2016 TOYOTA GT86 bulb

TABLE OF CONTENTSIndex
FT86_EE
4
4-1. Maintenance and care
Cleaning and protecting
the vehicle exterior ........... 282
Cleaning and protecting
the vehicle interior ............ 286
Cleaning and protecting
the Alcantara
® area .......... 290
4-2. Maintenance
Maintenance
requirements..................... 292
4-3. Do-it-yourself
maintenance
Do-it-yourself service
precautions ....................... 295
Hood ................................... 298
Positioning a floor jack ........ 300
Engine compartment........... 302
Tires .................................... 315
Tire inflation pressure ......... 324
Wheels ................................ 326
Air conditioning filter ........... 329
Wireless remote control/
electronic key battery........ 332
Checking and replacing
fuses ................................. 336
Light bulbs .......................... 3445-1. Essential information
Emergency flashers ........... 364
If your vehicle needs to
be towed .......................... 365
If you think something is
wrong ............................... 372
Fuel pump shut off
system.............................. 373
5-2. Steps to take in an
emergency
If a warning light turns
on or a warning buzzer
sounds... ......................... 374
If you have a flat tire
(vehicles with
a spare tire) ...................... 386
If you have a flat tire
(vehicles with
an emergency tire
puncture repair kit) ........... 395
If the engine will not
start .................................. 411
If the shift lever cannot be
shifted from P ................... 414
4Maintenance and care5When trouble arises
86_OM_EE_OM18058E.book 4 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

191
2-1. Driving procedures
2
When driving
FT86_EE
Tur n signal lever
■Turn signals can be operated when
Vehicles without a smart entry & start system
The engine switch is in the “ON” position.
Vehicles with a smart entry & start system
The “ENGINE START STOP” switch is in IGNITION ON mode.
■If the indicators flash faster than usual
Check that a light bulb in the turn signal lights has not burned out. The turn signal lever can be used to show the following intentions of
the driver:
Right turn
Left turn
Lane change to the right
(push and hold the lever
partway)
The right hand signals will
flash until you release the
lever.
Lane change to the left
(push and hold the lever
partway)
The left hand signals will flash
until you release the lever.
86_OM_EE_OM18058E.book 191 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

4Maintenance and care
281
FT86_EE
4-1. Maintenance and care
Cleaning and protecting
the vehicle exterior ......... 282
Cleaning and protecting
the vehicle interior .......... 286
Cleaning and protecting
the Alcantara
® area ........ 290
4-2. Maintenance
Maintenance
requirements................... 292
4-3. Do-it-yourself
maintenance
Do-it-yourself service
precautions ..................... 295
Hood ................................. 298
Positioning a floor jack ...... 300
Engine compartment......... 302
Tires .................................. 315
Tire inflation pressure ....... 324
Wheels .............................. 326
Air conditioning filter ......... 329
Wireless remote control/
electronic key battery...... 332
Checking and replacing
fuses ............................... 336
Light bulbs ........................ 344
86_OM_EE_OM18058E.book 281 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

295
4
Maintenance and care
FT86_EE
4-3. Do-it-yourself maintenance
Do-it-yourself ser vice precautions
If you perform maintenance yourself, be sure to follow the correct
procedures as given in these sections.
ItemsParts and tools
Battery condition (→P. 309)•Warm water
• Baking soda
• Grease
• Conventional wrench
(for terminal clamp bolts)
• Distilled water
Engine coolant level (→P. 306)• “TOYOTA Genuine 50/50 Pre-
mixed Super Long Life Coolant
BLUE” or similar high-quality
ethylene glycol-based non-
silicate, non-amine, non-nitrite
and non-borate coolant with long-
life hybrid organic acid
technology. “TOYOTA Genuine
50/50 Pre-mixed Super Long Life
Coolant BLUE” is pre-mixed with
50% coolant and 50% deionized
water.
• Funnel (used only for adding cool-
ant)
Engine oil level(→P. 303)• “Toyota Genuine Motor Oil” or
equivalent
• Rag or paper towel, funnel
(used only for adding engine oil)
Fuses (→P. 336)• Fuse with same amperage rating
as original
Light bulbs (→P. 344)• Bulb with same number and watt-
age rating as original
• Phillips-head screwdriver
• Flathead screwdriver
86_OM_EE_OM18058E.book 295 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

343 4-3. Do-it-yourself maintenance
4
Maintenance and care
FT86_EE
■After a fuse is replaced
●If the lights do not turn on even after the fuse has been replaced, a bulb
may need replacement. (→P. 344)
●If the replaced fuse blows again, have the vehicle inspected by any
authorized Toyota dealer or repairer, or another duly qualified and
equipped professional.
■If there is an overload in the circuits
The fuses are designed to blow, protecting the wiring harness from damage.
CAUTION
■To prevent system breakdowns and vehicle fire
Observe the following precautions.
Failing to do so may cause damage to the vehicle, and possibly a fire or
injury.
●Never use a fuse of a higher amperage rating than indicated, or use any
other object in place of a fuse.
●Always use a genuine Toyota fuse or equivalent.
●Do not modify the fuse or the fuse box.
NOTICE
■Before replacing fuses
Have the cause of electrical overload determined and repaired by any autho-
rized Toyota dealer or repairer, or another duly qualified and equipped pro-
fessional.
86_OM_EE_OM18058E.book 343 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

344
4-3. Do-it-yourself maintenance
FT86_EE
Light bulbs
You may replace the following bulbs by yourself. The difficulty level
of replacement varies depending on the bulb. As there is a danger
that components may be damaged, we recommend that replacement
is carried out by any authorized Toyota dealer or repairer, or another
duly qualified and equipped professional.
■Preparing a replacement light bulb
Check the wattage of the light bulb being replaced. (→P. 446)
■Front bulb locations
Headlights (high beam)
(vehicles with halogen
headlights)
Headlights (low beam) (vehicles with
halogen headlights)
Side turn
signal lights
Front turn signal lightsFront position lights (vehicles
with halogen headlights)
Daytime running lights
(vehicles with
halogen headlights)
Front fog lights
(if equipped)
86_OM_EE_OM18058E.book 344 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

345 4-3. Do-it-yourself maintenance
4
Maintenance and care
FT86_EE
■Rear bulb locations
Rear turn signal lights
Back-up lightsLicense
plate
lights
Rear fog
light
86_OM_EE_OM18058E.book 345 ページ ２０１５年３月１７日　火曜日　午前１１時３１分

346 4-3. Do-it-yourself maintenance
FT86_EE
Replacing light bulbs
■Headlight low beams (vehicles with halogen bulbs)
Turn the bulb base counterclock-
wise.
Unplug the connector while
depressing the lock release.
Replace the light bulb, and install
the bulb base.
Align the 3 tabs on the light bulb
with the mounting, and insert.
STEP 1
STEP 2
STEP 3
86_OM_EE_OM18058E.book 346 ページ ２０１５年３月１７日　火曜日　午前１１時３１分