THE FIAT CODE SYSTEM
This is an electronic engine locking system which
increases protection against attempted thefts of the car.
It is automatically activated when the ignition key is
removed.
An electronic device is fitted in each ignition key grip.
The device transmits a radio-frequency signal when the
engine is started through a special aerial built into the
ignition switch. The modulated signal, which changes
each time the engine is started, is the “password”, by
means of which the control unit recognises the key and
enables to start the engine.
OPERATION
Each time the vehicle is started by turning the ignition
key to MAR, the Fiat CODE system control unit sends
a recognition code to the engine control unit to
deactivate the immobiliser.
The acknowledgement code is sent only if the Fiat
CODE system control unit has recognised the code
transmitted from the key.
Each time the ignition key is turned to STOP, the Fiat
CODE system deactivates the functions of the engine
management control unit.
If the code is not recognised correctly during ignition,
the
Ywarning light comes on in the instrument panel.
SYMBOLS
Special coloured labels have been attached near or
actually on some of the components of your car. These
labels bear symbols that remind you of the precautions
to be taken as regards that particular component.
The plate summarising the symbols used can be found
under the bonnet, fig. 2.
F0U003Abfig. 2
CONTENTS TECHNICAL
SPECIFICATIONS
MAINTENANCE
AND CARE
IN AN
EMERGENCY WARNING LIGHTS
AND MESSAGESSTARTING
AND DRIVINGSAFETY
KNOWING
YOUR VEHICLE
4
001-028 PUNTO Abarth GB 1ed 17-07-2012 12:04 Pagina 4
81
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
fig. 83
BONNET
OPENING
Proceed as follows:
❒pull the lever fig. 83 in the direction of the arrow;
❒pull the lever A-fig. 84 as shown in the figure;
❒lift the bonnet and, at the same time, release the
bonnet support rod from its locking device D-fig. 85;
then insert the end of the bonnet support rod C-
fig. 86 into the hole E.
IMPORTANT Before opening the bonnet, check that
windscreen wiper arms are not lifted from the
windscreen.
fig. 84
CLOSURE
Proceed as follows:
❒hold the bonnet up with one hand and with the
other remove the rod C-fig. 86 from the hole E and
fit it back into its catch D-fig. 85;
❒lower the bonnet to approximately 20 centimetres
from the engine compartment, then let it drop. Make
sure that the bonnet is completely closed and not
fastened only by the safety catch. If it is not perfectly
closed, do not try to press the bonnet lid down but
open it and repeat the procedure.
IMPORTANT Always check that the bonnet is closed
properly to prevent it from opening while the car is
travelling.
069-108 PUNTO Abarth GB 1ed 17-07-2012 12:07 Pagina 81
82
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
fig. 85
The bonnet must always be perfectly
closed while travelling for safety reasons.
Make sure that the bonnet is properly closed
and that the lock is engaged. If you notice
whilst driving that the lock is not perfectly
engaged, stop at once and close the bonnet
properly.
WARNING
Positioning the support rod incorrectly
could cause the bonnet to fall suddenly.
WARNING
fig. 86
Perform these operations only when the
car is stationary.
WARNING
069-108 PUNTO Abarth GB 1ed 17-07-2012 12:07 Pagina 82
103
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
fig. 102
IMPORTANT NOTES
Before opening the bonnet, make sure
that the car is switched off and the key
is in the OFF position. Follow the instructions on
the plate near the front crossmember fig. 102. It
is advisable to extract the key when there are
other people in the car. The car should always
be left after the key has been removed or
turned to the OFF position. When refuelling,
make sure that the car is switched off with the
key in the OFF position.
WARNING
“e-GSI” SYSTEM
(GEAR SHIFT INDICATOR)
(for versions/markets where provided)
The “e-GSI” system (Gear Shift Indicator) advises the
driver to change gear via a signal on the instrument
panel (see
fig. 103).
