2017 AUDI A8 wiper fluid

Cockpit over view
light also turns on. Make sure t hat the speed
does not go above the speed displayed. Drive to
an author ized Audi dealer or authorized A udi
Serv ice Facility immediately to have the malfunc­
tion corrected .
_,.,. Engine oil sensor
• Oil l eve l! Se nsor def ectiv e
The sensor to check the engine oil leve l has
fa iled. Drive to an authori zed Aud i dea ler or au­
thor ized Audi Service Facility immediate ly to have
the malfunction corrected .
r Engine warm-up request
n Plea se warm up eng ine
F uel has entered the engine oil, either from low
outside temperatures or frequent short drives .
Drive unt il the engine is warm so that the fuel in
the eng ine oi l will evaporate . Avo id high engine
speeds, full acce le rating and heavy eng ine loads
when doing this.
Bil Tank system
liD Plea se refuel
If the indicator lig ht t urns on for the fi rst time
and the mess age appears, there are abo ut 4 gal ­
lons (15 lite rs) of fue l le ft in the tank.
II] Fuel tank s ystem malfunction! Pl ea se con­
tact dealer
There is a malfunction in the fue l tank system .
Drive to an authorized Audi dea ler or authorized
Aud i Serv ice Facility immediately to have the
malfunct ion corrected.
(D Tips
More information on ref ue ling is avai lab le on
page
c:> page 268.
~ Washer fluid level
C Please refill washer flu id
24
Fill the washer fluid fo r the windshie ld washer
system and the headlight washer system when
the ignit ion is switched off
c:> page 281 .
• Windshield wipers
m Windshield wiper defecti ve
There is a ma lf u nction with the winds hield wip­
ers .
D rive to an authori zed A udi dealer or au tho riz ed
Audi Se rvice Facility immediate ly to have the
malfunction corrected.
~ /0~ Bulb failure indicator
If the S:i indicator light turns on, a bulb has
failed . The message indicates the location of the
bulb.
If the
II indicator light also t urns on, then a rear
fog light has failed. The position of the indicator
li ght corresponds with the location on the vehi­
cle.
Vehicle light s: system fault!
There is a m alfu n ction in the headlights o r the
li ght sw itch .
D rive to an author ized A udi dealer or authorized
Audi Se rvice Fac ility immediate ly to have the
malfunction correc ted .
_& WARNING
-Light bulbs a re under pressure and can ex­
plode when b ulbs are replaced, whic h in­
creases the risk of inj ury.
- With H ID headlights * (xenon -plus head ­
lights), the high-vo ltage component must
be handled correct ly . Otherwise, there is a
risk of fatal in jury.
~(i) Headlight range control system
II He adlight ra nge cont rol system: system
f a ult!
There is a ma lfunction in the headlight range
contro l system, which may cause glare for other
drivers.
-

0 co .... N ,..... N .... 0 0 :c ' reactivated the next time you switch the ignition
on.
C leaning the headlights. The headlight washer
system operates only when the low beam head­ lights are switched on.
If you move the lever to
position @, the headlights and the night vision
assist camera* are cleaned at intervals.
A WARNING
- The rain sensor is only intended to assist the
driver. The driver may still be responsible
for manually sw itching the wipers on based
on v is ibility conditions .
- The w indshield may not be treated with wa­
ter-repelling windsh ield coating agents . Un­
favorable conditions, such as wetness, dark­ ness, and when the sun is low, can cause in­
creased g lare, which increases the risk of an
acc ident. W iper blade chatter is a lso poss i­
ble.
- Prope rly f unction ing windsh ield wiper
blades are required fo r a clear view and safe
driving
c:> page 51, Replacing the wiper
blades.
(D Note
- If there is frost, make su re t he windshie ld
wiper blades are not fro zen to the wind­
shield. Sw itching on the windshield wipers
when the blades are frozen to the wind­
shield can damage the wiper blades.
- Prior to using a car wash, the windshield
wiper system must be switched
off (lever in
pos ition
@ ). This prevents the wipers from
switching on un intent ionally and causing
damage to the w indshield w iper system .
- The windshield wipers switch
off when the
i gnition is sw itched off. You can activate the
windsh ield wipers after the ign it ion is
switched back on by moving the winds hield
wiper lever to any posit ion.
- Worn o r dirty windshield wiper blades result
i n streak ing . This can affect the ra in sensor
funct ion. Check you r windshield wiper
blades regu larly.
Light s and Vision
-The washer fluid nozz les for the windshield
washer system are heated at low tempera­
t u res when the ign ition is on .
- When stopping tempo rari ly, such as at a
traffic light, the speed of the windshield
w ipers automatically reduces by one level.
Cleaning the wiper blades
Clean the wiper b lades when you see w iper
streaks . Clean the wiper blades with a soft towel
and glass cleane r.
.. Place the windshie ld w iper arms in the service
position
c:> page 51.
.. Fold the windshield w iper arms away from the
w indshield .
A WARNING
Dirty windshie ld wiper b lades can impa ir vi­
sion, wh ich increases the ris k of an acciden t.
Replacing the wiper blades
The service position is set in the Infotainment
system .
Fig. 57 Removing winds hield wiper b lades
Wind shi eld wiper se rvice po sition /b lade
r epl ace ment po sit ion
~
~
M 0 :i: ... m
.. Switch the ignition off and move the windshield
w iper lever to position @briefly
c::> page 50,
fig. 56. The windshield wipers move into the
serv ice position .
.. To br ing the wiper b lades back into the original
position, switch the ignition on and ope rate the
w indshield w iper lever.
You can also turn the service posit io n on or off in
the Infotainment system: ..,_
51

