2016 KIA K900 light

S E AT I N G
35*IF EQUIPPED
A LWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
Move/press controls to adjust headrest, seat forward/backward position, seat cushion length, seatback
angle or lumbar support.
Headrest Height Adjustment*: Move button
A up/down to adjust headrest height
Seatback Angle Adjustment: Move button
B forward/backward to adjust seatback angle
Seat Sliding, Seat Height and Cushion Length* Adjustments:
§ Move button
C forward/backward to slide seat
§ Move front part of button
D up/down to raise/lower front part of seat
§ Move back part of button
E up/down to raise/lower back part of seat
§ Move button
F forward/backward to increase/decrease cushion length*
Lumbar Support Adjustment:
§ Press
G to increase support
§ Press
H to decrease support
§ Press
I to move lumbar support up/down
Power Adjustable Driver’s \feat
A
B
ED
F
C
GH
I
I
(Buttons located on left side of seat cushion)
(Controls located on door panel)
Power Height Adjustment* – To adjust the height, move
the seat control button A up/down.
Manual Tilt Adjustment – To adjust the headrest forward/
backward, tilt the lower part of the headrest at a slight angle.
Power Front \feat Headrest Adjust\bent*
29319_Text.indd 3511/6/15 10:24 AM

OTHER KEY FEATURES
*IF EQUIPPED 38
Smart Power Trunk
The Smart Trunk automatically unlocks and opens the trunk
hands-free when the Smart Key fob is detected near the rear
of the vehicle.
When the Smart Key fob is on your person and you are within
close proximity to the rear of the vehicle, the hazard lights
will blink and a chime will sound for approximately three
seconds to alert you that the Smart Trunk is about to open.
The alert system will blink and chime two additional times
before the Smart Trunk opens.
The Smart Trunk feature is OFF by default. To enable the
Smart Trunk, go to User Settings in the LCD instrument
cluster modes and select Smart Trunk.Quick Tip
The Smart Trunk can be deactivated with the Smart
Key by pressing any button on the key fob.
REMINDERS: - The Smart Trunk feature will not operate within
15 seconds after the doors are closed and locked
or if the Smart Key is within 60 inches from the
front door handles
- Doors must be closed and locked for the Smart
Trunk to operate
- The Smart Key must be outside of the vehicle for
the Smart Trunk to operate
For more information on Smart Trunk operation, please
refer to the Owner’s Manual.
29319_Text.indd 3811/6/15 10:25 AM

OTHER KEY F E AT U R E S
*IF EQUIPPED 42
Map/Room Lamps
Automatic Tu r n O\f\f Function
The interior lights automatically turn off approximately 20
seconds after the ENGINE START/STOP button is turned O F F.
Map/Room Lamp Operation
Map Lamps – These lights produce spot beams for
convenient use as map lamps or as personal lamps for the
driver or the front passenger. Press the buttons
A to turn the
map lamps ON/OFF.
ROOM button – Press the button
B to turn the front and
rear lamps ON/OFF.
REAR ROOM button – Press the button
C to turn the rear
lamp ON/OFF.
DOOR button – When the DOOR button
D is pressed (LED
lit) the front and rear lamps will turn ON as follows:
§ When a door is opened or doors are unlocked with the
Smart Key, the lamps will turn ON for approximately
30 seconds
§ If the ENGINE START/STOP button is in the ACC/OFF
position and a door is open, the lamps will stay ON for
approximately 20 minutes
§ If the ENGINE START/STOP button is in the ACC/ON
position and a door is open, the lamps will stay ON
The lamps will turn OFF immediately if the ENGINE STA R T/
STOP button is turned ON or all doors are locked.
PRIVACY button – When button
E is pressed (LED lit) and
a door is opened, that door lamp will turn ON.
REMINDER: When room lamp lens is pressed ON it
will remain ON, even when the map lamp switch is in
the OFF position.
Quic\b
Tips
- When doors are unlocked by the Smart Key, the
lamp turns ON for approximately 30 seconds
- If your vehicle is equipped with the theft alarm
system, the interior lights automatically turn off
approximately 3 seconds after the system is in
armed stage
- Using interior lights for an extended period of time
may cause battery discharge
BC
D
E
AA
29319_Text.indd 4211/6/15 10:25 AM

OTHER KEY F E AT U R E S
*IF EQUIPPED 44
ABC
DE
FGH
A eServices Guide button B UVO Luxury Services Voice Local Search button C Roadside Assist button D Auto dimming ON/OFF
E Glare detection sensorF HomeLink® button G HomeLink® button
H HomeLink® button
Auto-Dimming Rearview Mirror with \fomeLink®
The Auto-Dimming Rearview Mirror is designed to help reduce glare from a vehicle’s headlights located in
the rear and also connect up to three electronic transmitters in one location. To turn automatic dimming ON
or O F F, press button
D.
\bVO Luxury Services Rearview Mirror Key Functions
A UVO Luxury Services Guide button: Provides information about UVO Luxury Services features within the
vehicle. Press button A and follow the voice prompts to use the eServices Guide.
B UVO Luxury Services Voice Local Search button: Uses Google® to locate points of interest in the
surrounding area. Press button B and follow the voice prompts to use UVO Luxury Services Voice
Local Search.
C Roadside Assist button: Connects to Roadside Assist and provides services including emergency
assistance and vehicle towing. Press button C to connect to Roadside Assist.
REMINDER: Mirror indicator light will illuminate when automatic dimming is ON.
29319_Text.indd 4411/6/15 10:26 AM

