2016 MERCEDES-BENZ GLE light

[x] Cancel search: light

Page 91 of 450

MERCEDES-BENZ GLE 2016  Owners Manual Opening the tailgate automatically You can open the tailgate automatically with the
SmartKey or the handle in the tailgate. X
Press and hold the �T button on the Smart-
Key until the tailgate opens.
o

Page 93 of 450

MERCEDES-BENZ GLE 2016  Owners Manual X
Open the tailgate. X
Insert mechanical key �D into the SmartKey
( Y
page 81).
Side windows
Important safety notes
G WARNING
While opening the side windows, body parts
could become trapped between th

Page 95 of 450

MERCEDES-BENZ GLE 2016  Owners Manual Vehicles with KEYLESS-GO: R
Release the sensor surfaces on the exterior
door handle to interrupt the closing proce-
dure. R
To open, pull the same door handle immedi-
ately and hold it firmly. The doo

Page 97 of 450

MERCEDES-BENZ GLE 2016  Owners Manual Problems with the side windows
G WARNING
If you close a side window again immediately after it has been blocked or reset, the side window
closes with increased or maximum force. The reversing feature

Page 98 of 450

MERCEDES-BENZ GLE 2016  Owners Manual ! Only open the sliding sunroof if it is free of
snow and ice. Otherwise, malfunctions may
occur.
Do not allow anything to protrude from the
sliding sunroof. Otherwise, the seals could be
damaged.
! T

Page 101 of 450

MERCEDES-BENZ GLE 2016  Owners Manual Problems with the sliding sunroof Your vehicle may be equipped with a sliding sunroof or a panorama roof with power tilt/sliding
panel. In the following section, the term "sliding sunroof" ref

Page 108 of 450

MERCEDES-BENZ GLE 2016  Owners Manual Problems with the seat heating Problem
Possible causes/consequences and �P Solutions
The seat heating has
switched off prematurely
or cannot be switched
on. The on-board voltage is too low because too

Page 109 of 450

MERCEDES-BENZ GLE 2016  Owners Manual Problems with the seat ventilation Problem
Possible causes/consequences and �P Solutions
The seat ventilation has
switched off prematurely
or cannot be switched
on. The on-board voltage is too low bec