2016 MERCEDES-BENZ GL brake sensor

Display messages
Possible causes/consequences and P Solutions
PRE-SAFE Functions
Currently Limite d
See Operator' s Man ‐
ual Adaptive Brake Assis t or th e PRE-SAF E ®
Brake is temporarily inop-
erative . Possibl e causes are:R
function is impaire d due to heav y rain or snow.R
th e rada r sensor system is temporarily inoperative, e.g. due to
electromagnetic radiation emitted by nearby TV or radi o sta-
tion s or other source s of electromagnetic radiation .R
Mercedes-AMG vehicles: ES P ®
is deactivatedR
th e system is outside th e operating temperature range.R
th e on-boar d voltag e is to o low.
Whe n th e causes state d abov e no longer apply, th e display mes -
sage disappears.
Adaptive Brake Assis t or th e PRE-SAF E ®
Brake is operative again .
If th e display message does no t disappear :X
Pull ove r and stop th e vehicl e safely as soo n as possible, payin g
attention to roa d and traffic conditions.X
Secur e th e vehicl e against rollin g away ( Y
page 189).X
Restart th e engine. X
Mercedes-AMG vehicles: reactivat e ES P ®
( Y
page 74).
PRE-SAFE Functions
Limite d See Opera‐
tor's Manual Adaptive Brake Assis t or th e PRE-SAF E ®
Brake is malfunctioning.
BA S PLU S or th e distanc e warnin g function may also hav e failed.X
Visit a qualified specialist workshop .298
Display messages
On-board computer and displays

Display messages
Possible causes/consequences and P Solutions
Radar Sensor s
Dirty See Opera‐
tor's Manual At leas t on e of th e following drivin g systems or drivin g safet y sys-
tems is temporarily restricted or inoperative: R
PRE-SAF E ®
Brake R
Active Lan e Keepin g Assis tR
Active Blind Spot Assis t
If th e rada r sensor system in fron t is dirty, Active Blind Spot Assis t
will no t perform a course-correcting brak e application .
Possibl e causes are: R
th e sensor s in th e radiato r trim and/o r in th e bumpers are dirtyR
th e function of th e drivin g system and/o r drivin g safet y system
is impaire d due to heav y rain or snow.
A warnin g tone also sounds.
Whe n th e causes state d abov e no longer apply, th e display mes -
sage disappears. Al l drivin g systems and drivin g safet y systems
are operative again .
If th e display message does no t disappear :X
Pull ove r and stop th e vehicl e safely as soo n as possible, payin g
attention to roa d and traffic conditions.X
Secur e th e vehicl e against rollin g away ( Y
page 189).X
Switc h of f th e engine.X
Clean th e sensor s in th e following location s ( Y
page 380):R
in th e radiato r trim R
in th e fron t bumper R
in th e rear bumper, particularl y in th e middle of th e rear
bumper X
Restart th e engine.
The display message disappears.
u Restraint sys . mal ‐
function Consul t
workshop The restrain t system is faulty.
The u warnin g lamp also lights up in th e instrumen t cluster.
G WARNIN G
The air bags or Emergency Tensioning Devices may either be trig-
gered unintentionally or, in th e event of an accident, may no t be
triggered .
There is an increase d ris k of injury.X
Visit a qualified specialist workshop .
Observ e th e additional information on restrain t systems
( Y
page 44) . Display messages 29 9
On-board computer and displays Z

Display messages
Possible causes/consequences and P Solutions
DISTRONIC PLU S off DISTRONIC PLU S has been deactivated ( Y
page 205).
If it was deactivated automatically, a warnin g tone also sounds.
DISTRONIC PLU S
available again DISTRONIC PLU S is operational again after havin g been tempo -
rarily unavailable . You can no w reactivat e DISTRONIC PLU S
( Y
page 205).
DISTRONIC PLU S Cur ‐
rently Unavailable
See Operator' s Man ‐
ual DISTRONIC PLU S is temporarily inoperative.
Possibl e causes are: R
function is impaire d due to heav y rain or snow.R
th e rada r sensor system is temporarily inoperative, e.g. due to
electromagnetic radiation emitted by nearby TV or radi o sta-
tion s or other source s of electromagnetic radiation .R
th e system is outside th e operating temperature range.R
th e on-boar d voltag e is to o low.
A warnin g tone also sounds.
Whe n th e causes state d abov e no longer apply, th e display mes -
sage disappears.
DISTRONIC PLU S is operational again .
If th e display message does no t disappear :X
Pull ove r and stop th e vehicl e safely as soo n as possible, payin g
attention to roa d and traffic conditions.X
Secur e th e vehicl e against rollin g away ( Y
page 189).X
Restart th e engine.
DISTRONIC PLU S
inoperative DISTRONIC PLU S is defective.
The following may hav e also failed:R
BA S PLU S R
PRE-SAF E ®
Brake
A warnin g tone also sounds. X
Visit a qualified specialist workshop .
DISTRONIC PLU S sus ‐
pended You hav e depressed th e accelerato r pedal . DISTRONIC PLU S is no
longer controllin g th e speed of th e vehicle.X
Remove your foot from th e accelerato r pedal .
DISTRONIC PLU S
- - - mph An activation condition fo r DISTRONIC PLU S is no t fulfilled .X
Chec k th e activation condition s fo r DISTRONIC PLU S
( Y
page 205).316
Display messages
On-board computer and displays

