2016 MERCEDES-BENZ GL key

[x] Cancel search: key

Page 102 of 462

MERCEDES-BENZ GL 2016  Owners Manual Proceed as follows if someone is trapped: R
Release the �7 button to interrupt the
closing procedure. R
Press and hold the �6 button to open.
Vehicles with KEYLESS-GO: R
Release the sensor surfaces on

Page 104 of 462

MERCEDES-BENZ GL 2016  Owners Manual Problems with the side windows
G WARNING
If you close a side window again immediately after it has been blocked or reset, the side window
closes with increased or maximum force. The reversing feature

Page 106 of 462

MERCEDES-BENZ GL 2016  Owners Manual lock. This function is available for up to five
minutes or until the driver's or front-
passenger door is opened.
Resetting
! If the sliding sunroof still cannot be
opened or closed fully after re

Page 111 of 462

MERCEDES-BENZ GL 2016  Owners Manual The seat belt should: R
fit snugly across your body R
be routed across the middle of your shoul-
der R
be routed in your pelvic area across the hip
joints X
Before starting off, adjust the rear-view m

Page 115 of 462

MERCEDES-BENZ GL 2016  Owners Manual Always make sure that the seat and backrest
are engaged as described: R
before traveling with a passenger on a seat
with the EASY-ENTRY/EXIT feature R
after you have adjusted the seat R
after the EASY

Page 121 of 462

MERCEDES-BENZ GL 2016  Owners Manual Therefore, do not switch the seat heating on
repeatedly.
Driver's and front-passenger seat
Rear seats
The three red indicator lamps in the button
indicate the heating level you have selected.
The

Page 122 of 462

MERCEDES-BENZ GL 2016  Owners Manual Problems with the seat heating Problem
Possible causes/consequences and �P Solutions
The seat heating has
switched off prema-
turely or cannot be
switched on. The on-board voltage is too low because t

Page 123 of 462

MERCEDES-BENZ GL 2016  Owners Manual Problems with the seat ventilation Problem
Possible causes/consequences and �P Solutions
The seat ventilation has
switched off prema-
turely or cannot be
switched on. The on-board voltage is too low b