Instruments  and  indicator  lights 
The number  of  keys programmed  to  the vehicle  is 
also displayed.  The display 
L2 3/3 in dicates  that 
three  keys have been  programmed.  This a llows 
you to  make  sure you  have  received all  of  the  keys 
when  you  purchase  a used vehicle. 
For  examp le, if  you on ly receive two  keys, you 
should  take  those  keys to  your  authorized  Audi 
dealer  to  have the  missing  key deactivated  so  it 
cannot  be used. You should  also  report the  miss
ing  key  to your  insurance  company . 
Calling  up the  driver information 
A yellow  or red symbol  appears  in the  instrument 
cluster  display,  usually with  a driver  message. 
The driver  message display  disappears  after  about  5 seconds. The dr iver message can be dis
played  again  by briefly pressing the 
ISETI button. 
Setting  the  speed warning 
By pressing  the !SET ! button  briefly,  you  can set 
thresho ld 
1 of  the  speed warning  while  you are 
driving 
c::;,page  92. By maintaining  pressure  on 
the 
! SET I button,  you  delete the  warning  thresh
old. 
Digital  clock with  date  display 
Depending  on the  vehicle  equipment level,  you 
may choose  between  the  quartz  clock  or  the 
GPS 
controlled  clock* l!j in the  radio  or  in the  MMI* . 
You  can learn  more  about this in  the  MMI manual 
or  in the  radio user's  manual. 
(Di Tips 
-When  you sw itch off  the ignition  or  open 
the  driver  door,  the  time, date,  odometer 
and  temperature  are  displayed for  an addi
tiona l 
30 seconds. 
- You can  also call up the  display  with  the 
ISET I button c::;, page  9 while  the  ignition is 
switched 
off. 
Fuel gauge 
The fuel  gauge works  only  when  the  ignition  is 
on. 
When  the  needle  reaches the  reserve mark,  the 
c::;, page  30 Ii') symbol  appears  in the  instru-
10 
ment  cluster  display  as  well  as the message 
Please  refuel. This message  is meant  to  remind 
you  to 
refuel. 
The total  tank  capacity  of  your  ve hicle is  listed  in 
¢ page  273. 
(D Note 
Never run the  tank  completely dry! An  ir regu
lar  supply  of  fuel  can cause  engine misfiring 
and  fuel could  enter  into  the exhaust  system. 
The  catalytic  converter  could then  overheat 
and  be damaged. 
Odometer 
The odometer  indicates  the  distance  driven. 
Fig.  5 Instrument  cluster:  odometer 
Fig.  6 Instrument  cluster: reset  button 
The display  of  distance driven  is shown  in  kilome
ters  "km"  or in "m iles". 
- USA models  -Miles 
- Canada models  - Kilometers 
Yo u can  switch  from  kilometers  to miles  or vise 
versa in the  radio  o r in the  MMI*.  You can lea rn 
more  about  this  in  the  MMI  manual  or  in the  ra
dio  user's  man ual.  
         
        
        a, 
a, 
..... N ,-... N ..... 0 0 
0: 
co 
@ Tips 
The  Energy  flow  display  will not  shown  in the 
MMI display  when  the  reverse  gear  is  engag
ed,  due  to  safety  reasons . 
Consumption  display 
Applies  to:  vehicles with  hybrid drive 
Fig . 1 20 MMI  displa y:  co nsump tio n  dis play 
T he  consumption  d isplay  shows  the  average  en 
ergy  consumption  and  the  rec uperation  quantity 
i n 5  minute  interva ls . 
Calling  up the  consumption  display 
...  Select : I MENU I function  button> Hybrid control 
button . 
...  Turn  the  cont rol  knob  co unter -clockwise. 
Resetting  the  consumption  displ ay 
...  Se lect : I MENU I function  button > Hybrid cont rol 
button  . 
...  Turn  the  control  knob  to 
Reset consumpt ion 
stat ist ics . 
The  orange  bars  show  the  average  consumption 
and  the  green  bars  show  the  recuperation  quanti
ty . Each  bar  represents  a  measured 
5 minute  in
terval.  The  display  covers  a 
60 m inute  time  peri 
od . 
The  bar  w ith  the  wh ite  border  on  the  outer  right 
shows  the  current  average  consumption  or  the 
cur rent  recupe ration  q uantity.  After  5  minutes, 
this  bar  trave ls  a step  to  the  left  and  a  new  bar 
a p pears  in the  outer  right . 
The filled  bars  show  the  values  for  the  curren t 
drive  cycle . Once  the  ignition  is  sw itched  off  and 
on  aga in,  all  of  the  prev ious  bars  are  display ed  as 
H ybrid 
not  fi lled  and  new  fi lled  bars  a ppear  on  the  right. 
T his  is so  t hat  the  values  from  the  previous  t rips 
and  the  current  trip  can  be compared  v isua lly. 
Vehicle  tool  kit  and tire  repair  set 
Applies  to:  vehicles with  hybrid drive 
Fig.  121 L uggage compar tm ent:  ve hicle too l bag an d tir e 
r epa ir set 
The veh icle  tool  k it  is fou nd  u nder  a  cover  in the 
cargo  floor 
c::> fig. 121 @ . The ti re  repa ir set  (T ire 
Mobility  System)  is fo und  in the  storage  com
partmen t  in the  r ight  side  trim  p anel @. 
Additional  informat ion  about  t he vehicle  too l kit 
may  be  found  under 
c::> page 250 and  about  the 
t ir e  repa ir set  un der 
c::> page 253  . 
@ Tips 
The  right  sto rage  compartment  in t he  lug
gage  compartment  and  its  co nte nts  must  al
w ays  be  kept  in  the  vehicle.  The vehicle  must 
not  be  o per ate d w it h ou t the  tire  repair  set. 
Charging  the  batteries 
Applies  to:  vehicles with hybrid  drive 
The  vehicle  is eq uip ped  w it h t wo 12 volt  ba tteries 
and  a  high  vo ltage  battery . 
If the 12 vo lt  batte ries  are  dead,  they  may  be 
ch arged  wi th  a charger  or  the  vehicle  may  be 
j u mp  s tarted  wi th  assis tan ce  from  ano ther  veh i
cl e  in the  same  way  as  a  conventional  vehicle. 
T he  same  app lies  to  the  hig h vol tag e batte ry  if  it 
is d isch arged.  However,  in  this  ca se,  the ch ar gin g 
proces s  is  ac compa nied  wi th  messages  in t he  in 
strument  cl uster  d is p lay . T he  ignition  mus t be 
switched  on  and  a ll unnecessary  e lectric  compo-
nents  must  be  turned  off . "" 
107