2016 TOYOTA C-HR fuel

7458-2. Steps to take in an emergency
8
When trouble arises
C-HR_OM_Europe_OM10528E
If the engine will not start
One of the following may be the cause of the problem:
● There may not be sufficient fuel in the vehicle’s tank.
Refuel the vehicle.
● The engine may be flooded.
Try to restart the engine again following correct starting procedures.
( P. 233, 236)
● There may be a malfunction in the engine immobilizer system.
( P. 8 7 )
One of the following may be the cause of the problem:
● The battery may be discharged. (P. 750)
● The battery terminal connections may be loose or corroded.
The engine starting system may be malfunctioning due to an electrical
problem such as electronic key battery depletion or a blown fuse.
However, an interim measure is available to start the engine.
( P. 746)
If the engine will not start even though correct starting proce-
dures are being followed ( P. 233, 236), consider each of the fol-
lowing points:
The engine will not start even though the starter motor operates
normally.
The starter motor turns over slowly, the interior lights and head-
lights are dim, or the horn does not sound or sounds at a low
volume.
The starter motor does not turn over (vehicles with a smart entry
& start system)

761
9Vehicle specifications
C-HR_OM_Europe_OM10528E
9-1. Specifications
Maintenance data
(fuel, oil level, etc.)........... 762
Fuel information ................. 774
9-2. Customization
Customizable features ....... 776
9-3. Initialization
Items to initialize ................ 789

7629-1. Specifications
C-HR_OM_Europe_OM10528E
Maintenance data (fuel, oil level, etc.)
*1: Unladen vehicles
*2: Vehicles with a Stop & Start system
*3: Vehicles without a Stop & Start system
*4: Vehicles with a Multidrive
*5: Vehicles with a manual transmission
Dimensions and weights
Overall length 4360 mm (171.7 in.)
Overall width 1795 mm (70.7 in.)
Overall height*11555 mm (61.2 in.)*2
1565 mm (61.6 in.)*3
Wheelbase 2640 mm (103.9 in.)
TreadFront 1550 mm (61.0 in.)
Rear 1560 mm (61.4 in.)
Gross vehicle mass2WD models 1865 kg (4112 lb.)*4
1845 kg (4068 lb.)*5
AWD models 1930 kg (4255 lb.)
Maximum
permissible axle
capacity
Front 1050 kg (2315 lb.)
Rear 1080 kg (2381 lb.)
Drawbar load 75 kg (165 lb.)
Towing capacityWith brake
Except for Guadeloupe and
Martinique
1100 kg (2425 lb.)*4
1300 kg (2866 lb.)*5
For Guadeloupe and Martinique
600 kg (1323 lb.)*4
1100 kg (2425 lb.)*5
Without brake 720 kg (1587 lb.)

7649-1. Specifications
C-HR_OM_Europe_OM10528E
■Engine number
The engine number is stamped
on the engine block as shown.
Engine
Model 8NR-FTS
Ty p e 4-cylinder in line, 4-cycle, gasoline (with turbo-
charger)
Bore and stroke 71.5  74.5 mm (2.82  2.93 in.)
Displacement 1197 cm3 (73.0 cu.in.)
Valve clearance (engine
cold) Automatic adjustment
Drive belt tension Automatic adjustment
Fuel
Fuel type
EU area:
Unleaded gasoline conforming to European
standard EN228 only
Except EU area:
Unleaded gasoline only
Research Octane
Number95 or higher
Fuel tank capacity
(Reference)50 L (13.2 gal., 11.0 Imp.gal.)