Intelligent Technology
Brakes
New brake p ads
New b rake pads do no t achieve the ir full b raking
effect during the firs t 250 mi (400 km) . They
m ust be "broken in" first . The b reak -in period can
be considerably longe r for vehicles with ceram ic
brake rotors* . However, you can compensate for
the slightly reduced braking force by pressing
firm ly on the brake pedal. Avo id heavy braking
during the break-in period .
Wear
Brake pad wear depends largely on the way the
veh icle is driven and on operat ing cond itions.
This is especially true if you are driving frequently
in the c ity and on curves or with a sporty driving
style .
Operating noise
Noises may occur when braking depend ing on the
speed, braking force and outs ide cond itions such
as temperature and humidity.
Noises may become more appare nt at lowe r
speeds due to the nature of the materia ls in the
ceramic brake rotors*.
Effect of water and road salt
I n cer tain s ituations, for example a fter driving
through water, in heavy rain, afte r ove rnig ht con ­
densation or after washing your car, the braking
effect can be red uced by moisture or ice on the
brake rotors and b rake pads . The brakes must be
"dr ied" first w ith a few care ful b rake applica­
tions .
At higher speeds and with the windshie ld wipers
turned on, the brake pads press aga inst the brake
rotors for a short amount of time. T his action,
which is no t felt by the driver, happens at regular
i n tervals a nd ensu res a better react ion time for
the bra kes in wet weather.
The braking effect can also be reduced if you are
driving on salted roads a nd you do not apply the
brakes fo r long pe riods of time. The laye r of salt
o n th e brake roto rs and pads mus t be wo rn off
fi rs t when the brakes are app lied.
128
D ue to its s urface, the ce ram ic brake rotor * ab ­
sorbs moisture in ce rtain situations. The refore,
there will tempora rily be less brak ing fo rce than
whe n the brakes are d ry . You can compensate for
th is by press ing the brake pedal harder.
Corrosion
Leav ing the ve hicl e pa rked for long periods of
time , low mileage and avoiding heavy b raking
can contrib ute to corros ion on the b rake roto rs
and to dirty brake pads.
If you usua lly avoid heavy bra king or if there is
cor rosion p resent, occasiona l heavy brak ing at
high speeds is recommended to clean the brake
rotors and pads
c> ,& .
Brake system malfunction
if you no tic e th at the b rake peda l t ravel has sud­
denly
increase d, then a bra ke circuit in the dua l­
c ir cuit b rake system may have malfunctioned.
D rive to an authorized A udi dealer or authorized
Audi Service Facility immed iate ly to have the
problem corrected . On the way there, drive w ith
reduced sp eed and keep in m ind that you wilt
need a longe r distance to stop and you will need
to press the b rake peda l ha rder.
Low b rake fluid level
When the brake fluid level is low, malfunctions in
the b rake system may occur . The brake fl uid level
i s e lec tronically moni to red.
Brake booster
The brake booster amp lifies the pressure you ap­
ply to the brake pedal. It only wor ks when the en­
gine is running.
A WARNING
- On ly app ly the brakes for the purpose of
cleani ng the bra ke sys tem w hen road and
t raffic cond itions permit. You must not en­
da nger ot her roa d users . T h is i ncreases the
r isk of an acci den t.
-
- Never le t th e ve hicle roll while t he engi ne is
stop ped bec ause this increa ses the r is k of an
a cciden t. ..,.