Through the “e-GSI” system, the driver is informed that
the gear change will allow a reduction in fuel
consumption. Therefore, for driving oriented towards
cutting fuel consumption, it is advisable to follow the
suggestions of the “e-GSI” system, where the traffic
conditions allow it.
fig. 103
069-108 PUNTO Abarth GB 1ed 17-07-2012 12:08 Pagina 103
186
HEAVY USAGE OF THE CAR
Should the car be used predominantly in one of the
following particularly demanding conditions:
❒dusty roads;
❒short distances (less than 7-8 km) and with external
temperatures below zero;
❒frequently idling engine or long distance low speed
driving (e. g. taxis or door-to-door deliveries) or in
the case of long term inactivity;
❒in cities;
perform the following inspections more frequently than
shown on the Scheduled Servicing Plan:
❒check front disc brake pad conditions and wear;
❒check cleanliness of bonnet and boot locks and
linkage cleanliness and lubrication;
❒visually inspect the conditions of: engine, gearbox,
transmission, pipes and hoses (exhaust – fuel
– brakes), rubber parts (boots, sleeves, bushes, etc.);
❒check battery charge and liquid level (electrolyte);
❒visually inspect condition of accessory drive belts;
❒check pollen filter and replace it, if required;
❒check air filter and replace, if required.
PERIODIC CHECKS
Every 1,000 km or before long journeys, check and, if
necessary, top up the following:
❒engine coolant fluid level;
❒brake fluid level;
❒windscreen washer fluid level;
❒tyre pressure and conditions;
❒operation of lighting system (headlights, direction
indicators, hazard lights, etc.);
❒operation of the windscreen wiper/washer system,
position and wear of the windscreen and rear
window wiper blades.
Every 3,000 km check and top up if required: engine oil
level.
It is advisable to use PETRONAS LUBRICANTS products,
designed and produced specifically for Abarth cars (see
table “Capacities” in section “Technical Specifications”).
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
183-204 PUNTO Abarth GB 1ed 17-07-2012 15:17 Pagina 186
201
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Detergents pollute the environment. The
vehicle should be washed in areas
equipped for collecting and cleaning the
liquid used in the washing process.
ADVICE FOR PRESERVING THE BODYWORK
Paint
Paintwork does not only serve an aesthetic purpose, but
also protects the underlying sheet metal.
Touch up abrasions and scratches immediately to
prevent rust formation. Use only original paint products
for touch-ups (see “Bodywork paint identification plate”
in the “Technical specifications” section).
Normal maintenance of paintwork consists in washing
the car: the frequency depends on the conditions and
environment where the car is used. For example, in
highly polluted areas, or if the roads are sprayed with
salt, it is wise to wash the car more frequently.
To correctly wash the vehicle, proceed as follows:
❒remove the aerial from the roof to prevent damage
to it if the car is washed in an automatic system;
❒rif high pressure water jets are used to wash the car,
make sure they are at least 40 cm away from the
bodywork to avoid causing damage. It should be
remembered that a build up of water could cause
damage, in the long term, to the car; dy using a low
pressure jet of water;
❒wipe a sponge with a slightly soapy solution over the
bodywork, frequently rinsing with the sponge;
❒rinse well with water and dry with a jet of air or a
chamois leather.Dry the less visible parts, such as the door frames,
bonnet and the headlight frames with special care, as in
these areas water may stagnate more easily. The car
should not be taken to a closed area immediately, but
left outside so that residual water can evaporate.
Do not wash the car after it has been left in the sun or
with the bonnet hot: this may alter the shine of the
paintwork. Exterior plastic parts must be cleaned in the
same way as the rest of the car.
Where possible, do not park under trees; the resinous
substance that many species release give the paint a dull
appearance and increase the possibility of triggering
rusting processes.
IMPORTANT Bird droppings must be washed off
immediately and thoroughly as the acid they contain is
particularly aggressive.
