2016 NISSAN JUKE heater


> (GLW    0RGHO )' @
SAA0451
CD/USB MEMORY CARE AND
CLEANING
GUID-64EAAC34-D3E6-47F3-841B-A7464B111E8A
CDGUID-72A0FA4E-7343-4A22-B467-F4E3857EF7C8.Handle a CD by its edges. Never touch the
surface of the disc. Do not bend the disc.
. Always place the discs in the storage case
when they are not being used.
. To clean a disc, wipe the surface from the
center to the outer edge using a clean, soft
cloth. Do not wipe the disc using a circular
motion.
Do not use a conventional record cleaner or
alcohol intended for industrial use. .
A new disc may be rough on the inner and
outer edges. Remove the rough edges by
rubbing the inner and outer edges with the
side of a pen or pencil as illustrated.
USB memoryGUID-709BE949-E9B3-4FAB-B7E0-5AF11C267158.Do not touch the terminal portion of the USB
memory.
. Do not place heavy objects on the USB
memory.
. Do not store the USB memory in very humid
locations.
. Do not expose the USB memory to direct
sunlight.
. Do not spill any liquids on the USB memory.
Refer to the USB memory Owner's Manual for
the details.
SAA3383
1. SOURCE select switch
2. Tuning switch
3. VOLUME control switch
STEERING WHEEL SWITCH FOR
AUDIO CONTROL
GUID-397ACA65-CDE2-45A0-908C-5A518FD11FB7The audio system can be operated using the
controls on the steering wheel.
SOURCE select switchGUID-75DA39CD-BA48-480A-9F30-CF5FAEEBA12BPush the SOURCE select switch to change the
mode to available audio source.
Heater, air conditioner, audio and phone systems4-73
&RQGLWLRQ


> (GLW    0RGHO )' @
4-74Heater, air conditioner, audio and phone systems
VOLUME control switchGUID-2B953C64-A296-4323-9900-C814A2B80F0EPush up or down the VOLUME control switch to
increase or decrease the volume.
Tuning switchGUID-1A426B03-BA49-4A51-88E3-3E3275A1C5F0
AM and FM radio:GUID-F83C168B-173D-4313-B631-F712588C0463.Push the tuning switch for less than 1.5
seconds to change the next or previous
radio preset.
. Push the tuning switch for more than 1.5
seconds to seek the next or previous radio
station.
SXM operation (if so equipped):
GUID-F83C168B-173D-4313-B631-F712588C0463. Tilt up/down for less than 1.5 seconds to
increase or decrease the preset station.
. Tilt up/down for more than 1.5 seconds to
go to the next or previous category.
iPod


> (GLW    0RGHO )' @
SAA2102
Type A (if so equipped)
SAA2374
Type B (if so equipped)
ANTENNAGUID-2E6EC723-5024-4ED7-8C53-2005D67806B8To remove the antenna, hold the bottom of the
antenna and turn it counterclockwise.
To install the antenna, turn the antenna clock-
wise and tighten.
CAUTION
.To avoid damaging or deforming the
antenna, be sure to fold down (if so
equipped) or remove the antenna
under the following conditions.
Ð The vehicle enters a garage with
a low ceiling.
Ð The vehicle is covered with a car cover.
. Be sure that antenna is removed
before the vehicle enters an auto-
matic car wash.
. Always properly tighten the antenna
rod during installation. Otherwise,
the antenna rod may break during
vehicle operation.
GUID-EB2565B8-2F32-44D1-884B-3D9157E86821This vehicle is equipped with Smartphone
Integration technology. This allows many com-
patible Smartphone applications to be displayed
and easily controlled through the vehicle's
touchscreen.
NOTE:
A compatible smartphone and registration
is required to use mobile applications or to
access connected features of certain vehi-
cle applications.
REGISTERING WITH NISSANCON-
NECTSMAPPGUID-09282224-C822-4A6E-B841-C70746449602To use the Smartphone Integration feature, it is
necessary for the user to register. In order to
register, visit the NissanConnect
SMwebsite,
www.nissanusa.com/connect/ and sign up or
create an account through the prompts on the
NissanConnect
SMApp. Once registered, down-
load the NissanConnectSMApp from your
compatible phone's application download
source and then log into the application. If you
already have an account created through the
App, please log in.
Heater, air conditioner, audio and phone systems4-75
NISSANCONNECTSMAPP
SMARTPHONE INTEGRATION
&RQGLWLRQ


