2016 LEXUS LS460L seats

143
3
Operation of
each component
LS460/LS460L_GE (OM50G06E)
3-1. Key information
Keys ...................................................144
3-2. Opening, closing and
locking the doors
Smart entry &
start system................................. 153
Wireless remote control........... 177
Doors ............................................... 186
Trunk .................................................. 191
3-3. Adjusting the seats
Front seats...................................... 198
Power rear seat ..........................205
Driving position memory ......... 218
Rear seat position memory.... 223
Head restraints ........................... 225
3-4. Adjusting the steering
wheel and mirrors
Steering wheel ............................ 228
Inside rear view mirror ............ 229
Outside rear view
mirrors ......................................... 232
3-5. Opening, closing the
windows and moon roof
Power windows .......................... 236
Moon roof ..................................... 240

1903-2. Opening, closing and locking the doors
LS460/LS460L_GE (OM50G06E)
■Customization
Settings (e.g. unlocking function using a key) can be changed.
(Customizable features P. 667)
CAUTION
■To prevent an accident
Observe the following precautions while driving the vehicle.
Failure to do so may result in a door opening and an occupant throwing out of the
vehicle, resulting in death or serious injury.
●Ensure that all doors are properly closed and locked.
●Do not pull the inside handle of the doors while driving.
For Korea and other countries with airbag manual on-off system except South
Africa
Be especially careful for the front doors, as the doors may be opened even if the
inside lock buttons are in locked position.
Other than listed above
Be especially careful for the driver’s door, as the door may be opened even if the
inside lock button is in locked position.
●Set the rear door child-protector locks when children are seated in the rear seats.
■ Door closer
In the event that a door is left slightly open, the door closer will automatically close
it to the fully closed position.
If the child-protector lock is set, the door closer will not stop during operation even
if an attempt is made to open the door from inside the vehicle. Be careful not to
catch fingers or anything else in the door. Failure to do so may result in serious
injury.
NOTICE
■ To prevent door closer malfunction
Do not frequently repeat opening and closing of doors, or apply excessive force to
a door while the door closer is operating.

198
LS460/LS460L_GE (OM50G06E)
3-3. Adjusting the seats
Front seats
Adjustment procedure
Passenger’s seat Driver’s seat
Seat position adjustment switch
The height of the driver’s head restraint is automatically adjusted simultaneously
with the seat position adjustment operation.
Seatback angle adjustment switch
Head restraint height adjustment switch ( P. 225)
Seat cushion (front) angle adjustment switch
Vertical height adjustment switch
Lumbar/pelvic support adjustment switch
Driver’s seat: firmness, vertical, backward and forward positioning
Front passenger’s seat: firmness, backward and forward positioning (if equipped)
Seat cushion length adjustment switch
Ottoman angle adjustment switch (if equipped)
If forward adjustment is performed while the ottoman is raised, the ottoman will
move downward.
1
2
3
4
5
6
7
8

1993-3. Adjusting the seats
3
Operation of each component
LS460/LS460L_GE (OM50G06E)
Vehicles without relaxation seat
Tilts the seatback forward
Tilts the seatback backward
Moves the seat forward
Moves the seat backward
Vehicles with relaxation seat
Tilts the seatback forward and
moves the seat forward
Tilts the seatback backward and
moves the seat backward
If the rear seat is not in the neutral
position, pressing the button once will
move the rear seat to the neutral posi-
tion. Pressing the button again will
move the front passenger’s seat to the
neutral position.
Tilts the seatback forward
Tilts the seatback backward
Moves the seat forward
Moves the seat backward
Operating the front passenger’s seat from the driver’s seat
1
2
3
4
1
2
3
4
5
6

2003-3. Adjusting the seats
LS460/LS460L_GE (OM50G06E)
5-seat models
Moves the front passenger’s seat
forward
The signal beeps when the seat opera-
tion stops at the forward limit.
Moves the front passenger’s seat
backward
The seatback will return to the neutral
position. If the head restraint is folded,
it will rise before the seatback moves.
4-seat models
Moves the front passenger’s seat
forward
The signal beeps when the seat opera-
tion stops at the forward limit.
Moves the front passenger’s seat
backward
The seatback will return to the neutral
position. If the head restraint is folded,
it will rise before the seatback moves.
Operating the front passenger’s seat from the rear seat
(vehicles with relaxation seat)
1
2
1
2

