2016 Peugeot Boxer charging

7
boxer_en_Chap01_Vue-ensemble_ed01-2015
Seat belts 106-108
Airbags 110-112
Deactivating the passenger's front airbag 111, 11 4
Parking brake, handbrake

98
Front seats, adjustments


71-72
Seat with variable damping


72
2-seat bench


73 Child seats


1
13-116, 119-120
12 volt socket,
u

SB port

79, 81-82 Battery (+), charging,


starting 142-144
e

arth point (-)
128, 142
Fuses in the right hand door pillar 145, 147
IntErIor
Seats / rear bench
seats 74-75
Rear heating / air conditioning

65-66
Sliding side door


20
Folding foot board


84
Sliding side windows


83 Rear view mirror


85
Lane departure warning system
105
Cab courtesy lamp
80, 152
Changing a courtesy lamp bulb

149, 152
ISOFIX mountings 117-118
tools, jack


76, 156
Accessories

124
Load space


81-82
●
stowing rings,
● load retainer ,
●

interior roof box,
●


side trims,
●


12 volt socket,
●


courtesy lamp,
torch

83
1
OVeRVIeW
Location

25
boxer_en_Chap02_Pret-a-Partir_ed01-2015
Warning/indicator lampisindicates Solution - action
Coolant
temperature on with the
needle in the red
zone.
an abnormal increase.
Park and switch off the ignition. Allow the system to cool
sufficiently. Visually check the level.
on H in the red
zone. the coolant temperature is too
high. "Checks - Levels and checks" section.
Contact a P
euge O t
dealer or a qualified workshop.
e

ngine oil
pressure on while driving. that the pressure is too low.
Park and switch off the ignition. Allow the lubrication
system to cool in order to check its level.
"Checks - Levels and checks" section.
continuously on,
even though the
level is correct. a major fault.
Contact a P
euge O t
dealer or a qualified workshop.
flashing, for a


few seconds,
with a message
in the screen. a high level of deterioration of
the engine oil. Have the engine oil changes as soon as possible. After
the second level of alert, engine performance will be
limited. Your vehicle's programmed service schedule is
not altered.
Battery charge on.
a fault with the charging
system. Check the battery terminals…
"Quick help - Flat battery" section.
continuously on,
fixed or flashing
in spite of the
checks. an ignition or injection fault.
Have it checked by a P
euge O t
dealer or a qualified

workshop.
Door or bonnet
open detection on.that a door or the bonnet is not
closed correctly. Check that the cab doors, the rear and side doors and
the bonnet are closed.
Instruments and controls
2
rEAdY to SEt oFF

83
boxer_en_Chap03_ergo-et-confort_ed01-2015
Sliding side windows
Depending on the vehicle's equipment, the
side windows of row 2 can be opened.
Squeeze the two controls then slide the
window.
torch
If your vehicle has one, the magnetic torch is
located at the rear courtesy lamp.
A lamp is locatred in the centre of the torch
base.
Remove the torch from its base by
pressing the button then pivoting the torch
downwards by 90 degrees.
to switch on the torch, slide the switch

forwards.
to change the 4 batteries (NiMH type),


remove the protective cover, located on the
torch. With the vehicle stationary, key in the
ignition switch or removed, recharging
and lighting from the torch stops after
around 15 minutes.
t
he torch batteries recharge automatically
while driving.
to put the torch back in place, engage

it in the notches on the base and pivot it
upwards.
While driving, the window must be


closed or secured in an intermediate
position.
Do not extend long objects outside the
vehicle via the window.
Practical information
3
EASE oF uSE and coMFort

143
boxer_en_Chap08_Aide-Rapide_ed01-2015
Access to the battery
unscrew the 6 access cover retaining
screws.
Lift of
f or remove completely the access
cover.
Press lever 1 downwards to spread the
clamp.
Remove the terminal 2 from the negative (-)
post.
t
he batteries contain harmful
substances such as sulphuric acid and
lead.
t
hey must be discarded in accordance
with the provisions of the law and must not,
in any circumstances, be discarded with
household waste.
take used batteries to a special collection

point.
t

he charging operation must be carried
out in a ventilated area away from
naked flames or any possible sources of
sparks to eliminate the risk of explosion
and fire.
Do not attempt to charge a frozen battery: it
must first be thawed to eliminate the risks of
explosion. If the battery has frozen, before
charging it have it checked by a specialist
who will check that the internal components
have not been damaged and that the
container is not cracked, which could mean
that there is a risk of a leak of toxic and
corrosive acid.
Proceed with a slow charge charge at low
current for a maximum pf about 24 hours to
avoid damaging the battery. Before disconnecting the battery, you must
wait for 2 minutes after switching off the
ignition.
Never disconnect a terminal when the
engine is running.
Never charge a battery without first
disconnecting the terminals.
Close the windows and doors before
disconnecting the battery.
After every reconnection of the battery,
switch on the ignition and wait 1 minute
before starting to allow the electronic
systems to be initialised. If slight difficulties
are experienced after this, please contact a
P
euge O t
dealer or a qualified workshop.
Discharged battery
QuICK HeLP
8

