Page 75 of 258
1.69
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT \
AND COUNTRY.
TRIP COMPUTER: trip settings (5/5)
Examples of selectionsInterpreting the display selected
LEARNING THE 
TYRE PRESSURE
i)  Reset the tyre pressure.
Please refer to the information on the “Tyre pressure loss warning” in Section 2.
j)  Cruise control and speed limiter programmed speed.Refer to the information in “Cruise control” and “Speed limiter\
” in Section 2.
SPEED LIMITER 
90 km/H
CRUISE CONTROL  90 km/H
13° 16:30
k) Clock and temperature. Please refer to the information under “Clock and exterior temperature\
”.
NO MESSAGE  MEMORISED 
l) Trip log.
Successive display:
–   information messages (passenger airbag OFF etc.);
–   operating fault messages (check the injection system, etc.). 
     
        
        Page 76 of 258
1.70
TRIP COMPUTER AND WARNING SYSTEM: information messages
Examples of messagesInterpreting the display selected
« PARKING BRAKE ON »   Indicates that the parking brake has been applied.
« PLEASE REMOVE  KEYCARD »  Request to remove the RENAULT card from the reader when you leave the vehicle.
« TRACTION 
CONTROL OFF »  Indicates that you have deactivated the traction control function.
« TURN STEERINGWHEEL  + START »  Turn the steering wheel slightly whilst pressing the vehicle start button\
 to unlock the steering 
column.
« STEERING WHEEL  NOT LOCKED »  Indicates that the steering column has not been locked.
These can help in the vehicle starting phase, or give information about \
a selection or a driving status.
Examples of information messages are given in the following pages. 
     
        
        Page 77 of 258

1.71
TRIP COMPUTER AND WARNING SYSTEM: operating fault messages
These appear with the © warning light and mean that you should drive very carefully to an author\
ised dealer as 
soon as possible. If you fail to follow this recommendation, you risk da\
maging your vehicle.
They disappear when the display selection key is pressed or after severa\
l seconds and are stored in the computer log. The 
© warning light stays on. Examples of operating fault messages are given \
in the following pages.
Examples of messages Interpreting the display selected
« CLEAN DIESEL FILTER » Indicates the presence of water in the diesel filter; contact an approve\
d Dealer 
as soon as possible.
« CHECK VEHICLE »  Indicates a fault in one of the pedal sensors, battery management system\
 or oil 
level sensor.
« CHECK AIRBAG »  Indicates a fault in the restraint system in addition to the seat belts.\
 In the event 
of an accident, it is possible that they may not be triggered.
« CHECK ANTI-POLLUTION SYSTEM »  Indicates a fault in the vehicle’s particle filter system. 
     
        
        Page 78 of 258
1.72
TRIP COMPUTER AND WARNING SYSTEM: warning message
These appear with the ® warning light and require you to stop immediately, for your own safety, as soon as traf-
fic conditions allow. Stop your engine and do not restart it. Contact an approved Dealer.
Examples of warning messages are given in the following pages.  Note: the messages appear on the display either individually 
or alternately (when there are several messages to be displayed), and \
may be accompanied by a warning light and/or a beep.
Examples of messages Interpreting the display selected
« ENGINE FAILURE HAZARD »  Indicates an injection fault, the vehicle’s engine has overheated or there is a 
serious engine fault.
« BRAKING SYSTEM FAULT »  Indicates a fault in the braking system.
« BATTERY CHARGING FAULT »  Indicates a fault in the vehicle battery charging circuit (alternator e\
tc.).
« PUNCTURE » Indicates that at least one wheel is punctured or severely underinflated\
. 
     
