2016 LINCOLN MKX brake sensor

1011
2016 MKX
11
Convenience
SecuriCodeTM Keyless Entry Keypad
The keypad is near the driver window.
It lights when touched, and allows
you to lock or unlock the doors and
liftgate, recall memory features and arm
or disarm the anti-theft alarm. To get
started, locate your 5-digit factory code
found on your owner’s wallet card (in the glove box). Entering this code unlocks
the driver door.
To lock all doors: Press and hold 7•8 and 9•0 at the same time with the driver
door closed.
To unlock all doors: Enter your 5-digit code (either the factory code or your
personal code), and then press 3•4 within five seconds.
To release the liftgate: Enter your 5-digit code (either the factory code or your
personal code), and then press 5•6 within five seconds.
For complete information, refer to the SecuriCode Keyless Entry Keypad section
in the Locks chapter of your Owner’s Manual.
Intelligent Access
Note:
The transmitter must be within 3 feet (1 meter) of the vehicle for in\
telligent
access to function properly.
To unlock and open a door, pull an exterior door handle. Make sure not to touch
the lock sensor area on the front of the handle.
To lock the doors, touch the top of the door handle.
To unlock and open a front door, pull the front ex terior door handle.
The unlock sensor is on the back of the handle.
To lock the doors, touch the sensor on the top of the door handle.
Intelligent Access Remote Entry Icons
Press once to lock all doors.
Press again within three seconds to
confirm that you locked all doors.
Press
once to unlock the driver door.
Press again within three seconds to
unlock all doors.
Press
to activate the panic alarm.
Press again or switch the ignition
on to deactivate.
Press
twice within three seconds to open the liftgate.
Car finder: Press
twice within three seconds to locate your vehicle.
The horn sounds and the direction indicators flash.
Note: The intelligent access transmitter also contains a mechanical key blade
that you can use to unlock the driver door, if necessary.
SelectShift Automatic® Transmission with Paddle Activation
Gives you the ability to manually change gears if you like. To use, move the
gearshift lever from drive (D) to sport (S).
Pull the right paddle (+) to upshift, pull the left paddle (–) to downshift.
Remote Start
Remote start allows you to start your vehicle using your transmitter. To start, press
and then press twice within three seconds.
Once inside, apply the brake while pressing the START STOP button. Shift into
drive (D) and go.
To switch the engine off from outside the vehicle after using your remote start,
press
once.
An LED on the remote control provides status feedback of remote start or\

stop commands:
Solid green: The remote start was successful.
Solid red: The remote stop was successful and the engine is off.
Blinking red: The remote start or stop failed.
Blinking green: The system is waiting for a status update.
Power Liftgate
Your liftgate has an automatic open and closing feature.
To open remotely, press
twice on your remote control within three seconds.
To close or reverse the movement, press
twice again.
You can also operate the liftgate by pressing the
button on the instrument
panel. The rear cargo area control lets you close the liftgate by pressi\
ng the
button.
To Set the Liftgate Open Height
1. Open the liftgate.
2. Manually move the liftgate to the desired height. 3.
Press and hold the control button on the liftgate until you hear a tone,
indicating programming is complete.
The system recalls the new open liftgate height when you use the power l\
iftgate
feature. To change the programmed height, repeat the procedure.
Note: You cannot program the height if the liftgate position is too low. Once you
open the power liftgate, you can manually move it to a different height. When
operating the power liftgate after you have programmed a lower height th\
an
full-open, you can fully open the liftgate by manually pushing it upward\
to the
maximum open position.
Hands-free Liftgate Operation*
1. Make sure you have your intelligent access transmitter within
3 feet (1 meter) of the liftgate.
2. Move your foot under and back from the rear bumper, similar to a kicking
(front-to-back) motion. Do not move your foot sideways or the sensors \
may not
detect the motion.
Note: In vehicles equipped with the towing package, you must kick your
foot between the trailer hitch and the exhaust system. Do not kick under
the hitch.
*if equipped

