Page 273 of 358

operate in the frequency range of 280 to
433 MHz.
RReplace the batteries in garage door
remote controlA. This increases the like-
lihood that garage door remote control A
will transmit a strong and precise signal to
the integrated garage door opener.
RWhen programing, hold remote control A
at varying distances and angles from the
button which you are programing. Try vari-
ous angles at a distance between 2and
12 inches (5to 30 cm) or at the same angle
but at varying distances.
RIf another remote control is available for the
same garage door drive, repeat the same
programing steps with this remote control. Before performing these steps, make sure
that new batteries have been installed in
garage door drive remote control A.
RNote that some remote controls only trans-
mit for a limited amount of time (the indi-
cator lamp on the remote control goes out).
Press button Bon remote control Aagain
before transmission ends.
RAlign the antenna cable of the garage door
opener unit. This can improve signal recep-
tion/transmission.
Opening/closing the garage door
After it has been programmed, the integrated
garage door opener performs the function of
the garage door system remote control.
Please also read the operating instructions
for the garage door system.
XTurn the SmartKey to position 2in the igni-
tion lock (
Ypage 139).
XPress button ;,=or? which you have
programmed to operate the garage door.
Garage door system with a fixed code: indi-
cator lamp :lights up green.
Garage door system with a rolling code:
indicator lamp :flashes green.
The transmitter will transmit a signal as
long as the button is pressed. The trans-
mission is halted after a maximum of ten
seconds and indicator lamp :lights up
yellow.
XPress button ;,=or? again if neces-
sary.
Clearing the memory
Make sure that you clear the memory of the
integrated garage door opener before selling
the vehicle.
XTurn the SmartKey to position 2in the igni-
tion lock (
Ypage 139).
XPress and hold buttons ;and ?.
The indicator lamp initially lights up yellow
and then green.
XRelease buttons ;and ?.
The memory of the integrated garage door
opener in the rear-view mirror is cleared.
Features271
Stowage and features
Z
Page 287 of 358

XClean the inside and outside of the win-
dows with a damp cloth and a cleaning
agent that isrecommended and approved
by Mercedes-Benz.
Cleaning wiper blades
GWARNIN G
You could become trapped by th ewindshield
wiper sif they start moving while cleanin gth e
windshield or wiper blades .Ther eis aris kof
injury.
Always switch off th ewindshield wiper sand
th eignition before cleanin gth ewindshield or
wiper blades .
!Do not pull the wiper blade. Otherwise,
the wiper blade could be damaged.
!Do not clean wiperblades too often and
do not rub them too hard. Otherwise, the
graphite coating could be damaged. This
could cause wipernoise.
!Holdthe wiper arm securely when folding
back. The windshield could be damaged if
the wiper arm smacks against it suddenly.
XFoldthe windshield wiper arms away from
the windshield.
XCaref ullyclean the wiper blades with a
damp cloth.
XFo ldthe windshield wiper arms back again
before switching on the ignition.
Cleaning the exterior lighting
!Only use cleaning agents or cleaning
cloths which are suitable for plastic light
lenses. Unsuitable cleaning agents or
cleaning cloths could scratch or damage
the plastic light lenses.
XClean the plastic lenses of the exterior
lighting using a wet sponge and a mild
cleaning agent, e.g. Mercedes-Benz car
shampoo or cleaning cloths.
Cleaning the mirror turn signals
!Only use cleaning agents or cleaning
cloths that are suitable for plastic lenses.
Unsuitable cleaning agents or cleaning
cloths could scratch or damage the plastic lenses of the mirror turn signals.
XClean the plastic lenses of the mirror turn
signals inthe exterior mirror housing using
a wet sponge and mild cleaning agent, e.g.
Mercedes-Benz car shampoo or cleaning
cloths.
Cleaning the sensors
!If you clean the sensors with a power
washer, make sure that you keep a dis-
tance of at least 11.8 in(30 cm )betwee n
th evehicl e and the power washer nozzle.
Information about the correct distance is
available from the equipment manufac-
turer.
XClean sensors :of the driving systems
with water, car shampoo and a soft cloth.
Cleaning the exhaust pipe
GWARNING
The exhaust tail pipeand tail pipetrim can
become very hot. Ifyou come into contact
Care285
Maintenance and care
Z
Page 300 of 358

