2016 LEXUS LS460L torque

3454-5. Using the driving support systems
4
Driving
LS460/LS460L_GE (OM50G06E)
Lane departure warning function
If the system judges that the vehicle may deviate from its lane, it alerts
the driver using rapid beeping, indications on the multi-information dis-
play, and a sensory warning* given via the steering wheel.
*: A slight steering torque is applied for a short period of time in the direction of the
center of the lane.
Lane keeping assist function
• This function will be active when the vehicle-to-vehicle distance con-
trol mode of the dynamic radar crui se control with full-speed range
( P. 328) is set with vehicle speed above approximately 72 km/h
(45 mph) and while the lane departure warning function is active.
• When the lane keeping assist function is active, a slight steering
torque will be applied, to help th e driver maintain the vehicle inside
the lane.
The lane keeping assist function will be temporarily canceled if the steering
wheel is not operated, or if you continue driving with your hands lightly touch-
ing the steering wheel. ( P. 349)
Functions included in the LKA
1
2

4034-6. Driving tips
4
Driving
LS460/LS460L_GE (OM50G06E)
◆Using Eco drive mode
When using Eco drive mode, the torque corresponding to the accelerator
pedal depression amount can be generate d more smoothly than it is in normal
conditions. In addition, the operation of the air conditioning system (heating/
cooling) will be minimized, improving the fuel economy. ( P. 354)
◆Use of Eco Driving Indicator
The Eco-friendly driving is possible by keeping the bar display of the Eco Driv-
ing Indicator shown in the multi-information display within the Zone of Eco
driving. (  P. 132)
◆Accelerator pedal/brake pedal operation
Drive your vehicle smoothly. Avoid abrupt acceleration and deceleration.
Gradual acceleration and deceleration will help reduce excessive fuel con-
sumption.
◆When braking
Observe conditions in front of and ar ound the vehicle, and estimate your
stopping position. Release the accelerator pedal early and continue coasting.
Use the brake pedal to adjust your stopping position. Make sure to operate
the brake pedal gently.
◆Delays
Repeated acceleration and deceleration, as well as long waits at traffic lights,
will lead to bad fuel economy. Check traffic reports before leaving and avoid
delays as much as possible.
◆Highway driving
Control and maintain the vehicle at a constant speed. Before stopping at a toll
booth or similar, allow plenty of time to release the accelerator pedal and gen-
tly apply the brakes.
Eco-friendly driving tips
For improved fuel economy and reduced CO2 emissions, pay attention to the
following points:

6247-2. Steps to take in an emergency
LS460/LS460L_GE (OM50G06E)
Remove the wheel ornament by
pushing from the reverse side.
6
CAUTION
■Replacing a flat tire
●Observe the following precautions.
Failure to do so may result in serious injury:
• Do not try to remove the wheel ornament by hand. Take due care in handling
the ornament to avoid unexpected personal injury.
• Do not touch the disc wheels or the area around the brakes immediately after
the vehicle has been driven.
After the vehicle has been driven the disc wheels and the area around the
brakes will be extremely hot. Touching these areas with hands, feet or other
body parts while changing a tire, etc. may result in burns.
●Failure to follow these precautions could cause the wheel nuts to loosen and the
tire to fall off, resulting in death or serious injury.
• Never use oil or grease on the wheel bolts or wheel nuts.
Oil and grease may cause the wheel nuts to be excessively tightened, leading
to bolt or disc wheel damage. In addition, the oil or grease can cause the
wheel nuts to loosen and the wheel may fall off, causing a serious accident.
Remove any oil or grease from the wheel bolts or wheel nuts.
• Have the wheel nuts tightened with a torque wrench to 140 N•m (14.3 kgf•m,
103 ft•lbf) as soon as possible after changing wheels.
• Do not attach a heavily damaged wheel ornament, as it may fly off the wheel
while the vehicle is moving.
• When installing a tire, only use wheel nuts that have been specifically designed
for that wheel.
• If there are any cracks or deformations in the bolt screws, nut threads or bolt
holes of the wheel, have the vehicle inspected by your Lexus dealer.