Display messages
Possible causes/consequences and P Solutions
Tir e Press. Moni‐
tor Currently
Unavailable Becaus e there is interferenc e from a stron g source of radi o waves,
no signal s from th e tire pressur e sensor s are detected. The tire
pressur e monitor is temporarily malfunctioning. X
Drive on .
The tire pressur e monitor restarts automatically as soo n as th e
problem has been resolved.
Tir e Press. Sen ‐
sor(s) Missin g There is no signal from th e tire pressur e sensor of on e or several
wheels. The pressur e of th e affecte d tire is no t displayed in th e
multifunction display. X
Hav e th e fault y tire pressur e sensor replaced at a qualified spe -
cialist workshop .
Tir e Pressure Mon ‐
ito r Inoperative
No Wheel Sensor s The wheels mounted do no t hav e a suitable tire pressur e sensor .
The tire pressur e monitor is deactivated.X
Moun t wheels wit h suitable tire pressur e sensors.
The tire pressur e monitor is activated automatically after drivin g
fo r a few minutes.
Tir e Press. Moni‐
tor Inoperative The tire pressur e monitor is faulty.X
Visit a qualified specialist workshop .
Vehicle
Display messages
Possible causes/consequences and P Solutions
Shift to 'P' or
'N' to Start Engine You hav e attempte d to start th e engin e wit h th e transmissio n in
position R or D . X
Shift th e transmissio n to position P or N .
Apply brake to
deselect Par k (P)
position You hav e attempte d to mov e th e transmissio n selector lever to
position D , R or N without depressin g th e brak e pedal .X
Depress th e brak e pedal .
To shift out of P
or N, depres s
brake and start
engine Wit h th e engin e switched off, you hav e attempte d to shift th e
selector lever out of position P or N into another transmissio n
position . X
Depress th e brak e pedal .X
Start th e engine.320
Display messages
On-board computer and displays

X
Clean the plast ic lenses of the exterior
lighting using a wet sponge and a mild
cleaning agent, e.g. Mercedes-Benz car
shampoo or cleaning cloths.
Cleaning the mirror turn signals
! On ly use cleaning agents or cleaning
cloths that are suitable for plast ic lenses.
Unsuit able cleaning agents or cleaning
cloths could scratch or damage the plastic
lenses of the mirror turn signals. X
Clean the plast ic lenses of the mirror turn
signals in the exterior mirror housing using
a wet sponge and mild cleaning agent, e.g.
Mercedes-Benz car shampoo or cleaning
cloths.
Cleaning the side running board
! Do not clean the aluminum inserts of the
side running board with alkaline or acidic
cleaners, such as wheel cleaner. Do not use
acid ic wheel cleaners to remove brake
dust. The aluminum inserts could other-
wise be damaged.
Cleaning the sensors
! If you clean the sensors with a power
washer, make sure that you keep a dis-
tance of at least 11.8 in (30 cm) between
the veh icle and the power washer nozzle.
In formation about the correct distance is
availab le from the equipment manufac-
turer. X
Clean sensors C of the driv ing systems
wit h water, car shampoo and a soft cloth.
Cleaning the rear view camera
! Do not clean the camera lens and the area
around the rear view camera with a power
washer.
X
Use clear water and a soft cloth to clean
camera lens C .
Cleaning the 360° camera
! Do not clean the camera lens and the area
around the 360° camera with a power
washer.360380
Care
Maintenance and care