iRemove theSmartKey if you park th e
vehicl eand do no trequire any electrical
consumers. The vehicl ewill then use ver y
littl eenergy, thus conservin gbattery
power.
iIf th epowe rsupply has been interrupted,
e.g. if you reconnect th ebattery, you will
hav eto :
Rset th eclock ;see th eseparat eoperating
instructions.
On vehicles wit hCOMAND and anaviga-
tion system, th eclock is set automati-
cally.
Rreset th efunction for foldin gth eexterio r
mirror sin/out automatically, by foldin g
th emirror sout once (
Ypage 104).
Charging th ebatter y
GWARNIN G
Durin gchargin gand jump-starting, explosive
gase scan escape from th ebattery. There is a
ris kof an explosion .
Particularly avoid fire, open flames, creatin g
sparks and smoking. Ensur ethere is sufficien t
ventilation while chargin gand jump-starting.
Do no tlean ove r abattery.
GWARNIN G
Battery aci dis caustic. There is aris kof injury.
Avoid contact wit hskin ,eyes or clothing. Do
no tinhale any battery gases. Do no tlean ove r
th ebattery. Kee pchildren away from batter-
ies. Wash away battery aci dimmediately wit h
plenty of clean water and see kmedica latten -
tion .
GWARNIN G
A discharged battery can freez eat tempera-
tures belo wfreezin gpoint. Whe njump-start -
in gth evehicl eor chargin gth ebattery, gase s
can escape from th ebattery. There is aris kof
an explosion .
Allow thefrozen battery to thaw out before
chargin git or jump-starting.
!Only use battery chargers wit h amaxi-
mum chargin gvoltag eof 14.8 V.
!Only charg eth ebattery usin gth ejump-
startin gconnection point.
The jump-startin gconnection poin tis in th e
engin ecompartment.
If th eindicator/warnin glamp sdo no tligh tup
at low temperatures ,it is ver ylikely that th e
discharged battery has frozen .In this case,
you may neither charg eth ebattery no rjump-
start th evehicle. The servic elife of athawed-
out battery may be shorter. The startin gchar-
acteristics can be impaired, particularly at
low temperatures .Hav eth ethawed-out bat -
tery checke dat aqualified specialist work-
shop.
Read th ebattery charger' soperating instruc -
tion sbefore chargin gth ebattery.
XOpe nth ehood.
XConnect th ebattery charger to th epositive
terminal and ground poin tin th esam e
order as when connecting th edonor bat -
tery in th ejump-startin gprocedure
(
Ypage 299).
298Battery (vehicle)
Breakdown assistance
Page 355 of 358
Dimensions andweights
Model:Openin gheight
All model s(70.7 in)
(1796 mm)
Missin gvalues wer eno tavailable at time of
going to print .
Mercedes‑AMG
vehicles
Vehicle length163. 2in (4146 mm)
Vehicle length
when opening /
closing th eroof
Vehicle width
including exterior
mirror s79.0 in (2006 mm)
Vehicle height51.2 in (1301 mm)
Vehicle height ,
when opening /
closing th eroof
Wheelbase95.7 in (2430 mm)
Turning radius34.6 ft (10.5 5m)
Maximum trunk
load220 lb (100 kg)
All other models
Vehicle length162.8 in (4134 mm)
Vehicle length
when opening/
closing the roof170.0 in (4319 mm)
Vehicle width
including exterior
mirrors79.0 in (2006 mm)
Vehicle height51.3 in (1303 mm)
Vehicle height,
when opening/
closing the roof61.5 in (1561 mm)
Wheelbase95.7 in (2430 mm)
Turning radius34.5 ft (10.52 m)
Maximum trunk
load220 lb (100 kg)
Vehicle data353
Technical data
Z