OTHER KEY FEATURES
45*IF EQUIPPED
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLE TE OPER ATING INFORMATION AND SAFE T Y WARNINGS.
E Glare detection sensorF HomeLink® button G HomeLink® button
H HomeLink® button
How to Sync Transmitter with HomeLink\f
If programming for the rst time, begin with step 1 (repeating
this step will delete all information).
To program non-rolling and rolling code garage door openers
and other devices:
1. Press and hold the left
F and center G buttons
simultaneously until the indicator light begins to ash (to
reprogram buttons, skip this step)
2. Press and hold the desired button
F, G or H and hold
the button on the transmitter while it is approximately 1 to
3 inches away from the mirror. The HomeLink
® indicator
light will ash rapidly once the frequency signal has been
successfully programmed
To nish programming rolling code garage door openers,
complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s
motor head unit. Press and release the button and complete
step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink
®
button up to three times
Quick Tips
- You can reprogram a single HomeLink® button by
repeating step 2
- Erasing programmed buttons will delete all
trained transmitters
\bperating HomeLink\f:
Press one of the programmed HomeLink
® buttons.
Erasing programmed buttons:
Press and hold the left
F and center H buttons
simultaneously for approximately 20 seconds, and then
release both buttons within 30 seconds.
If your garage door opener was manufactured in 2011
or later, and you are unable to program your vehicle’s
HomeLink
® system, you may need to purchase a
HomeLink® Repeater Kit. For more information, go to
www.HomeLink.com or call (800) 355-3515.
29319_Text.indd 4511/6/15 10:26 AM

OTHER KEY F E AT U R E S
*IF EQUIPPED 46
Hood Release Lever and Latch
Openin\f the Hood:
1. Pull the hood release lever
A to unlatch the hood
2. In the front of the vehicle, lift the hood slightly, push the secondary latch inside of the hood (center)
B to
the left and lift the hood
Closin\f the Hood:
Lower the hood about halfway and then press down to securely lock in place.
A
B
S\bnvisor
Use the sunvisor to shield direct light through the front or
side windows.
Slide the sunvisor out and adjust as needed. REMINDERS:
- Sunvisor may not shield all direct light
- Sunvisor may impair visibility if not adjusted
properly
- Be aware of seating position when adjusting or
swinging sunvisor around to or from the front or
side windows
29319_Text.indd 4611/6/15 10:26 AM

SAFETY F E AT U R E S
*IF EQUIPPED 48
Seat Belts
Pre-Safe Seat Belt (P SB) *
To properly faste\f your safety belts:
1. Insert the belt tongue plate
A into the buckle until it clicks
2. Position the lap portion of the belt across your lap as LOW
ON THE HIPS as possible. Adjust the belt to a SNUG FIT by
pulling up on the shoulder portion
B
Seat Belt \betractor Locks
Retractor locks allow lap/shoulder safety belts to remain
unlocked during normal vehicle operation for freedom of
movement and
increased comfort.
During a STRONG S T O P, SUDDEN TURN OR CERTAIN
COLLISIONS, seat belt retractors will automatically lock
the belts to help reduce the risk of injury.
The Pre-Safe Seat Belt (PSB) will activate and pull the seat
belt into tighter contact against the occupant’s body if a
collision is detected or during certain driving maneuvers.
The PSB system operates as below:
§ The seat belt may tighten when:
- The vehicle senses a collision
- An emergency braking situation occurs
- There’s a loss of vehicle control
§ The seat belt vibrates when the vehicle detects an object
too close to the vehicle
For more detailed information regarding your vehicle’s
safety belts, please refer to your Owner’s Manual
and the separate brochure titled “Understanding Your
Safety Belt & Supplemental Restraint System.”
Quick
Tip
The seat belt warning chime operates for the
driver’s seat only.
A
B
REMINDERS:
The Pre-Safe Seat Belt warning light will illuminate
on LCD screen if there is a problem with the system.
Have the system checked if:
- The warning light does not turn on briey when
you turn the ENGINE START/STOP button to the
ON position
- The warning light stays on after illumination for
approximately 3 seconds
- The warning light comes on while the vehicle is
in motion
29319_Text.indd 4811/6/15 10:26 AM

SAFETY F E AT U R E S
49*IF EQUIPPED
A LWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS.
A
B
Occupant Detection System (ODS) / \fassenger Air\bag Off Indicator
ODS detects the presence of the front passenger A.
Depending on the situation and type of accident, the system may:
§ Deploy air bag (adult)
§ Not deploy the airbag (unoccupied)
If the system determines that the airbag should not be deployed, the “PASS AIRBAG OFF” light
will illuminate
B.
Please refer to your Owner’s Manual and the separate brochure titled “Understanding Your Safety Belt & Supplemental
Restraint System” for more detailed information regarding your vehicle’s airbags.
29319_Text.indd 4911/6/15 10:26 AM