2016 LINCOLN MKC radio

54
3 Service Engine Soon Light Lights briefly when you switch on the
ignition. If it remains on or blinks after you start
the engine, the On-Board Diagnostics (OBD-II)
system has detected a problem. Drive in a
moderate fashion (avoid heavy acceleration
and deceleration) and contact your authorized
dealer as soon as possible.
4 Right Vehicle Information Display
Displays information about Entertainment,
Climate, Phone and Navigation*. Use the right,
5-way controls located on your steering wheel
to scroll through, highlight and make minor
adjustments within a selected menu. Refer to
your SYNC Supplement for more information.
5 Steering Wheel Controls
Audio
Press VOL + or – to increase or decrease
volume levels. Press |⊳ or ⊲| to access the next
or previous radio station preset, CD track or
MP3 selection.

Voice
Press to answer call.
Press
to exit phone mode or end a call.
Press
to access voice recognition.
6 Power Tilt/Telescoping Steering Column*
The 4-way rocker control allows you to adjust
the steering wheel to your desired position.

7 Push Button Start
Allows you to start your vehicle by pressing
the START STOP button while fully pressing
down on the brake pedal. If you leave your
vehicle idling for an extended period of
time, it automatically shuts down. Before the
engine shuts down, a message appears in
the information display, allowing the driver to
override the shutdown feature.

Note: Your intelligent access transmitter must
be inside the vehicle for the ignition to start.
The keyless warning alert sounds the horn twice
when you exit the vehicle with the transmitter
and the vehicle is still on.
8 Push Button Shift Transmission
Your vehicle includes an electronic
transmission. The shift buttons are on the center
stack next to the SYNC® 3 system.

Putting Your Vehicle in Gear
A. Fully press down the brake pedal.
B. Press and release one of the PRNDS
buttons to select your gear.
C. The gear shift button you select lights and
the information display shows a telltale of
the selected gear.
D. Release the brake pedal and your
transmission remains in the selected gear.

Note: When entering an automatic car wash,
always put your vehicle into Stay in Neutral
mode. To put your vehicle in Stay in Neutral
mode, make sure your vehicle is stationary
first and then:
A. Press the neutral (N) button on the shifter
assembly once. The information display
screen then reads “Press N to enter Stay
in Neutral mode”.
B. Press N on the shifter assembly again.
The information display displays a message
to confirm that you are in the Stay in
Neutral mode, and the N button flashes
continuously to confirm your selection.
C. To exit Stay in Neutral mode, fully press
down on the brake pedal, then press and
release another gear. Release the brake
pedal and your transmission remains in the
selected gear.
Instrument Panel
1 Electric Parking Brake
The operating switch replaces the conventional handbrake, and is to the left of the steering\
column.
To use, pull the switch. The brake system warning lamp lights to confirm\
that you applied the electric
parking brake. You can release the electric parking brake manually by sw\
itching the ignition on, pressing
the brake pedal and then pressing the electric parking brake switch down\
. The brake system warning
lamp turns off. Refer to the Brakes chapter of your Owner’s Manual for more details. 2 Left Vehicle Information Display
Provides information about various systems on
your vehicle. Use the left, 5-way controls located
on the steering wheel to choose and confirm
settings and messages. Refer to the Information
Displays chapter in your Owner’s Manual for
more information.
*if equipped*if equipped
2016 MKC

98
SYNC® 3
Text Messaging
Note:
Downloading and sending text messages
using Bluetooth are cell phone-dependent features.
Certain features in text messaging are speed-
dependent and not available when your vehicle
is traveling at speeds over 3 mph (5 km/h).
When a new message arrives, an audible tone
sounds and the screen displays a pop-up with the
caller name and ID, if supported by your
cell phone.
You Can Select
Listen to have SYNC 3 read the message to you.
Dial to call your contact.
Close to exit the screen.
You can reply to text messages with a preset
message. See your SYNC Supplement for details.
Navigation*
Press the navigation* icon to set your
destination. Select one of two ways to find
your destination:
Destination mode lets you key in a specific
address or use a variety of search methods to
locate where you want to go.
Map mode shows advanced viewing that
includes 2-D city maps, 3-D landmarks and 3-D
city models (when available).
Refer to your SYNC Supplement for
complete details.
Set a Destination
Press Destination on your touchscreen and then
press Search. Enter a street address, intersection,
city or a point of interest (POI).
After you choose your destination, press Start Route.
The system uses a variety of screens and visible
prompts to guide you to your destination.
During your route, you can press the maneuver
arrow icon on the map if you want the system to
repeat the previous route guidance instructions. The navigation map shows your estimated time of
arrival, remaining travel time and the distance to
your destination.
Navigation Menu
While you are on your route, you can change your
touchscreen view. To change the view, touch Menu
on the bottom of the screen, and then select Screen
View to choose from any of the following:

Full Map.
Highway Exit Info displays POI icons, including
restaurants, ATMs, etc., as they pertain to each
exit. You can select a POI as a waypoint,
if you wish.
Turn List shows all of the available turns on your
current route.
Traffic List displays SiriusXM Traffic and
Travel Link* information. If traffic conditions
change to cause a major delay on the originally
selected route, then SYNC 3 provides an
automatic re-route.
Note: Minor traffic changes do not prompt a re-route.
*if equipped
Climate
Touch the Climate icon on the touchscreen
to access climate control features, including the
temperature, airflow direction, fan speed and other
climate features for you and your front passenger.
You can use voice commands to operate the climate
system by saying “Climate set temperature 72
degrees”. SYNC 3 makes the adjustment.
Set Your Temperature
Touch the Climate icon on the touchscreen.
Set your exact, desired temperature by using the ▲ or ▼ buttons.
Audio
No matter how you store your music, SYNC
makes it yours to enjoy when you’re behind the
wheel. Just press the Audio icon on the touchscreen.
From here, you can easily go between all of
your media sources.
Set Your Radio Presets
Tune to the station and then press and hold one
of the memory preset buttons. The audio mutes
briefly while the system saves the station, and
then the audio returns.
Two preset banks are available for AM and three
banks for FM. To access additional presets, tap
the preset button. The indicator on the preset
button shows which bank of presets you are
currently viewing.
Bring in Your Own Music
Plug your device, such as a phone or media player,
into a USB port, select SOURCE and then choose
USB. Wait for the system to finish indexing your
music to begin listening. You can even create
random playlists by using the Shuffle function.
The USB port begins charging your device as soon
as you plug it in.
Apps
Stream Apps
The system supports the use of certain audio apps
such as Pandora® or iHeartRadio® through a USB or
Bluetooth-enabled devices.
Each app gives you different on-screen options
depending on the app’s content. Refer to your SYNC
Supplement for more information.
*if equipped*if equipped
2016 MKC