2017 Abarth Punto light

219
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
8.05.06.1
FUEL CONSUMPTION
The fuel consumption figures given in the table below
are determined on the basis of the type-approval tests
set down by relevant European Directives.
The procedures below are followed for measuring
consumption:
❒urban cycle: cold starting followed by driving that
simulates urban use of the car;
❒extra-urban cycle: drive simulating the driving of the
car out of town with frequent acceleration in all
gears; the speed varies from 0 to 120 km/h;
❒combined consumption: the weighting is around 37%
urban cycle and 63% extra-urban cycle.IMPORTANT The type of route, traffic situations,
weather conditions, driving style, general conditions of
the car, trim level/equipment/accessories, load, climate
control system, roof rack, other situations that affect air
drag may lead to different fuel consumption levels than
those measured.
Fuel consumption according to the current European directive (litres/100 km)
Version Urban Extra-urban Combined
1.4 Turbo Multi Air
205-220 PUNTO Abarth GB 1ed 17-07-2012 13:26 Pagina 219

220
KNOWING
YOUR VEHICLE
SAFETY
STARTING
AND DRIVING
WARNING LIGHTS
AND MESSAGES
IN AN
EMERGENCY
MAINTENANCE
AND CARE
TECHNICAL
SPECIFICATIONS
CONTENTS
142
CO2EMISSIONS
The CO2emission levels given in the following tables refer to combined consumption.
Version CO2emissions according to the current European directive (g/km)
1.4 Turbo Multi Air
205-220 PUNTO Abarth GB 1ed 17-07-2012 13:26 Pagina 220

CDs
The presence of dirt, scratches or distortions on the
CDs may cause skipping while it is playing and poor
sound quality. For optimal playback conditions, follow
these guidelines:
❒only use CDs with the following mark;
RADIO
223
❒clean every CD thoroughly removing any fingermarks
or dust using a soft cloth. Hold CDs by the
circumference and clean them from the centre
towards the edge;
❒never use chemicals (e.g. antistatics or thinners or
sprays) for cleaning as they may damage the surface of
the CDs;
❒after listening place CDs back in their boxes to avoid
them from being damaged;
❒do not expose CDs to direct sunlight, high
temperatures or moisture for long periods;
❒do not stick labels on the CD surface or write on the
recorded surface with pencils or pens.
❒do not use CDs that are very scratched, flawed,
distorted, etc. Using discs like these will result in
malfunctions or damage to the player;
❒The use of original CD media is required for the best
quality audio production. Correct operation is not
guaranteed when CD-R/RW media are used that
were not correctly mastered and/or with a maximum
capacity above 650 Mb;
❒Do not use commercially available protective sheets
for CDs or discs with stabilisers, etc. as they could
get stuck in the internal mechanism and damage the
disc;
❒if a copy-protected CD is used, it may take a few
seconds before the system starts to reproduce it.
The CD player cannot be guaranteed to play all
protected discs. The fact that the CD is protected
from being copied is often shown in very small letters
or is just legible on the CD cover itself where it may,
for example, say “COPY CONTROL”, “COPY
PROTECTED”, “THIS CD CANNOT BE PLAYED
ON A PC/MAC”, or it may be identified through the
use of symbols, such as, for example:
❒The CD player is capable of reading most
compression systems currently in use (e.g.: LAME,
BLADE, XING, FRAUNHOFER) but, following the
development of these systems, the reading of all
compression formats is not guaranteed.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 223

235
RADIO
PRESET/USER*/CLASSIC/ ROCK/JAZZ
functions (equaliser activation/deactivation)
The built-in equaliser can be activated/deactivated. When
the equaliser function is deactivated, the audio settings
can only be changed by adjusting the “Bass” and “Treble”
settings, whereas when the function is on, the acoustic
curves can be adjusted.
To deactivate the equaliser, select the “EQ Preset”
function using the buttons ¯or ˙.
To activate the equaliser, use the buttons ¯or ˙to
select one of the presets:
❒“FM/AM/CD...EQ User” (7 equaliser band preset that
can be changed by the user);
❒“Classic” (equaliser preset for optimal classical music
sound);
❒“Rock” (equaliser preset for optimal rock and pop
music sound);
❒“Jazz” (equaliser preset for optimal jazz music sound);
When one of the equaliser adjustments is activated the
text “EQ” lights up.*USER EQ SETTINGS function
(equaliser settings only if the USER setting has
been selected)
To set a customized equaliser adjustment, set the user
using either the ▲or ▼button and press the MENU
button.
A 7 bar graph appears on the display, in which each bar
represents a frequency. Select the bar to be adjusted
using the buttons ¯or ˙; the selected bar will start to
flash and it can be adjusted using buttons ▲or ▼.
To store the setting, press the AUDIO button again. The
display will show the source activated at that time
followed by the text “User”. If the mode is FM, then the
display will show “FM EQ User”.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:27 Pagina 235