7669-1. Specifications
C-HR_OM_Europe_OM10528E
Recommended viscosity (SAE):
“Toyota Genuine Motor Oil SAE
0W-20 for Downsized Turbo
Gasoline Engines” is filled into
your Toyota vehicle at manufac-
turing, and SAE 0W-20 is the
best choice for good fuel econ-
omy and good starting in cold
weather.
If SAE 0W-20 oil is not available, SAE 5W-30 oil may be used.
However, it should be replaced with SAE 0W-20 at the next oil
change.
Oil viscosity (0W-20 is explained here as an example):
• The 0W in 0W-20 indicates the characteristic of the oil which
allows cold startability. Oils with a lower value before the W allow
for easier starting of the engine in cold weather.
• The 20 in 0W-20 indicates the viscosity characteristic of the oil
when the oil is at high temperature. An oil with a higher viscosity
(one with a higher value) may be better suited if the vehicle is
operated at high speeds, or under extreme load conditions.
Temperature range anticipated
before next oil change
Preferred

7679-1. Specifications
9
Vehicle specifications
C-HR_OM_Europe_OM10528E
How to read oil container labels:
Either or both API registered marks are added to some oil contain-
ers to help you select the oil you should use.
API Service Symbol
Top portion: “API SERVICE SN”
means the oil quality designa-
tion by American Petroleum
Institute (API).
Center portion: “SAE 0W-20”
means the SAE viscosity grade.
Lower portion: “Resource-
Conserving” means that the oil
has fuel-saving and environ-
mental protection capabilities.
ILSAC Certification Mark
The International Lubricant Specification Advisory Committee (ILSAC)
Certification Mark is displayed on the front of the container.
1
2

7709-1. Specifications
C-HR_OM_Europe_OM10528E
Your Toyota vehicle is filled with “Toyota Genuine Differential Gear Oil” at the
factory.
Use Toyota approved “Toyota Genuine Differential Gear Oil” or an equivalent
of matching quality to satisfy the above specification.
Please contact any authorized Toyota re tailer or Toyota authorized repairer,
or any reliable repairer for further details.
Manual transmission
Gear oil capacity (Reference) 2.4 L (2.5 qt., 2.1 Imp.qt.)
Gear oil type “TOYOTA Genuine Manual Transmission
Gear Oil LV GL-4 75W” or equivalent
NOTICE
■ Manual transmission gear oil
• Please be aware that depending on the particular characteristics of the
gear oil used or the operating conditions, idle sound, shift feeling and/or
fuel efficiency may be different or affected and, in the worst case, damage
to the vehicle’s transmission.
Toyota recommends to use “TOYOTA Genuine Manual Transmission
Gear Oil LV GL-4 75W” to achieve optimal performance.
• Your Toyota vehicle is filled with “TOYOTA Genuine Manual Transmission
Gear Oil LV GL-4 75W” at the factory.
Use Toyota approved “TOYOTA Genuine Manual Transmission Gear Oil
LV GL-4 75W” or an equivalent oil matching quality that satisfies the
above specifications.
Please contact any authorized Toyota retailer or Toyota authorized
repairer, or any reliable repairer for further details.
Rear differential (AWD models)
Oil capacity 0.5 L (0.5 qt., 0.4 lmp.qt.)
Oil type and viscosity Toyota Genuine Differential gear oil LT
75W-85 GL-5 or equivalent

7749-1. Specifications
C-HR_OM_Europe_OM10528E
Fuel information
■Use of ethanol blended gasoline in a gasoline engine
Toyota allows the use of ethanol blended gasoline where the ethanol content
is up to 10%. Make sure that the ethanol blended gasoline to be used has a
Research Octane Number that follows the above.
■ If your engine knocks
● Consult any authorized Toyota retailer or Toyota authorized repairer, or any
reliable repairer.
● You may occasionally notice light knocking for a short time while accelerat-
ing or driving uphill. This is normal and there is no need for concern.
EU area:
You must only use unleaded gasoline conforming to European
standard EN228.
Select unleaded gasoline with a Research Octane Number of 95
or higher for optimum engine performance.
Except EU area:
You must only use unleaded gasoline.
Select unleaded gasoline with a Research Octane Number of 95
or higher for optimum engine performance.