2016 Peugeot Traveller run flat

.
.
Driving recommendations 192
Starting-switching off the engine, manual key, remote control

1
95
Starting-switching off the engine
"Keyless
e
n
try and Starting"
1
98
Parking brake

2
01
Hill start assist

2
02
5-speed manual gearbox
2

03
6-speed manual gearbox
2

03
Gear ef ficiency indicator

2
04
Automatic gearbox
20

5
ele

ctronic gearbox
2
10
Stop & Start

2
14
Head-up display

2
18
Memorising speeds
2

20
Speed limit recognition
2

21
Speed limiter
2

25
Cruise control

2
28
Dynamic cruise control

2
32
Collision Risk Alert and Active Safety Brake
23

9
Lane departure warning system

2
45
Fatigue detection system

2
47
Blind spot monitoring system

2
49
Parking sensors
2

52
Reversing camera, interior mirror

2
54
180° rear vision

2
55
Under-inflation detection
2

58Fuel tank
2 61
Diesel misfuel prevention 26
2
Snow chains

2
64
to

wing a trailer
2
65
en

ergy economy mode
26
6
Accessories
2

67
Roof bars / Roof rack

2
68
Changing a wiper blade
2

69
B o nnet


271
Diesel engine
2

72
Checking levels

2
73
Checks


276
AdBlue
® and SCR system
(BlueHDi Diesel) 2 78
Warning triangle (stowing)
2

82
to

ol box
2
82
te

mporary puncture repair kit
2
85
Changing a wheel
2

91
Changing a bulb
2

98
Changing a fuse
3

11
12 V battery

3
16
to

w i n g

3 2 0
Running out of fuel (Diesel)

3
22Dimensions


323
en

gines

324
Weights

324
Identification markings
3
27
Driving
Practical information
In the event of a breakdownte chnical data
emergency or assistance 328
Pe ugeot Connect Nav 3 31
P
e

ugeot Connect Radio
4
19
Bluetooth
® audio system 4 73
Audio equipment and telematics
Alphabetical index
Contents

4
exterior
Filler cap, fuel tank 261-262
Misfuel prevention 26 2-263
Running out of Diesel fuel, priming


322
un

der-inflation detection
2
58-260
ty

res, pressures
2
59 -260, 327
e

SC system
1
59 -161
ABS,
e
B
FD
1
59 -160
DSC, ASR

1
61
gr

ip control
16
1, 162-163
Snow chains

2
64
Front doors

6
5
AdBlue
® tank 2 78-281to
ol box 2 82-284
Automatic illumination of headlamps
1
47
Automatic headlamp dipping
151-152
Direction indicators
1

46
Adjusting the headlamp beam height
1

53
Changing front bulbs
2

98-304
Headlamp wash
1

56
Panoramic sunroof
1

20
Accessories


267-268
op

ening the bonnet

2

71 Key

45
Key, remote control
4
5 -50
Changing the battery, reinitialisation
5
1
Keyless e
n
try
and Starting
5
2-62
Changing the battery, reinitialisation
6
2
Starting - switching off the engine 198 -20 0
-
k
ey, remote control
-

K

eyless
e
n

try and Starting
remote control
Locking - unlocking from inside

6
4
Alarm


83-85
Speed limit
recognition
221-224
Collision Risk Alert

2

39 -242
Active Safety Brake

2

42-244
Changing a wiper blade

269
Automatic wiping
1

55-156
Front demisting, defrosting
1

31
Front foglamps

1

45, 299, 304
Daytime running lamps

1

47, 300
Cornering lighting
1

50
Parking sensors
2

52-253
to

wing


320-321
over view

20
Warning / indicator lampStateCause Action / Observations
Foot on the
brake pedal fixed.
th

e brake pedal must be pressed. With an automatic or electronic gearbox, press the brake pedal, engine running, before releasing the
parking brake, to release the selector lever and come
out of position P or N.
If you wish to release the parking brake without
pressing the brake pedal, this warning lamp will
remain on.
Foot on the
clutch fixed.
In the S
t

o
P m
ode of Stop & Start,
the change to S
tA

R
t
mode is denied
because the clutch pedal is not fully
down. If your vehicle has a manual gearbox, you must
declutch fully to allow the change to engine
S
t