237
RADIO
AF SWITCHING function
(alternative frequency search)
The radio can operate in two different modes in the RDS
system:
❒“AF Switching On”: search for alternative frequencies
activated (the letters “AF” appear on the display);
❒“AF Switching Off”: search for alternative frequencies
not activated.
Proceed as follows to activate/deactivate the function:
❒press the MENU button and select “AF Switching
On”;
❒press the ¯/ ˙buttons to turn the function on/off.
With the function activated the car radio will
automatically tune into the station with the strongest
signal that is transmitting the same programme. While
driving, the same station can be continuously listened to
without having to change the frequency when you
change zones. Obviously, it must be possible to receive the station that
you are listening to, in the area you are driving through.
If the AF function is activated, “AF” will light up in the
display.
If the AF function has been activated and the radio
cannot receive the station tuned into the radio activates
the automatic search during which the wording “FM
Search” will be shown on the display (for high-level
radios only).
With AF function deactivated, the remaining RDS
functions such as the radio station name display, remain
active.
The AF function can only be activated on FM bands.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:28 Pagina 237

238
RADIO
TRAFFIC INFORMATION function
(traffic information)
Some stations on the FM band (FM1, FM2 and FMA) can
transmit information about traffic conditions. In this case
the text “TA” appears on the display.
Proceed as follows to activate/deactivate the TA
function:
❒press the MENU button briefly and select “Traffic
info”;
❒press the ¯/ ˙buttons to turn the function on/off.
If the TA function has been activated, the icon “TA”
lights up on the display.
IMPORTANT If the TA function is activated with an
audio source other than Tuner (Radio) (CD, MP3,
telephone or Mute/Pause), the radio can carry out an
automatic search and therefore it is possible, when
reactivating the Tuner (Radio) source, that the frequency
tuned into is different from the one previously set.
With the TA function, it is possible to:
❒search only for RDS stations that transmit on the FM
band, that are enabled to transmit traffic information;
❒receive traffic information even if the CD player is on;
❒receive traffic information at a minimum preset
volume even with the radio volume off.
IMPORTANT In some countries there are radio stations
that, even with the TP function activated, do not
transmit traffic information (the icon “TP” appears on
the display).If the radio is tuned to a station in the AM band, when
TA is activated it will tune to the last selected station in
the FM1 band.
The volume at which the traffic news is transmitted
depends on the listening volume:
❒listening volume below 5: traffic news volume equal
to 5 (fixed value);
❒listening volume above 5: traffic news volume equal
to listening volume +1.
If the volume is changed during the traffic news, the level
will not be shown on the display; the new level will only
be maintained during the traffic news in progress.
While traffic information is being received, “TRAFFIC
INFORMATION” will appear on the display.
The TA function can be interrupted by pressing any
button on the car radio.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:28 Pagina 238

257
RIGHT HAND DRIVE VERSION
RIGHT HAND DRIVE VERSION
DASHBOARD
The presence and position of the controls, instruments and gauges may vary depending on the version.
F0U197Abfig. 1
1.Adjustable side air vents – 2.Fixed side air vents – 3.Right steering column stalk: windscreen wiper controls, rear
window wiper, trip computer –
4.Instrument panel – 5.Left steering column stalk: external lights –6.Panel controls –
7. Portable navigation system setup (for versions/markets, where provided) –
8.Adjustable central air vents – 9.Fixed
upper air vent –
10.Front airbag – passenger side – 11.Glove compartment – 12.Light guide – 13.Radio (for versions/
markets where provided) –
14.HVAC controls – 15. Steering wheel adjustment lever – 16.Front airbag – driver’s side –
17.Ignition device – 18.Control panel: headlamp alignment adjustment/ reconfigurable multifunction display.
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:28 Pagina 257

RIGHT HAND DRIVE VERSION
258
INSTRUMENT PANEL
A Speedometer (speed indicator)
B Fuel level gauge with reserve
warning light
C Engine coolant temperature
gauge with overheating warning
light
D Rev counter
E Reconfigurable multifunction
display
F0U198Abfig. 2
221-258 PUNTO Abarth GB 1ed 17-07-2012 13:28 Pagina 258