183-204 PUNTO Abarth GB 1ed 17-07-2012 15:17 Pagina 201
259
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
– tips for extending
battery life .................................... 194
Bi-zone automatic climate
control system ............................ 44
Body
– body version codes ................ 207
– cleaning, care and
maintenance ................................ 200
– maintenance ............................. 202
Bodywork codes ........................... 207
Bodywork paint
identification plate ...................... 206
Bodywork versions ...................... 207
Bonnet
– opening/closing ........................ 81
Boot ................................................. 76
– closing the tailgate ................... 77
– expanding the boot ................ 78
– opening the boot in
an emergency .............................. 77
– removing the parcel shelf ...... 80
– tailgate opening ....................... 76
Boot courtesy light ....................... 57
– bulb replacement .................... 169
Boot
– closing the tailgate .................. 77– expanding the boot ................ 78
– opening the tailgate ................ 76
– opening the tailgate in
an emergency .............................. 77
– removing the parcel shelf ...... 80
Brake Assist (system) .................. 87
Brake Assist system ..................... 87
Brake fluid
– checking levels and
topping up .................................... 191
– specifications ............................ 218
Brake lights
– bulb replacement .................... 165
Brakes
– brake fluid (type) .................... 218
– checking levels and
topping up .................................... 191
– handbrake ................................. 134
– technical specifications .......... 209
Bulbs
– bulb types ..........................159-160
– external bulb replacement .... 161
– general information
on replacement ........................... 158ABS ................................................. 85
– Brake Assist ............................. 87
ABS system .................................... 85
– Brake Assist ............................. 87
Accessories purchased by
the owner .................................... 105
Additional brake light
(third brake light)
– bulb replacement .................... 166
Air filter .......................................... 192
Air recirculation ........................43-46
Air vents ......................................... 38
Airbag deactivation ....................... 126
Alarm .............................................. 9
Ashtray ............................................. 65
ASR (system).................................. 89
Battery
– checking the charge and
the electrolyte level ................... 193
– jump starting ............................ 151
– maintenance ............................. 193
– recharging ................................. 177
– replacement ............................. 193
CONTENTS
259-266 PUNTO Abarth GB 1ed 17-07-2012 13:47 Pagina 259
261
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
Engine compartment
– checking levels ......................... 187
– opening/closing the bonnet .... 81
– washing ..................................... 202
Engine coolant
temperature gauge ..................... 15
Engine coolant
– checking levels and
topping up .................................... 189
– specifications ............................ 218
– temperature gauge and
warning light ................................ 15
Engine immobiliser
(Fiat CODE) ................................ 4
Engine marking .............................. 206
Engine oil
– checking levels and
topping up .................................... 188
– consumption ............................ 188
– technical specifications .......... 217
Engine starting ............................... 131
– bump starting ........................... 152
– emergency starting
(of engine) .................................... 151
– how to warm up the engine
after it has just started .............. 132
– ignition switch ......................... 11
– jump starting ............................ 151
– stopping the engine ................ 133Engine
– engine immobiliser
(Fiat CODE) ................................ 4
– how to warm up the engine
after it has just started .............. 132
– identification codes ................ 207
– marking ..................................... 206
– stopping the engine ................ 133
– technical specifications .......... 207
Environment (protection) ........... 108
EOBD (system) ............................. 92
ESP (system) .................................. 88
External lights (switching on) ..... 49
"e-GSI" system
(Gear Shift Indicator) ................ 103
Fiat CODE .................................... 4
Fix&Go Automatic
(rapid tyre repair kit) ................ 152
Flashing (main beams) .................. 50
Fluids (specifications) ......... 217-218
Fluids and lubricants
– refuelling ................................... 216
– specifications ..................217-218
Fog lights
– bulb replacement .................... 164
– Cornering Lights function ..... 51
– switching on ............................. 58 Dipped beam headlights
– bulb replacement .................... 162
– switching on ............................. 49
– switching on ............................. 50
Direction Indicators
– front bulb replacement .......... 163
– rear bulb replacement ........... 165
– side bulb replacement ............ 164
– switching on ............................. 50
Document holder pocket ........... 66
Door pockets ................................ 63
Doors .............................................. 71
– central locking ......................... 71
– Dead Lock ................................ 73
– door unlocking from
the outside ................................... 72
– locking the doors from
the outside ................................... 71
– locking/unlocking from
the inside ...................................... 72
– pockets ..................................... 63
DSS (Driving Sport Switch)
(car dynamic control system) ... 96
Electrical/electronic devices
(important notes for
installation) .................................. 106
Engine codes .................................. 207
259-266 PUNTO Abarth GB 1ed 17-07-2012 13:47 Pagina 261