Table of contents
Battery ........................................... 6-29
Replacing the fuses ....................... 6-31
Replacing the headlight bulb ......... 6-34
Replacing an auxiliary light bulb .... 6-36
Brake/tail light ................................ 6-37
Replacing a turn signal light bulb ............................................ 6-38
Replacing the license plate light
bulb ............................................ 6-38
Supporting the motor cycle ............. 6-39
Front wheel (for non-ABS
models) ...................................... 6-39
Rear wheel (for non-ABS models) ...................................... 6-41
Troubleshooting............................. 6-42
Troubleshooting charts .................. 6-44
Motorcycle care and storage ........... 7-1
Matte color caution .......................... 7-1
Care................................................. 7-1
Storage ............................................ 7-3
Specifications ................................... 8-1
Consumer information ..................... 9-1
Identification numbers ..................... 9-1
Diagnostic connector (MT09A) ........ 9-2
Index ................................................ 10-1
B87-9-E0_1.book 2 ページ 2015年12月16日 水曜日 午前10時21分
Periodic maintenance and adjustment6-42
1
2
3
4
567
8
9
10
11
12
have been removed, otherwise
the brake pads will be forced
shut.
[ECA11073]
To install the rear wheel
1. Install the wheel and the brake cal- iper bracket by inserting the wheel
axle from the left-hand side.TIP
Make sure that the slot in the brake
caliper bracket is fit over the retain-
er on the swingarm.
Make sure that there is enough
space between the brake pads be-fore installing the wheel. 2. Install the drive chain onto the rear
sprocket.
3. Install the axle nut.
4. Lower the rear wheel so that it is on the ground, and then put the
sidestand down.
5. Adjust the drive chain slack. (See page 6-23.)
6. Tighten the axle nut, and then tighten the locknuts to the speci-
fied torques.
EAU25872
TroubleshootingAlthough Yamaha motorcycles receive
a thorough inspection before shipment
from the factory, trouble may occur dur-
ing operation. Any problem in the fuel,
compression, or ignition systems, for
example, can cause poor starting and
loss of power.
The following troubleshooting charts
represent quick and easy procedures
for checking these vital systems your-
self. However, should your motorcycle
require any repair, take it to a Yamaha
dealer, whose skilled technicians have
the necessary tools, experience, and
know-how to service the motorcycle
properly.
Use only genuine Yamaha replace-
ment parts. Imitation parts may look like
Yamaha parts, but they are often inferi-
or, have a shorter service life and can
lead to expensive repair bills.
WARNING
EWA15142
When checking the fuel system, do
not smoke, and make sure there are
no open flames or sparks in the ar-
ea, including pilot lights from water
1. Wheel axle
1
1. Slot
2. RetainerTightening torques:Axle nut:
150 Nm (15 m·kgf, 108 ft·lbf)
Locknut: 16 Nm (1.6 m·kgf, 12 ft·lbf)
2
1
B87-9-E0_1.book 42 ページ 2015年12月16日 水曜日 午前10時21分
Periodic maintenance and adjustment6-44
1
2
3
4
567
8
9
10
11
12
EAU42365
Troubleshooting chartsStarting problems or poor engine performance
Check the fuel level in
the fuel tank.1. Fuel
There is enough fuel.
There is no fuel.
Check the battery.
Supply fuel.
The engine does not start.
Check the battery.
Remove the spark plugs
and check the electrodes.3. Ignition
Wipe off with a dry cloth and correct the
spark plug gaps, or replace the spark plugs.
Have a Yamaha dealer check the vehicle.
Operate the electric starter.4. Compression
There is compression.
There is no compression.
The engine does not start.
Have a Yamaha dealer check the vehicle.Have a Yamaha dealer check the vehicle.
The engine does not start.
Check the compression.
Operate the electric starter.2. Battery
The engine turns over
quickly.
The engine turns over
slowly.
The engine does not start.
Check the ignition.
The battery is good.Check the battery lead connections,
and have a Yamaha dealer charge
the battery if necessary.
DryWet
Operate the electric starter.
B87-9-E0_1.book 44 ページ 2015年12月16日 水曜日 午前10時21分
Index
10-2
1
2
3
4
5
6
7
8
91011
12
Tool kit ....................................................... 6-2
Traction control system ........................... 3-21
Traction control system indicator light ....... 3-6
Traction control system switch ................ 3-17
Troubleshooting ....................................... 6-42
Troubleshooting charts ............................ 6-44
Turn signal indicator light........................... 3-4
Turn signal light bulb, replacing ............... 6-38
Turn signal switch .................................... 3-17VValve clearance ....................................... 6-15
Vehicle identification number..................... 9-1WWheel bearings, checking ....................... 6-29
Wheel, front (for non-ABS models).......... 6-39
Wheel, rear (for non-ABS models) .......... 6-41
Wheels..................................................... 6-18
B87-9-E0_1.book 2 ページ 2015年12月16日 水曜日 午前10時21分