A R
t
m o d e .
Under-inflation
fixed, accompanied by
an audible signal and
a message.
th

e pressure in one or more tyres is
too low. Check the tyre pressures as soon as possible.
th

is check should preferably be carried out when the
tyres are cold.
You must reinitialise the system after the adjustment
of one or more tyre pressures and after changing one
or more wheels.
For more information on Under-inflation detection ,
refer to the corresponding section.
+ flashing then fixed,
accompanied by the
Service warning lamp.
th

e system has a fault: the tyre
pressures are no longer monitored. Check the tyre pressures as soon as possible.
Have the system checked by a P
e

ugeot dealer or a
qualified workshop.
Instruments

124
take care of passengers' feet when
manoeuvring the assembly.Incorrect use of the table could cause
serious injury.
Never use the table open or unfolded
while the vehicle is being driven. An
object on the table is turned into a
projectile under heavy braking.
en

sure that the table is correctly stowed
in the low position before moving off.
Never use the table tops as seats or
lean on them.
A label on the table is a reminder of this. Never place hot objects such as
casseroles or cooking pans on the
table, you risk damaging its surface
(risk of fire).
With the table deployed, each top can
support a maximum of 10 kg. Failure to
observe this maximum load introduces
the risk of damaging all or part of the
table module.
Never raise the table when it is between
individual seats; this risks damaging the
table tops.
Storage off the runner
If removing and storing the table
out of the vehicle, ensure that it is
placed in a clean area, so as to avoid
introducing any foreign bodies into the
mechanisms.
th

e table assembly must be placed on
a flat and level sur face when out of the
vehicle, resting on the guide so as to
avoid damaging the visible parts.
Caution, when out of the vehicle, the
table leans to the right or left when put
down.
ease of use and comfort

209
When the ignition is on, a message
appears in the instrument panel
screen to indicate a gearbox fault.
Operating fault
In this case, the gearbox switches to back-up
mode and is locked in 3rd gear. You may feel
a substantial knock when changing from P
to R and from N to R.
t
h
is will not cause any
damage to the gearbox.
Do not exceed 60 mph (100 km/h), local speed
restrictions permitting.
Have it checked by a P
e

ugeot dealer or a
qualified workshop. You risk damaging the gearbox:
-

i
f you press the accelerator and
brake pedals at the same time
(braking or acceleration must be
done only with the right foot),
-
i
f you force the selector from
position P to another position when
the battery is flat.
to r
educe fuel consumption when
stationary for long periods with the
engine running (traffic jam...), position
the selector at N and apply the parking
brake.
Stopping the vehicle
A stiff point may be noticed when
moving to position P .
If the selector is not in position P ,
when the driver's door is opened or
approximately 45 seconds after the
ignition is switched off, there is an
audible signal and a message appears.
F

R
eturn the selector to position P ;
the audible signal stops and the
message disappears.
Before switching off the engine, select
position


P then apply the parking brake to
immobilise the vehicle. In all circumstances, ensure that the
selector is in position P before leaving
your vehicle.
on a s
teep slope with a loaded
vehicle, press the brake pedal , select
position

P
, apply the parking brake then
release the brake pedal.
6
Driving

264
Snow chains
In wintry conditions, snow chains improve
traction as well as the behaviour of the vehicle
when braking.
th
e snow chains must be fitted only to
the front wheels.
ta

ke account of the legislation in force
in your country on the use of snow
chains and the maximum running speed
authorised. Avoid driving with snow chains on roads
that have been cleared of snow, to
avoid damaging your vehicle's tyres and
the road sur face. If your vehicle is fitted
with alloy wheels, check that no part of
the chain or its fixings is in contact with
the wheel rim.
us

e only the chains designed to be fitted to the
type of wheel fitted to your vehicle:
You can also use snow socks.
For more information on snow chains, contact a
P
e

ugeot dealer or a qualified workshop.
Advice on installation
F If you have to fit the chains during a journey, stop the vehicle on a flat sur face
on the side of the road.
F

