2016 RAM CHASSIS CAB torque

Do not oil wheel studs. For chrome wheels, do not
substitute with chrome plated wheel nuts.
Tighten the lug nuts/bolts in a star pattern until each
nut/bolt has been tightened twice. After 25 miles (40 km) check the lug nut/bolt torque to be
sure that all the lug nuts/bolts are properly seated
against the wheel.
Wheel Mounting Surface 8/10 Lug Nuts/Bolts Torque Patterns 6WHAT TO DO IN EMERGENCIES 539

(SRW) models. On dual rear wheel models (DRW) the
lug nuts are a two-piece assembly with a flat face.
Lightly tighten the nuts. To avoid risk of forcing the
vehicle off the jack, do not fully tighten the nuts until
the vehicle has been lowered.
6. Using the wheel wrench, finish tightening the nuts
using a crisscross pattern. For the proper lug nut
torque specifications refer to “Wheel and Tire Torque
Specifications” in this section. If in doubt about the
correct tightness, have them checked with a torque
wrench by your authorized dealer or at a service
station.
WARNING!A loose tire or jack thrown forward in a collision or
hard stop could injure someone in the vehicle. Al-
ways stow the jack parts and the extra tire and wheel
in the places provided. 7. Install wheel center cap (if equipped) and remove
wheel blocks. Do not install chrome or aluminum
wheel center caps on the spare wheel. This may result
in cap damage.
8. Lower the jack to its fully closed position. If the jack
will not lower by turning the dial (thumbwheel) by
hand, it may be necessary to use the jack drive tube in
order to lower the jack. Stow the replaced tire, jack,
and tools as previously described.
9. Adjust the tire pressure when possible.
Hub Caps/Wheel Covers — If Equipped
The hub caps must be removed before raising the vehicle
off the ground. 6WHAT TO DO IN EMERGENCIES 545

Replace the wheel skins first using a rubber mallet. When
replacing the hub caps, tilt the cap retainer over the lug
nut bolt circle and strike the high side down with a
rubber mallet. Be sure that the hub caps and wheel skins
are firmly seated around the wheel.
Dual Rear Wheels
Slots in the wheels will assist in properly orienting the
inner and outer wheels. Align these slots when assem-
bling the wheels for best access to the tire valve on the
inner wheel. The tires of both dual wheels must be
completely off the ground when tightening to insure
wheel centering and maximum wheel clamping.
Dual wheel models require a special heavy-duty lug nut
tightening adapter (included with the vehicle) to cor-
rectly tighten the lug nuts. Also, when it is necessary to
remove and install dual rear wheels, use a proper vehicle
lifting device. NOTE: When installing a spare tire (if equipped) as part
of a dual rear wheel end combination, the tire diameter of
the two individual tires must be compared. If there is a
significant difference, the larger tire should be installed in
a front location. The correct direction of rotation for dual
tire installations must also be observed.
It is recommended that wheel stud nuts be kept torqued
to specifications at all times. Torque wheel stud nuts to
specifications at each lubrication interval.
• Retighten the wheel nuts in the same sequence to the
torques listed in the table. Go through the sequence a
second time to verify that specific torque has been
achieved. Retighten to specifications at 100 miles
(160 km) and after 500 miles (800 km).
Wheel Nuts
All wheel nuts should be tightened occasionally to elimi-
nate the possibility of wheel studs being sheared or the 6WHAT TO DO IN EMERGENCIES 547

bolt holes in the wheels becoming elongated. This is
especially important during the first few hundred miles/
kilometers of operation to allow the wheel nuts to
become properly set. All wheel nuts should first be firmly
seated against the wheel. The wheel nuts should then be
tightened to recommended torque. Tighten the wheel
nuts to final torque in increments. Progress around the
bolt circle, tightening the wheel nut opposite to the wheel
nut just previously tightened until final torque is
achieved.
To Stow The Flat Or Spare — If Equipped
Refer to Upfitters Body Builders Guide for information
on stowing your spare tire (if equipped). HOISTING
A conventional floor jack may be used at the jacking
locations. Refer to the graphics that show jacking loca-
tions. However, a floor jack or frame hoist must never be
used on any other parts of the underbody.
CAUTION!Never use a floor jack directly under the differential
housing of a loaded truck or damage to your vehicle
may result.
JUMP-STARTING PROCEDURES
If your vehicle has a discharged battery it can be jump-
started using a set of jumper cables and a battery in
another vehicle or by using a portable battery booster
pack. Jump-starting can be dangerous if done improperly
so please follow the procedures in this section carefully.548 WHAT TO DO IN EMERGENCIES