144
boxer_en_Chap08_Aide-Rapide_ed01-2015
the presence of this label, in particular
with the Stop & Start system, indicates
the use of a 12 V lead-acid battery with
special technology and specification; the
involvement of a P
euge O t
dealer or

a qualified workshop is essential when
replacing or disconnecting the battery.
After refitting the battery by a
P
euge O t
dealer or a qualified

workshop, the Stop & Start system will
only be active after a continuous period of
immobilisation of the vehicle, a period which
depends on the climatic conditions and the
state of charge of the battery (up to about
8 hours).
It is advisable to disconnect the
negative (-) terminal of the battery
if the vehicle is not to be used for a
period of more than one month.
t

he description of the battery charging
procedure is given as an indication only.
If the battery has been disconnected
for some time, it may be necessary to
reinitialise the following functions:
-

the display parameters (date, time,


language, distance unit and temperature
unit),
-

the radio stations,
-


the central locking.
Some settings are cleared and must be


reprogrammed, consult a P
euge
O
t
.
If your vehicle is fitted with a tachograph or


an alarm, disconnection of the negative (-)
terminal of the battery (located under the
floor on the left-hand side, in the cab) is
recommended if the vehicle is not to be used
for a period of more than 5 days.
Discharged battery

183
boxer_en_Chap10a_Autoradio_Fiat-tactile-1_ed01-2015
touch screen Audio-telematic system
Multimedia audio system - Bluetooth® telephone - GPS navigation
Contents
First steps
1 84
glos

sary

185
Steering mounted controls

1
86
Menus
187
Radio


188
DAB (Digital Audio Broadcasting) radio

1
92
Media


19 4
Navigation
2

02
te

lephone

206
Vehicle information
2

10
Settings


212
Voice commands

2
22
th

e system is protected in such a way that it will only operate in
your vehicle. As as safety measure, the driver must only carry out operations
which require prolonged attention while the vehicle is stationary.
When the engine is switched off and to prevent discharging of
the battery, the system switches off following the activation of
the energy economy mode.
touch Screen Audio - telematic System
AuDIO and teLeMAtICS
10

198
boxer_en_Chap10a_Autoradio_Fiat-tactile-1_ed01-2015
uSB player
the system builds playlists (in temporary
memory), an operation which can take from
a few seconds to several minutes at the first
connection.
Reduce the number of non-music files and the
number of folders to reduce the waiting time.
th
e playlists are updated every time the
ignition is switched off or connection of a
u
S
B
memory stick. However, the audio system
memorises these lists and if they are not
modified, the loading time will be shorter. Insert a u
S
B memory stick or connect a
peripheral device to the u
S
B port in the central
storage space, provided for transferring data to
the system, using a suitable cable
(not supplied).
Auxiliary socket (Au x)
Connect the portable device (MP3 player…) to
the auxiliary Jack socket using an audio cable
(not supplied).
Located on the centre console, this port is used
only for powering and recharging the portable
device connected.
uSB port
First adjust the volume on your portable device
(to a high level).
th en adjust the volume of your
audio system.
Control is via the portable device.
th

e functions of the device connected to the
"A
uX

" socket are controlled directly from the
device itself: changing track / folder / playlist or
starting/ending/pausing play using the audio
system control panel or steering mounted
controls is therefore not possible.
Do not leave the cable of your portable device
connected to the A
uX s

ocket when not in use,
to avoid possible noises from the speakers.
touch Screen Audio - telematic System

231
boxer_en_Chap10b_Autoradio_Fiat-4_ed01-2015
Audio system
Multimedia audio system - Bluetooth® telephone
Contents
First steps 2 32
Steering mounted controls
23

3
Radio
234
Media


236
te

lephone
2
38
Settings
2

39
Voice commands

2
40
th

e system is coded in such a way that it will only operate in
your


vehicle. As a safety measure, the driver must only carry out operations
which require prolonged attention while the vehicle is stationary.
When the engine is not running and to prevent discharging of the
battery, the audio system may switch off following activation of
energy economy mode.
Audio System
AuDIO and teLeMAtICS
10