery" section.
remaining on,
in spite of the
checks. an
ignition or injection
malfunction.Have
it checked by a CITROËN dealer or a
qualified
workshop.
+
ABS
35
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp isindicatesSolution - action
Power
steering on. a fault with the
system.
The vehicle
retains conventional steering without assistance. Have
it checked by a CITROËN dealer or a qualified workshop.
Door open
detectionon and accompanied
by a message in the
screen. that a door is not
closed
correctly.Check
that all of the doors are closed.
ABS remaining
on.a fault with the anti-
lock
braking system.The
vehicle retains conventional braking.
Have
it checked by a CITROËN dealer or a
qualified
workshop.
ESC flashing.
triggering of the ASR
or
DSC regulation.The system optimises traction and improves the
directional
stability of the vehicle.
Chapter
5, "Driving safety" section.
remaining
on.a fault with the
system.
E.g.:
under-inflation
of
the tyres.E.g.:
check the pressure of the tyres.
Have
it checked by a CITROËN dealer or a
qualified
workshop. (Wheel speed sensor,
hydraulic
valve block, ...).
Under-
inflation on.
the tyre pressure is
too low in or more
wheels.Check
the tyre pressure as soon as possible.
This
check must be done with the tyres cold.
flashing
then
remaining on,
accompanied by the
Service warning
lamp, and depending
on equipment, the
display
of a message.the tyre pressure
monitoring system
has a fault or one of
the wheels does not
have
a sensor.Detection
of under-inflation is no longer assured.
Have
it checked by a CITROËN dealer or a
qualified
workshop.
Particle filter on. a problem with the
particle
filter (fuel
additive
level, risk of
blockage, ...).Have
the filter checked by a CITROËN dealer or
a
qualified workshop.
Chapter
7, "Levels" section.
READY TO GO
3
37
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Warning lamp
in the screenis
indicates Solution - action
Cruise
control on.
cruise
control selected.Manual
selection.
Chapter
4, "Steering mounted controls" section.
Speed limiter on.speed
limiter selected.Manual
selection.
Chapter
4, "Steering mounted controls" section.
Gear shift
indicator on.a recommendation
independent of the type and
density
of traffic.To reduce fuel consumption, change to an
appropriate
gear with a manual gearbox.
The driver retains responsibility to follow this
indication
or not.
Diesel
pre-heating on.climatic conditions requiring
pre-heating. Wait until the warning lamp goes off before
operating
the starter.
Presence of
water in the
Diesel filter
on and
accompanied by
a message in
the
screen.
water in the Diesel filter. Have the filter bled by a CITROËN dealer or a qualified
workshop without delay.
Chapter 7, "Checks" section.
According
to country.
Service
spanner on.that a service will be due
shortly. Refer
to the list of checks in the maintenance and
warranty
guide.
Have the service carried out by a CITROËN
dealer
or a qualified workshop.
Time flashing. adjustment
of the time.Use
the left-hand button on the instrument panel.
Chapter
3, "Instruments and controls" section.
READY TO GO
3
40
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
FUEL GAUGEC OOLANT TEMPERATURE
The needle is positioned before the
red zone:
normal operation.
In arduous conditions of use or hot
climatic conditions, the needle may
move
close to the red graduations.What you should do if the needle
enters the red zone:
Reduce your speed or let the engine
run
at idle.
What you should do if the warning
lamp comes on:
-
stop immediately
, switch off the
ignition.
The
fan may continue to
operate for a certain time, up to
approximately 10 minutes,
-
wait for the engine to cool down in
order
to check the coolant level and
top
it up if necessary.
As the cooling system is pressurised,
follow the procedure below to avoid the
risk of scalding:
-
wait at least one hour after
switching of
f the engine before
carrying out any work,
-
unscrew
the cap by 1/4 turn to
allow the pressure to drop,
-
when the pressure has dropped,
check
the level in the header tank,
- if necessary , remove the cap to
top up.
If the needle remains in the red
zone,
have the system checked by
a
CITROËN dealer or a qualified
workshop.Refer
to chapter 7, "Levels"
section.
Refer
to
chapter
7,
"Fuel"
section.
The fuel level is tested each time the
key
is
turned
to
the
"running"
position.
The
gauge
is
positioned
on:
-
1:
the
fuel
tank
is
full,
approximately
60
litres.
-
0:
the reserve is now being used,
the warning lamp comes on
continuously.
The
reserve
when
the
warning
first
comes
on
is
approximately
8
litres.
41
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
Instruments and controls
Berlingo2VP_en_Chap03_Pret-a-partir_ed02-2016
EMISSIONS CONTROLS
EOBD (European On Board
Diagnosis) is a diagnostics
system which complies with,
among others, the standards
on emissions limits of:
-
CO (carbon monoxide),
-
HC (unburnt hydrocarbons),
-
NOx (nitrogen oxides), detected
by oxygen sensors placed
downstream of the catalytic
converters,
-
particles.
UNDER-INFLATION DETECTION
This system
continuously monitors
the pressures of the four
tyres, as soon as the
vehicle is moving.
A pressure sensor is located in the
valve of each tyre (except the spare
wheel).
The system triggers an alert if a drop
in pressure is detected in one or more
tyres.
The
tyre
under-inflation detection
system is an aid to driving which
does not replace the need for
vigilance
on the part of the driver.
The driver is warned of any
malfunction of this emissions
control system by the illumination
of this warning lamp in the instrument
panel.
If this warning lamp comes on, have
it
checked
by
a
CITROËN
dealer
or
a
qualified
workshop. This system does not avoid the
need
to check the tyre pressures
regularly (including the spare
wheel)
and before a long journey.
Driving
with under-inflated tyres
adversely af
fects road holding,
extends
braking distances and causes
premature tyre wear
, particularly under
arduous conditions (vehicle loaded,
high
speed, long journey).
Driving
with under-inflated tyres
increases
fuel consumption.
The tyre pressures for your vehicle
can be found on the tyre pressure
label.
Refer
to chapter 9, "Identification
markings"
section.
The
tyre pressures must be checked
when the tyres cold (vehicle stopped
for 1 hour or after driving for less then
6
miles (10 km) at moderate speed).
Otherwise,
add 0.3 bar to the values
indicated
on the label.
READY TO GO
3