only the manufacturer ’s specified transmission fluid.
Refer to “Fluids, Lubricants, And Genuine Parts” in this
section for fluid specifications. It is important to maintain
the transmission fluid at the correct level using the
recommended fluid. No chemical flushes should be used
in any transmission; only the approved lubricant should
be used.
CAUTION!Using a transmission fluid other than the manufac-
turer ’s recommended fluid may cause deterioration
in transmission shift quality and/or torque converter
shudder, and will require more frequent fluid and
filter changes. Refer to “Fluids, Lubricants, And
Genuine Parts” in this section for fluid specifica-
tions. Special Additives
The manufacturer strongly recommends against using
any special additives in the transmission. Automatic
Transmission Fluid (ATF) is an engineered product and
its performance may be impaired by supplemental addi-
tives. Therefore, do not add any fluid additives to the
transmission. Avoid using transmission sealers as they
may adversely affect seals.
CAUTION!Do not use chemical flushes in your transmission as
the chemicals can damage your transmission compo-
nents. Such damage is not covered by the New
Vehicle Limited Warranty. 7MAINTAINING YOUR VEHICLE 597

Tilt Steering Column ...................... .178
Tip Start ............................... .403
Tire And Loading Information Placard . . . .466, 467, 484
Tire Markings ........................... .459
Tires.................... .120, 471, 477, 478, 647
Aging (Life Of Tires) .................... .481
Air Pressure .......................... .471
Chains .............................. .484
Compact Spare ........................ .478
Dual ......................... .487, 538, 547
General Information .............. .471, 477, 478
High Speed .......................... .474
Inflation Pressures ...................... .472
Life Of Tires .......................... .481
Load Capacity ..................... .466, 467
Pressure Monitor System (TPMS) ........... .488
Pressure Warning Light .................. .254
Quality Grading ....................... .647
Radial .............................. .475 Replacement .......................... .482
Rotation ............................. .486
Safety ........................... .459, 471
Sizes ............................... .461
Snow Tires ........................... .476
Spare Tire ..................... .477, 478, 479
Spinning ............................ .480
Tread Wear Indicators ................... .480
Wheel Nut Torque ..................... .545
Tire Safety Information .................... .459
Tongue Weight/Trailer Weight ............... .513
Torque Converter Clutch ................... .419
Tow Hooks, Emergency .................... .554
Towing ............................ .507, 556
Disabled Vehicle ....................... .556
Guide .............................. .513
Recr eational .......................... .528
W eight .............................. .513
Towing Vehicle Behind A Motorhome .......... .528668 INDEX

Uconnect Access
Vehicle Health Alert .................... .388
Uconnect Settings
Customer Programmable Features ..... .42, 321, 339
Passive Entry Programming ......... .42, 321, 339
Uconnect Settings ................... .321, 339
Uconnect Voice Command .................. .373
Uniform Tire Quality Grades ................ .647
Unleaded Gasoline ....................... .498
Untwisting Procedure, Seat Belt ................58
Vehicle Identification Number (VIN) .............6
Vehicle Loading ...................... .467, 504
Vehicle Modifications/Alterations ...............7
Vehicle Storage ....................... .371, 617
Viscosity, Engine Oil ...................... .571
Voice Recognition System (VR) ............... .373
Warnings And Cautions ......................6 Warranty Information ..................... .645
Washers, Windshield ................... .175, 584
Washing Vehicle ......................... .601
Water
Driving Through ....................... .436
Wheel And Wheel Trim .................... .603
Wheel And Wheel Trim Care ................ .603
Wheel Cover ........................... .545
Wheel Nut Torque .................... .545, 547
Wind Buffeting ............................49
Window Fogging ........................ .371
Windows ................................46
Power ................................46
Rear Sliding .......................... .228
Reset Auto-Up ..........................49
Wind Buffeting ..........................49
Windshield Defroster .......................119
Windshield Washers ................ .174, 175, 584
Fluid ............................ .174, 584670 INDEX