2016 Peugeot Expert VU Owner's Manual

327
Expert_en_Chap08_En-cas-de-panne_ed01-2016
on vehicles fitted with Diesel engines, the fuel
system must be primed if you run out of fuel.
For all versions other than BlueHDi, refer to the
corresponding engine compartment view.
Running out of fuel (Diesel)
For more information on Diesel misfuel
prevention, refer to the corresponding
section. F
A dd at least five litres of Diesel fuel to the
tank.
F
o
p
en the bonnet.
F

I
f necessary, unclip the styling cover for
access to the priming pump.
F

S
queeze and release the priming pump
repeatedly until resistance is felt (there
may be resistance at the first press).
F
o
p
erate the starter to start the engine
(if the engine does not start at the first
attempt, wait around 15 seconds before
trying again).
F

I
f the engine does not start after a few
attempts, operate the priming pump again
then start the engine.
F

R
efit the styling cover and clip it in place.
F

C
lose the bonnet.
1.6 HDi engine
(except BlueHDi)
If the engine does not start first time,
don't keep trying but start the procedure
again from the beginning.
BlueHDi engine
F Fill the fuel tank with at least five litres of Diesel.
F

S
witch on the ignition (without starting the
engine).
F

W
ait around 6 seconds and switch off the
ignition.
F

R
epeat the operation 10 times.
F
o
p
erate the starter to run the engine.
Other engines
F Add at least five litres of Diesel fuel to the tank.
F
o
p
en the bonnet.
F

I
f necessary, unclip the styling cover for
access to the priming pump.
F

S
queeze and release the priming pump
repeatedly until resistance is felt (there
may be resistance at the first press).
F
o
p
erate the starter to start the engine
(if the engine does not start at the first
attempt, wait around 15 seconds before
trying again).
F

I
f the engine does not start after a few
attempts, operate the priming pump again
then start the engine.
F

R
efit the styling cover and clip it in place.
F

C
lose the bonnet.
8
In the event of a breakdown

328
Expert_en_Chap09_caracteristiques-techniques_ed01-2016
Mirrors folded
Side-hinged doors TailgateC o m p a c t ( L1)
Standard (L2)
Long (L3)
* Increased payload.
** Payload increased with high body.
*** Depending on the country of sale.
Dimensions (in mm)
these dimensions have been measured on an unladen vehicle.
technical data

329
Expert_en_Chap09_caracteristiques-techniques_ed01-2016
* With moduwork, flap removed.
C o m p a c t ( L1)
Standard (L2)
Long (L3)
9
technical data

330
Expert_en_Chap09_caracteristiques-techniques_ed01-2016
Mirrors folded
Side-hinged doors TailgateC o m p a c t ( L1)
Standard (L2)
Long (L3)
* Increased payload.
** Payload increased with high body.
*** Depending on the country of sale.
technical data

331
Expert_en_Chap09_caracteristiques-techniques_ed01-2016
Platform cab
9
technical data

332
Expert_en_Chap09_caracteristiques-techniques_ed01-2016
Engines
Engine characteristics
the engine characteristics (capacity, maximum
power, maximum power speed, fuel, Co2
emissions...) for your vehicle are given in the
registration document, as well as in sales
brochures.
the

se characteristics correspond to the
values type-approved on a test bed, under
conditions defined in European legislation
(Directive


1999/99/EC).
For more information, contact a PE
u

g
Eo
t
dealer or a qualified workshop.
Weights
the kerb weight is equal to the unladen
weight + driver (75 kg).
th

e gt
W a
nd towed load values indicated
apply up to a maximum altitude of
1
000 metres; the towed load mentioned
must be reduced by 10 % for every additional
1
000 metres..
th

e weight of the braked trailer can be
increased, within the
gt
W l
imit, on condition
that the
g
V
W of the towing vehicle is reduced
by the same amount.
the

recommended nose weight is the vertical
load on the towbar ball (removable with or
without tools). High ambient temperatures may result
in a reduction in the per formance of
the vehicle to protect the engine; when
the ambient temperature is higher
than 37 °C, limit the towed weight.
If the ambient temperature is high, it
is recommended that the engine be
allowed to idle for 1 to 2 minutes after
the vehicle comes to a stop, to facilitate
its cooling.
to

wing with a lightly loaded vehicle can
adversely affect roadholding.
Braking distances are increased when
towing a trailer.
Never exceed 60 mph (100 km/h) when
towing (comply with the legislation in
force in your country).
GV W:

gross vehicle weight, the maximum authorised vehicle weight.
GT W:
gross train weight, the maximum authorised weight of
vehicle plus trailer.
Weights and towed
loads
the maximum weights and towed loads for your
vehicle are given are given in the registration
document, as well as in sales brochures.
th

ese values are also present on the
manufacturer's plate or label.
For more information, contact a PE
u

g
Eo
t
dealer or a qualified workshop.
technical data

333
Expert_en_Chap09_caracteristiques-techniques_ed01-2016
EuRo 4 and 5 Diesel engines
* Increased payload.Engine
Engine
code Gearbox Engine oil capacity
with filter replacement (litres) LengthUnbraked trailer
weight (kg)
8-9 seats Trailer nose weight
(kg)
8-9 seats
1.6 litre HDi 909HF
(DV6Du) M
anual
(5-speed) -L1, L2, L3
--
L 2 *, L 3 * -
2 litre HDi 150AHX
(DW10F) Manual
(6-speed)
6 .1L1, L2, L3
-
L 2 *, L 3 * -
E A t
6

automatic (6-speed) L1, L2, L3
-
L 2 *, L 3 * -
9
technical data

334
Expert_en_Chap09_caracteristiques-techniques_ed01-2016
EngineEngine
code Gearbox Engine oil capacity
with filter replacement (litres) LengthUnbraked trailer
weight (kg)
8-9 seats Trailer nose
weight (kg)
8-9 seats
2 litre BlueHDi
150AHX
(DW10FD) Manual
(6-speed)
6 .1L1, L2, L3
--
L 2 *, L 3 * -
E A t
6

automatic (6-speed) L1, L2, L3
-
L 2 *, L 3 * -
* Increased payload.
technical data