> (GLW    0RGHO )' @
4-76Heater, air conditioner, audio and phone systems
CONNECT PHONEGUID-F9527F2D-48B7-41BE-B654-8CF52A911A5ATo use this feature, a compatible smartphone
must be connected via Bluetooth


> (GLW    0RGHO )' @
4-78Heater, air conditioner, audio and phone systems
automatically after Siri


> (GLW    0RGHO )' @
4-80Heater, air conditioner, audio and phone systems
GUID-433608FE-D4D9-4693-ADC1-026C2CCCF895When installing a car phone or a CB radio in
your vehicle, be sure to observe the following
precautions, otherwise the new equipment may
adversely affect the electronic control modules
and electronic control system harness.
WARNING
.A cellular phone should not be used
for any purpose while driving so full
attention may be given to vehicle
operation. Some jurisdictions prohi-
bit the use of cellular phones while
driving.
. If you must make a call while your
vehicle is in motion, the hands-free
cellular phone operational mode (if
so equipped) is highly recom-
mended. Exercise extreme caution
at all times so full attention may be
given to vehicle operation.
. If a conversation in a moving vehicle
requires you to take notes, pull off
the road to a safe location and stop
your vehicle before doing so.
CAUTION
.Keep the antenna as far away as
possible from the electronic control
modules.
. Keep the antenna wire more than 8
in (20 cm) away from the electronic
control system harness. Do not
route the antenna wire next to any
harness.
. Adjust the antenna standing-wave
ratio as recommended by the man-
ufacturer.
. Connect the ground wire from the
CB radio chassis to the body.
. For details, consult a NISSAN deal-
er.
GUID-5BB4ADBF-288B-4991-9A88-69D70D6685E8
WARNING
.Use a phone after stopping your
vehicle in a safe location. If you
have to use a phone while driving,
exercise extreme caution at all
times so full attention may be given
to vehicle operation.
. If you are unable to devote full
attention to vehicle operation while
talking on the phone, pull off the
road to a safe location and stop
your vehicle.
CAUTION
To avoid draining the vehicle battery,
use a phone after starting the engine.
Your vehicle is equipped with the Bluetooth


> (GLW    0RGHO )' @
4-82Heater, air conditioner, audio and phone systems
IC Regulatory informationGUID-2EDEA324-802B-458F-970A-25372BA79E8D.Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the
device.
. This Class B digital apparatus meets all
requirements of the Canadian Interference-
Causing Equipment Regulations.
Bluetooth


> (GLW    0RGHO )' @
4-84Heater, air conditioner, audio and phone systems
.If you want to adjust the volume of the voice
feedback, push the (
-or+) button
on the steering wheel while being provided
with feedback. You can also use the radio
volume control knob.
Voice Prompt Interrupt:
GUID-F83C168B-173D-4313-B631-F712588C0463In most cases you can interrupt the voice
feedback to speak the next command by
pushing the
button on the steering wheel.
After interrupting the system, wait for a beep
before speaking your command.
One Shot Call:
GUID-F83C168B-173D-4313-B631-F712588C0463To use the system faster, you may speak the
second level commands with the main menu
command on the main menu. For example, push
the
button and after the tone say, ªCall
Redialº.
Operating tips:
GUID-F83C168B-173D-4313-B631-F712588C0463To get the best performance out of the voice
recognition system, observe the following:
. Keep the interior of the vehicle as quiet as
possible. Close the windows to eliminate
surrounding noises (traffic noises, vibration
sounds, etc.) , which may prevent the system
from recognizing voice commands correctly.
. Wait until the tone sounds before speaking a
command. Otherwise, the command will not
be received properly. .
Start speaking a command within 5 seconds
after the tone sounds.
. Speak in a natural voice without pausing
between words.
Voice commandsGUID-BE9F4E7E-EDF9-4F46-880E-05C5B1377DF1Voice commands can be used to operate the
Bluetooth