6257-2. Steps to take in an emergency
7
When trouble arises
LS460/LS460L_GE (OM50G06E)
Remove any dirt or foreign mat-
ter from the wheel contact sur-
face.
If foreign matter is on the wheel con-
tact surface, the wheel nuts may
loosen while the vehicle is in motion,
causing the tire to come off.
Install the spare tire and loosely
tighten each wheel nut by hand
by approximately the same
amount.
Turn the wheel nuts until the washers
come into contact with the disc wheel.
Lower the vehicle.
Firmly tighten each wheel nut two
or three times in the order shown
in the illustration.
Tightening torque:
140 N•m (14.3 kgf•m, 103 ft•lbf)
Installing the spare tire
1
Disc wheel
Washer
2
3
4

6528-1. Specifications
LS460/LS460L_GE (OM50G06E)
*1: For vehicles with model code*2 that has “V” as the last letter
*2: The model code is indicated on the manufacturer’s label or the Certification
Regulation label. ( P. 650)
Engine
Model1UR-FSE1UR-FE
Type8-cylinder V type, 4-cycle, gasoline
Bore and stroke94.0  83.0 mm (3.70  3.27 in.)
Displacement4608 cm3 (281.2 cu. in.)
Valve clearance
(engine cold)Automatic adjustment
Drive belt tensionAutomatic adjustment
Maximum vehicle speed*1250 km/h (155 mph)
Maximum torque (NET)*1493 N•m@4100 rpm455 N•m@4000 rpm
Maximum power (NET)*1285 kW@6400 rpm260 kW@6400 rpm
Fuel
Fuel typePremium unleaded gasoline only
Research Octane
Number
For Brazil95 (Octane rating 91) or higher
Except for Brazil95 or higher
Fuel tank capacity
(Reference)84 L (22.2 gal., 18.4 Imp. gal.)

6608-1. Specifications
LS460/LS460L_GE (OM50G06E)
18-inch tires
*: A rating closer to “1” indicates higher performance.
Tires and wheels (for Korea)
Tire manufacturerBridgestoneDunlopMichelin
Tire rolling resistance
rating (5 levels)*434
Tire wet grip rating
(5 levels)*333
Tire sizeP235/50R18 97V
Tire inflation pressure
(Recommended cold
tire inflation pressure)
Driving under normal conditions
Front: 230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Rear: 230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Driving at high speeds above 160 km/h (100 mph) (in
countries where such speeds are permitted by law)
Add 40 kPa (0.4 kgf/cm2 or bar, 6 psi) to the front tires,
70 kPa (0.7 kgf/cm2 or bar, 11 psi) to the rear tires.
Never exceed the maximum cold tire inflation pressure
indicated on the tire sidewall.
Wheel size18  7 1/2J
Wheel nut torque140 N•m (14.3 kgf•m, 103 ft•lbf)

661
8
8-1. Specifications
Vehicle specifications
LS460/LS460L_GE (OM50G06E)
19-inch tires
*: A rating closer to “1” indicates higher performance.
Tire manufacturerBridgestoneDunlopMichelin
Tire rolling resistance
rating (5 levels)*544
Tire wet grip rating
(5 levels)*333
Tire sizeP245/45R19 98V
Tire inflation pressure
(Recommended cold
tire inflation pressure)
Driving under normal conditions
Front: 230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Rear: 230 kPa (2.3 kgf/cm2 or bar, 33 psi)
Driving at high speeds above 160 km/h (100 mph) (in
countries where such speeds are permitted by law)
Add 50 kPa (0.5 kgf/cm2 or bar, 8 psi) to the front tires
and rear tires. Never exceed the maximum cold tire
inflation pressure indicated on the tire sidewall.
Wheel size19  8J
Wheel nut torque140 N•m (14.3 kgf•m, 103 ft•lbf)

6628-1. Specifications
LS460/LS460L_GE (OM50G06E)
18-inch tires
*1: For all loads including full rated loads
*2: For reduced loads (1 to 4 passengers only)
Tires and wheels (except for Korea)
Tire size235/50R18 97W
Tire inflation pressure
(Recommended cold
tire inflation pressure)
Vehicle speedFront wheel
kPa (kgf/cm2 or
bar, psi)
Rear wheel
kPa (kgf/cm2 or
bar, psi)
More than 210
km/h (130 mph)
330 (3.3, 48)*1
300 (3.0, 44)*2330 (3.3, 48)*1
320 (3.2, 46)*2
From 160 km/h
(100 mph)
to 210 km/h (130
mph)
280 (2.8, 41)*1
250 (2.5, 36)*2280 (2.8, 41)*1
260 (2.6, 38)*2
160 km/h (100
mph) or less
250 (2.5, 36)*1
230 (2.3, 33)*2240 (2.4, 35)*1
230 (2.3, 33)*2
Wheel size18  7 1/2J
Wheel nut torque140 N•m (14.3 kgf•m, 103 ft•lbf)