Valve clearance .................................. 8-41
Brakes ................................................ 8-41
Checking the front and rear brake pads.................................................. 8-41
Checking the brake fluid level ............ 8-42
Brake fluid replacement ..................... 8-43
Checking the brake pedal .................. 8-43
Parking brake ..................................... 8-44
Brake light switch adjustment ............ 8-44
Cable inspection and lubrication........ 8-45
Brake pedal and accelerator pedal
lubrication ......................................... 8-45
Checking the stabilizer bushes .......... 8-46
Rear knuckle upper and lower pivot
lubrication (left and right) .................. 8-46
Steering shaft lubrication ................... 8-47
Wheel removal.................................... 8-47
Checking and tightening the bead lock .................................................. 8-48
Tire replacement ................................ 8-48
Wheel installation ............................... 8-49
Battery ................................................ 8-50
Jump-starting ..................................... 8-53 Fuse replacement ...............................8-54
Replacing a headlight bulb .................8-57
Headlight beam adjustment ...............8-59
Tail/brake light bulb replacement .......8-60
Troubleshooting ..................................8-60
Troubleshooting charts .......................8-62
CLEANING AND STORAGE ....................9-1 Cleaning................................................9-1
Storage .................................................9-2
SPECIFICATIONS..................................10-1
CONSUMER INFORMATION ................11-1 Identification number records.............11-1
INDEX ....................................................12-1
UBN57AE0.book Page 3 Tuesday, November 24, 2015 1:42 PM
8-54
8
4. Connect the negative lead of the jumpercable to the negative terminal of the
charged battery and the other end of the
negative lead to an unpainted metal sur-
face of the frame of the vehicle to be
started.
5. Start the engine. (Refer to “Starting the engine” on page 6-2.)
6. After the engine starts, disconnect the
negative lead of the jumper cable from
the frame and charged battery, and then disconnect the positive lead of the jump-
er cable from the charged battery and the
battery in the vehicle.
7. Install the hood.
EBU33100Fuse replacementThe main fuse, the fuel injection system fuse,
the EPS fuse, and the fuse box are located
under the hood. (See page 8-10 for hood re-
moval and installation procedures.)
1. Jumper cable negative lead
1
UBN57AE0.book Page 54 Tuesday, November 24, 2015 1:42 PM
