Periodic maintenance and adjustment
6-27
1
2
3
4
56
7
8
9
10
11
12 sparks, flames, cigarettes, etc.,
away from the battery and pro-
vide sufficient ventilation when
charging it in an enclosed
space.
KEEP THIS AND ALL BATTER-
IES OUT OF THE REACH OFCHILDREN.
NOTICE
ECA10621
Never attempt to remove the battery
cell seals, as this would permanent-ly damage the battery.
The battery is located behind panel A.
Remove the panel to access the bat-
tery. (See page 6-8.)
To charge the battery
Have a Yamaha dealer charge the bat-
tery as soon as possi
ble if it seems to
have discharged. Keep in mind that the
battery tends to discharge more quickly
if the vehicle is equipped with optional
electrical accessories.
NOTICE
ECA16522
To charge a VRLA (Valve Regulated
Lead Acid) battery, a special (con-
stant-voltage) battery charger is re-
quired. Using a conventional batterycharger will damage the battery.
To store the battery 1. If the vehicle will not be used for more than one month, remove the
battery, fully charge it, and then
place it in a cool, dry place.
NOTICE: When removing the
battery, be sure the key is
turned to “OFF”, then discon-
nect the negative lead before
disconnecting the positive
lead.
[ECA16303]
2. If the battery will be stored for morethan two months, check it at least once a month and fully charge it if
necessary.
3. Fully charge the battery before in- stalling it. NOTICE: When install-
ing the battery, be sure the key
is turned to “OFF”, then con-
nect the positive lead before
connecting the negative
lead.
[ECA16841]
4. After installing the battery, make sure that the battery leads are
properly connected to the battery
terminals.
5. Turn the key from “ON” to “OFF” three times in three-second inter-
vals to initialize the idle speed con-
trol system.NOTICE
ECA16531
Always keep the battery charged.
Storing a discharged battery cancause permanent battery damage.
1. Battery
1
U53BE1E0 27 ページ ２０１５年９月１５日 火曜日 午後１時４８分
Specifications
8-2
1
2
3
4
5
6
789
10
11
12
Manufacturer/model: DURO / DM1157FRear tire:Type:Tubeless
Size: 120 / 80 - 16M/C 60P
Manufacturer/model:
DURO / DM1157Loading:Maximum load:179 kg (395 lb)
* (Total weight of rider, passenger, cargo
and accessories)Tire air pressure (measured on cold
tires):Loading condition:90 kg (198 lb)
Front: 175 kPa (1.75 kgf/cm
2, 25 psi)
Rear: 200 kPa (2.00 kgf/cm2, 29 psi)
Loading condition:
90 kg - maximum load
Front: 175 kPa (1.75 kgf/cm2, 25 psi)
Rear: 225 kPa (2.25 kgf/cm2, 33 psi)
Front wheel:Wheel type:Cast wheel
Rim size: J 16M/C × MT2.50
Rear wheel:Wheel type:Cast wheel
Rim size: J 16M/C × MT2.75Front brake:Type:
Hydraulic single disc brake
Specified brake fluid: DOT 4Rear brake:Type:
Mechanical leading trailing drum brakeFront suspension:Type:Telescopic fork
Spring:
Coil spring
Shock absorber: Hydraulic damper
Wheel travel: 100 mm (3.9 in)Rear suspension:Type:Unit swing
Spring: Coil spring
Shock absorber:
Gas-hydraulic damper
Wheel travel: 92 mm (3.6 in)Electrical system:System voltage:
12 V Ignition system:
TCI
Charging system:
AC magneto
Battery:Model:GT7B-4
Voltage, capacity:
12 V, 6.5 Ah (10 HR)Headlight:Bulb type:Halogen bulbBulb voltage, wattage quantity:Headlight:
12 V, 55.0 W 2
Front turn signal light: 12 V, 10.0 W 2
Rear turn signal light:
12 V, 10.0 W 2
Auxiliary light: 12 V, 5.0 W 2
License plate light: 12 V, 5.0 W 1
Engine trouble warning light:
12 V, LED × 1Fuse:Main fuse:20.0 A
Headlight fuse:
15.0 A
Signaling system fuse: 15.0 A
Ignition fuse: 7.5 A
U53BE1E0 2 ページ ２０１５年９月１５日 火曜日 午後１時４８分