        
        Page 79 of 258
1.73
Then press and hold button 2 or 3  to 
confirm the time set.
The minute display flashes: repeatedly 
press or press and hold button  2 or 3 to 
set the time.
When setting is complete, the hours 
and minutes remain displayed continu-
ously for 2 seconds: your setting is reg-
istered.
You may change the display.Display A
To access display 1 for setting the time, 
press button 2 or 3. Wait for a few sec-
onds.
The hours and minutes flash and you 
are now in setting mode; press and 
hold button  2 or 3 to set the hours.
Once the minutes flash, repeatedly 
press or press and hold button  2 ou 3 
to set the time.
CLOCK AND EXTERIOR TEMPERATURE (1/2)
2
3
If the power supply is cut (battery 
disconnected, supply wire cut, etc.), 
the clock must be reset.
We recommend that you do not 
adjust these settings while driving.
9°C 12:00
1
A   
     
        
        Page 80 of 258
1.74
Display B
Vehicles fitted with touch-screen 
multimedia, navigation aid systems, 
telephones, etc.
Refer to the separate instructions for 
the function to understand the special 
features of this equipment.
External temperature 
indicator
Special note:
When the exterior temperature is - 3°C 
to + 3°C, the °C characters flash (sig-
nalling a risk of ice on the road).
External temperature in-
dicator
As ice formation is related 
to climatic exposure, local 
air humidity and temperature, the 
external temperature alone is not 
sufficient to detect ice.
CLOCK AND EXTERIOR TEMPERATURE (2/2)
If the power supply is cut (battery disconnected, supply wire cut, etc.\
), the clock 
must be reset.
We recommend that you do not adjust these settings while driving.
B  
     
        
        Page 103 of 258

2.11
SPECIAL FEATURES OF DIESEL VERSIONS
Diesel engine speed
Diesel engines are fitted with injection 
equipment which prevents the engine 
speed being exceeded irrespective of 
the gear selected.
If the message “CHECK ANTI-
POLLUTION SYSTEM” is displayed 
along with warning lights 
Ä and 
©, consult an authorised dealer 
immediately.
When driving, depending on the fuel 
grade used, it is possible that white 
smoke may be emitted.
This is due to the exhaust particle filter 
being cleaned automatically, and does 
not affect the way the vehicle runs.
Running out of fuel
If the  tank has been completely drai-
ned, the system must be reprimed after 
the tank is refilled: see information on 
the “fuel tank” in section 1 before res-
tarting the engine.
Do not park the vehicle or 
run the engine in locations 
where combustible subs-
tances or materials such 
as grass or leaves can come into 
contact with the hot exhaust system.
Precautions to be taken in 
winter
To avoid any faults in icy weather:
–  ensure that the battery is always fully  charged,
– always keep the diesel tank re- latively full to avoid water vapour 
condensing in it and accumulating at 
the bottom of the tank. 
     
        
        Page 105 of 258

2.13
DRIVING ADVICE, ECO-DRIVING (1/5)
Fuel consumption is accredited in ac-
cordance with a standard regulatory 
method. Identical for all manufactu-
rers, this enables vehicles to be com-
pared with one another. Consumption 
in real time depends on vehicle usage 
conditions, the equipment fitted and the 
user’s driving style. To optimise fuel 
consumption, please refer to the fol-
lowing advice.
Depending on the vehicle, you will have 
various functions which enable you to 
lower your fuel consumption:
–  the rev counter;
–  gear change indicator;
–  the driving style indicator;
–  the journey record and eco-driving advice via the multimedia display;
–  ECO mode – activated by the ECO  button.
If fitted on the vehicle, the navigation 
system provides additional information.
2
Driving style indicator  2
Informs you about the driving style 
adopted in real time. You will be notified 
by the colour of warning light  2.
–  Green: measured, economical driv- ing;
–  Yellow: opt for a calmer driving style;
–  Orange: driving too fast.
The driving style indicator is activated 
by default. If you wish to deactivate it, 
please see the multimedia system in-
structions.
1
Gear change indicator  1
To obtain optimum consumption levels, 
a warning light on the instrument panel 
lets you know the best time to move up 
or down a gear:
Š move up a gear;
‰ move down a gear.