A
pply the parking brake and position any
wheel chocks to prevent movement of your
vehicle.
F

F
it the chains following the instructions
provided by the manufacturer.
F

M
ove off gently and drive for a few
moments, without exceeding 30 mph
(50 km/h).
F

S
top your vehicle and check that the snow
chains are correctly tightened.
or

iginal
tyre size
ty

pe of chain.
215/65 R16 12 mm links
215/60 R17 -
225/55 R17
It is strongly recommended that before
you leave, you practise fitting the snow
chains on a level and dry sur face.
Practical information

266
energy economy mode
System which manages the duration of use of certain functions to conserve a sufficient level of
charge in the battery.
After the engine has stopped, you can still use functions such as the audio and telematics
system, windscreen wipers, dipped beam headlamps, courtesy lamps, etc. for a maximum
combined duration of about forty minutes.
Switching to economy
mode
A message appears in the instrument panel
screen indicating that the vehicle has switched
to economy mode and the active functions are
put on standby.
If a telephone call is being made at this time, it
will be maintained for around 10 minutes with
the Bluetooth hands-free system of your audio
system.
Exiting economy mode
these functions are reactivated automatically
next time the vehicle is driven.
In order to restore the use of these functions
immediately, start the engine and let it run:
-

f
or less than ten minutes, to use the
equipment for approximately five minutes,
-

f
or more than ten minutes, to use the
equipment for up to approximately
thirty


minutes.
Let the engine run for the duration specified to
ensure that the battery charge is sufficient.
Do not repeatedly and continuously restart the
engine in order to charge the battery.
A flat battery prevents the engine from starting.
For more information on the 12 V batter y , refer
to the corresponding section.
Load reduction mode
System which manages the use of certain
functions according to the level of charge
remaining in the battery.
When the vehicle is being driven, the load
reduction function temporarily deactivates
certain functions, such as the air conditioning,
the heated rear screen...
th

e deactivated functions are reactivated
automatically as soon as conditions permit.
Practical information

289
F Connect the compressor's electric plug to the vehicle's 12 V socket.
F

S
tart the vehicle again and leave the
engine running. F
A djust the pressure using the compressor
(to inflate: switch B in position "I" ; to
deflate: switch B in position "O" and press
button C ), in accordance with the vehicle's
tyre pressure label (located on the left-
hand door aperture).
A l

oss of pressure indicates that the
puncture has not been fully plugged;
contact a P
e

ugeot dealer or qualified
workshop for assistance.
F

R
emove and stow the kit.
F

D
rive at reduced speed (50 mph [80 km/h]
max) limiting the distance travelled to
approximately 120 miles (200 km).
As soon as possible, go to a P
e

ugeot
dealer or a qualified workshop.
You must inform the technician that you
have used this kit. After inspection, the
technician will advise you on whether
the tyre can be repaired or if it must be
replaced.
Removing the cartridge
F Stow the black pipe.
F D etach the angled base from the white pipe.
F

S
upport the compressor vertically.
Beware of discharges of fluid.
th

e expiry date of the fluid is indicated
on the cartridge.
th

e sealant cartridge is designed for
single use; even if only partly used, it
must be replaced.
After use, do not discard the cartridge
into the environment, take it to an
authorised waste disposal site or a
P
e

ugeot
d
ealer.
Do not forget to obtain a new sealant
cartridge, available from P
e

ugeot
dealers or from a qualified workshop.
F
u
n
screw the cartridge from the bottom.
8
In the event of a breakdown