*if equipped
1415
2016 MKXEssential Information
Pre-Collision Assist
The system warns you of cer tain
collision risks. The system’s sensor
detects your vehicle’s rapid approach
to other vehicles traveling in the same
direction as your vehicle. When your
vehicle rapidly approaches another
vehicle, a red warning light flashes and
a tone sounds.
You can adjust your warning system’s
sensitivit y to any one of three
possible settings:
1. Alert: When activated, a red warning light flashes, an audible warning tone
sounds and a warning message shows in the information display.
2. Brake Support: The brake suppor t system assists the driver in reducing the
collision speed by lightly applying the brakes. If the risk of collision fur ther
increases after the warning light illuminates, the brake support prepares
the brake system for rapid braking. This may be apparent to the driver.
The system does not automatically activate the brakes, but if you press
the brake pedal, the system may apply full force, even if the brake pedal is
lightly pressed.
3. Active Braking: Active braking may activate if the system determines that a
collision is imminent. The system may help the driver reduce impact damage
or avoid the crash completely.
Note: Driving aids do not replace the need to watch where the vehicle is
moving and brake when necessar y. Refer to your Owner’s Manual for safet y
information, more details and limitations.
Lane Keeping System
The system notifies you to stay in your lane through the steering system and the
instrument cluster display when the front camera detects an unintentiona\
l drift
out of your lane is likely to occur. The system automatically detects and tracks the
road lane markings using a camera mounted behind the interior rear view \
mirror.
Press the button located on the left steering wheel stalk to switch the \
system on
or off. For more details, refer to the Driving Aids chapter of your Owner’s Manual.
Tire Pressure Monitoring System
Your vehicle has a tire pressure monitoring system that illuminates a low\
tire
pressure warning light
in your instrument cluster when one or more of your
tires are significantly under-inflated. If this happens, stop and check your tires as
soon as possible. Inflate them to the proper pressure. Refer to the Tire Pressure
Monitoring System section in the Wheels and Tires chapter of your Owner’s
Manual for more information.
Location of Spare Tire and Tools
Your spare tire and tools are located beneath the carpeted floor panel in the
cargo area of your vehicle. The spare tire is designed for emergency use only
and should be replaced as soon as possible. For complete details, refer to the
Wheels and Tires chapter of your Owner’s Manual.
Open Window Buffeting
You may hear a pulsing noise when just one of the windows is open. Lower the
opposite window slightly to reduce this noise.
Easy Fuel® System
With this system, put your vehicle in park (P) and switch off the ignition. Open the
fuel door, insert the nozzle and begin fueling. Wait about five to ten seconds after
pumping fuel before removing the fuel filler nozzle. This allows residual fuel to
drain back into the fuel tank and not spill onto the vehicle.
Running Out of Fuel
When using a portable fuel container, slowly insert the fuel funnel (located in the
left-hand side, rear storage compartment), and pour the fuel into the funnel. When
done, clean the funnel or properly dispose of it. You can purchase extra funnels
from your authorized dealer. Do not use aftermarket funnels as they do not work
with the Easy Fuel® system and may cause damage.
Note: Avoid running out of fuel because this situation may have an adverse
effect on powertrain components.
Fuel Tank Capacity/Fuel Info
All-wheel drive vehicles have a 18.5 gallon (70.0L) fuel tank capacity and
front-wheel drive vehicles have an 18.4 gallon (69.5L) fuel tank capacity. Use only
UNLEADED fuel or UNLEADED fuel blended with a maximum of 15% ethanol and\

a minimum octane rating of 87. Do not use diesel, fuel-methanol, leaded fuel or
any other fuel because it could damage or impair the emission control sy\
stem.
Towing Your MKX
Towing your vehicle behind an RV or any other vehicle may be limited. Refer
to Towing the Vehicle on Four Wheels section in the Towing chapter of your
Owner’s Manual.
Auto Hold
Auto Hold can assist you while stopping at traffic lights or while in traffic jams by
holding the brakes when you bring your vehicle to a stop. Press the Auto Hold
button to switch the system on. The Auto Hold button lights. When the system
is on and actively holding the vehicle, AUTO HOLD displays in the
instrument cluster.
When you press the accelerator pedal, Auto Hold automatically releases the
brakes. In certain situations, Auto Hold may apply the electric parking brake and
illuminate the brake warning lamp in the instrument cluster.
Auto Hold turns off when you power your vehicle down, or you can switch the
feature off manually by pressing the Auto Hold button. Switch Auto Hold off if you
are towing a trailer or having the vehicle towed.
See the Brakes chapter of your Owner’s Manual for more details.
Automatic Engine Shutdown
This feature automatically shuts down the engine if it has been idling for an
ex tended period of time. The ignition also turns off in order to save batter y
p ower. Before your vehicle shuts down, a message appears in the information
display showing a timer counting down. If you do not inter vene within 30
seconds, your vehicle shuts down. Another message appears in the information
display to inform you that your vehicle has shut down to save fuel. Star t your
vehicle as normal.
You can override this feature temporarily by pressing the brake or accelerator
pedal, or by pressing OK or the RESET button in your information display.
Refer to the Information Displays chapter of your Owner’s Manual for
more details.