2013-3. Adjusting the seats
3
Operation of each component
LS460/LS460L_GE (OM50G06E)
The seat and steering wheel are automatically adjusted to allow the driver
or front passenger to enter and exit the vehicle easily.
■Driver’s seat
When all of the following have
been performed, the driver’s seat
and steering wheel are automati-
cally adjusted to a position that
allows driver to enter and exit the
vehicle easily.
• The shift lever has been shifted
to P.
• The engine switch has been
turned off.
• The driver’s seat belt has been
unfastened.
When any of the following has been performed, the driver’s seat and
steering wheel automatically return to their original positions.
• The engine switch has been turned to ACCESSORY mode.
• The driver’s seat belt has been fastened.
■Front passenger’s seat
If the front passenger’s door is opened while the vehicle is stopped, the
adjusted lumbar/pelvic support ( if equipped), ottoman (if equipped),
etc. will return to its original position.
Power easy access system

2023-3. Adjusting the seats
LS460/LS460L_GE (OM50G06E)
■Operating the foldable head restraint (vehicles with relaxation seat)
●If the seatback angle is adjusted using the switches located on the side of the front
passenger’s seat or center console when the engine switch is in IGNITION ON
mode, the head restraint will operate as follows:
• When tilting the seatback forward: After the seatback movement ends, the head
restraint starts to rise and fold. A signal beeps once operation is complete. If the
switch is released during the operation, the head restraint will return to the neu-
tral position.
• When tilting the seatback backward: If the head restraint is folded, it will return
to the neutral position.
●In the following situations, the head restraint will not operate even when the seat-
back angle adjustment switch is operated:
• The engine switch is off.
• The weight of an occupant or heavy object, etc. is detected on the front passen-
ger’s seat.
• The front passenger’s seat belt is fastened.
• The front passenger’s door is open.
■Operating the front passenger’s seat from the rear seat (vehicles with relaxation
seat)
The front passenger’s seat can be operated when the engine switch is in IGNITION
ON mode. However, in the following situations, the front passenger’s seat does not
move even when the switch is operated:
●The weight of an occupant or heavy object etc. is detected on the front passenger’s
seat.
●The front passenger’s seat belt is fastened.
●The front passenger’s door is open. (The front seat will not move forward.)
■Seat cushion automatic length adjustment (driver’s seat)
If the front of the cushion gets too close to the area around the instrument panel
when the seat position is being adjusted, the seat cushion will automatically retract.
■Seat operation automatic stop function (vehicles with relaxation seat)
If a front seat is likely to come into contact with the retractable table (4-seat models)
or the ottoman during seat operation or activation of the power easy access system,
a buzzer will sound and seat slide operation will be stopped partway.
(A warning message will be shown on the multi-information display.)

2033-3. Adjusting the seats
3
Operation of each component
LS460/LS460L_GE (OM50G06E)
■Power easy access system operations
●When exiting the vehicle, the power easy access system may not operate if the seat
is already close to the rearmost position, etc.
●If the seat position is adjusted during the power easy access system operation, the
operation will stop.
●If the seat position is adjusted during or after the power easy access system opera-
tion when the driver is exiting the vehicle, the power easy access system will not
operate when entering the vehicle.
■Customization
The distance that the driver’s seat moves backward during the power easy access
system can be changed. (Customizable features P. 667)
CAUTION
■When adjusting the seat position
●Take care when adjusting the seat position to ensure that other passengers are
not injured by the moving seat.
●Do not put your hands under the seat or near the moving parts to avoid injury.
Fingers or hands may become jammed in the seat mechanism.
■Seat adjustment
To reduce the risk of sliding under the lap belt during a collision, do not recline the
seat more than necessary.
If the seat is too reclined, the lap belt may slide past the hips and apply restraint
forces directly to the abdomen, or your neck may contact the shoulder belt,
increasing the risk of death or serious injury in the event of an accident.
Adjustments should not be made while driving as the seat may unexpectedly move
and cause the driver to lose control of the vehicle.
■Operating the front passenger’s seat from the driver’s seat or rear seat
Do not operate the front passenger’s seat when a passenger is seated in it. In addi-
tion, do not let anyone sit down in the front passenger’s seat while the seat is being
operated or when the head restraint is being folded. The front passenger may
catch their legs between the instrument panel and seat, or the head restraint may
interfere with their head, resulting in injury.