2016 Ram 3500 Chassis Cab wiring

11. Replace bulb(s) as necessary.
CAUTION!
•Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
• Always use the correct bulb size and type for
replacement. An incorrect bulb size or type may
overheat and cause damage to the lamp, the bulb
socket, or the lamp wiring.
NOTE: There are access covers over both headlamp bulb
access holes in the quad front lamp unit housing (if
equipped). These covers MUST be reinstalled after the
bulb has been replaced.
Fog Lamps — If Equipped
1. Reach under and behind the front bumper to access the back of the front fog lamp housing.
2. Disconnect the fog lamp wiring harness connector from the fog lamp bulb.
3. Rotate the bulb counterclockwise ¼ turn to unlock the bulb from the housing.
4. Pull the bulb straight out from the housing.
CAUTION!
Do not contaminate the bulb glass by touching it
with your fingers or by allowing it to contact other
oily surfaces. Shortened bulb life will result.
7
MAINTAINING YOUR VEHICLE 617

Traction............................... .430
Traction Control ......................... .445
Trailer Sway Control (TSC) ..................451
Trailer Towing .......................... .502
Cooling System Tips .....................519
Hitches ............................. .507
Minimum Requirements ..................509
Mirrors ............................. .137
Trailer And Tongue Weight ................508
Wiring .............................. .517
Trailer Towing Guide ...................... .508
Trailer Weight ........................... .508
Transfer Case ........................... .593
Electronically Shifted .....................423
Fluid ............................... .624
Transmission ........................... .593
Automatic ........................ .404, 593
Fluid ............................... .624
Shifting ............................. .401Transmitter Battery Service (Remote Keyless Entry) . .29
Transmitter Programming (Remote Keyless Entry) . . .24
Transmitter, Remote Keyless Entry (RKE)
.........24
Transporting Pets .........................112
Tread Wear Indicators ..................... .477
Turn Signals ..................... .168, 263, 615
Uconnect Customer Programmable Features ........317, 335
Operation ............................ .339
Uconnect Settings ...................... .307
Uconnect Settings ....................317, 335
Uconnect 8.4A/8.4AN Voice Recognition Additional Information ...................390
Do Not Disturb ....................... .389
General Information .....................390
Siri Eyes Free ......................... .389
Uconnect 8.4 Settings Customer Programmable Features — Units .....326
10
INDEX 663

INSTALLATION OF RADIO TRANSMITTING
EQUIPMENT
Special design considerations are incorporated into this
vehicle’s electronic system to provide immunity to radio
frequency signals. Mobile two-way radios and telephone
equipment must be installed properly by trained person-
nel. The following must be observed during installation.
The positive power connection should be made directly
to the battery and fused as close to the battery as possible.
The negative power connection should be made to body
sheet metal adjacent to the negative battery connection.
This connection should not be fused.
Antennas for two-way radios should be mounted on the
roof or the rear area of the vehicle. Care should be used
in mounting antennas with magnet bases. Magnets may
affect the accuracy or operation of the compass on
vehicles so equipped.The antenna cable should be as short as practical and
routed away from the vehicle wiring when possible. Use
only fully shielded coaxial cable.
Carefully match the antenna and cable to the radio to
ensure a low Standing Wave Ratio (SWR).
Mobile radio equipment with output power greater than
normal may require special precautions.
All installations should be checked for possible interfer-
ence between the communications equipment and the
vehicle’s electronic systems.